13.340.99 其他防护设备 标准查询与下载

NAVY MS16036 REV C NOTICE 1-1996 贮气式飞行员自动释放飞机安全带

This notice should be filed in front of MS 16036C(Wep), dated 16 October 1961.

BELT - AIRCRAFT SAFETY, PILOT'S AUTOMATIC RELEASE, CARTRIDGE OPERATED

CAN/CSA-Z259.1-1995(R2004) 安全带和挂绳

1. Scope 1.1 This Standard covers safety belts of the tongue buckle type and lanyards. It may be applied to an assembly consisting of a belt with an attached lanyard, or to a belt alone, or to a lanyard alone. 1.2 This Standard does not cover specific designs for safety belts, except insofar as design limitations are necessary to provide an acceptable level of service.

Safety Belts and Lanyards

CSA Z94.5-1995(R2001) 非处方太阳镜

1. Scope 1.1 This Standard applies to all nonprescription sunglasses, having lenses of substantially plano power, normally used where safety eyewear is not specifically recommended. 1.2 This Standard provides requirements for transmittance of ultraviolet radiation and visible light, qualification of lens types, impact resistance, cosmetic quality, refractive properties, lens warpage, and labelling. 1.3 This Standard does not apply to products covered by CSA Standards CAN/CSA-Z94.3 and Preliminary Standard P400. 1.4 Sunglass needs for aphakics may not be met by this Standard.

Nonprescription Sunglasses

ARMY A-A-52490 A-1995 轻负荷或分马力V型安全带

This CID covers requirements for stock power transmission, light-duty, endless V-type belts. The V-belts are for use with fractional-horsepower engines or motors that use small diameter pulleys on drives which generally require a single belt. The V-belts are intended for intermittent or infrequent use, rather than continuous operation. Typical applications are: shop equipment, blowers, and centrifugal pumps(see 7.4).

BELTS, V: LIGHT-DUTY OR FRACTIONAL-HORSEPOWER

CNS 13372-1994 玻璃滤光下日光曝露测试基准

本标准规定耐候测试机构，评估非金属材料对经由玻璃滤光后之日光的抗辐射之曝露测试基准。（以下简称本基准）备考：本基准规定曝露方式，至于试验样品之调配及结果之评估，应依各别标准之规定。

Standard Practice for Conducting Exposures to Daylight Filtered Through Glass

CNS 13338-1994 硬式棒球用头盔

本标准适用于棒球用头盔，（限于硬式棒球用者，以下简称硬式棒球用头盔）。

Helmet for Baseball Use

CNS 13340-1994 棒球及垒球捕手用头盔

本标准适用于棒球（1）及垒球及竞赛，或练习中，为保护捕手之头部在打击手挥棒后所产生之撞击所佩戴之捕手头盔（以下简称「头盔」）。（注 1）：所指之棒球包括硬式棒球、准硬式棒球及软式棒球。

Helmet of Catcher for Baseball and Softball Use

CNS 13339-1994 软式棒球及垒球用头盔

本标准适用于软式棒球（1）所使用之软式棒球用头盔（以下简称「棒球用头盔」），及软式垒球所使用之垒球用头盔以下简称「垒球用头盔」），但垒球用头盔亦可掌棒球用头盔使用。捕手用头盔除外。注（1）：所指软式棒球并不包含准硬式棒球所使用之 H 号软式棒球。

Helmet for Soft Baseball and Softball Use

NF S71-504:1993 防止从高处跌落的个人防护设备.能量吸收器

Personal protective equipment against falls from a height. Energy absorbers.

NF S71-503:1993 防止从高处跌落的个人防护设备.收紧索

Personal protective equipment against falls from a height. Lanyards.

NF S71-508:1993 工作定位和防高处坠落个人防护设备.全身用吊带

PERSONAL PROTECTIVE EQUIPMENT AGAINST FALLS FROM A HEIGHT. FULL BODY HARNESSES. (EUROPEAN STANDARD EN 361).

NF S71-512:1993 防高处坠落的个人防护设备.使用和标记指示的一般要求

PERSONAL PROTECTIVE EQUIPMENT AGAINST FALLS FROM A HEIGHT. GENERAL REQUIREMENTS FOR INSTRUCTIONS FOR USE AND FOR MARKING. (EUROPEAN STANDARD EN 365).

NF S71-507:1993 防止从高处跌落的个人防护设备.收缩式跌落制动装置

PERSONAL PROTECTIVE EQUIPMENT AGAINST FALLS FROM A HEIGHT. RETRACTABLE TYPE FALL ARRESTERS. (EUROPEAN STANDARD EN 360).

NF S71-510:1993 防止从高处跌落的个人防护设备.跌落制动系统

PERSONAL PROTECTIVE EQUIPMENT AGAINST FALLS FROM A HEIGHT. FALL ARREST SYSTEMS. (EUROPEAN STANDARD EN 363).

NF S71-505:1993 工作定位和防高处坠落个人防护设备.工作定位系统

PERSONAL EQUIPMENT FOR WORK POSITIONING AND PREVENTION OF FALLS FROM A HEIGHT. WORK POSITIONING SYSTEMS. (EUROPEAN STANDARD EN 358).

ARMY A-A-52422-1993 窄型工业驱动V型安全带

The General Services Administration has authorized the use of this commercial item description(CID) as a replacement for MIL-B-52919A, MS39277A, MS39278A, and MS39279A, which are canceled.

BELTS, V: INDUSTRIAL DRIVE, NARROW TYPE

SANS 50365:1992 防人员从高处坠落的保护装置．使用说明和标记的一般要求

This standard states the general requirements for instructions for use and for marking of equipment for protection against falls from heights.

Personal protective equipment against falls from a height - General requirements for instructions for use and for marking

SANS 50358:1992 控制工作位置和防止从高处坠落的人员防护设备．工作位置控制系统

This standard specifies requirements, testing and the marking, labelling and packaging of systems intended for work positioning and support of the worker at a height including the prevention of free fall. A work positioning system is not meant to be used for fall arrest.

Personal equipment for work positioning and prevention of falls from a height - Work positioning systems

SANS 50362:1992 防高处坠落的个人防护设备．连接器

This standard specifies the requirements, test methods, instructions for use and marking for connectors. Connectors according to this standard are used in work positioning and fall arrest systems specified in EN 358 and EN 363 respectively. Lanyards with connectors as terminations are specified in EN 354.

Personal protective equipment against falls from a height - Connectors

CSA Z259.3-M1978-1978(C2004) 架线工安全带和肩带

1. Domaine d'application 1.1 La présente norme traite des exigences minimales de résistance et de sécurité, des tailles, du marquage et de l'emballage des ceintures et des courroies de sécurité. L'équipement dont il est question ici est réservé au personnel des entreprises d'électricité et des communications. 1.2 Cette norme ne s'applique pas aux ceintures ou aux courroies destinées à des usages autres que ceux énoncés ci-dessus. 1.3 Cette norme ne traite pas des différents modèles de ceintures et de courroies de sécurité. Le cas échéant, des restrictions sont apportées aux pièces constitutives des ceintures et des courroies de sécurité afin d'en assurer la sécurité et la durabilité. Toutes les pièces de la ceinture et de la courroie de sécurité dont les dimensions ne sont pas données doivent répondre aux prescriptions relatives à la résistance.

Lineman Safety Belts & Straps