13.340.99 其他防护设备 标准查询与下载

GA 68-2019 警用防刺服

police stab proof clothing

ASTM C1695-18a 热设备用可拆卸和可重复使用的柔性绝缘毯的制造标准规范

Standard Specification for Fabrication of Flexible Removable and Reusable Blanket Insulation for Hot Service

ASTM C1695-18 热设备用可拆卸和可重复使用的柔性绝缘毯的制造标准规范

Standard Specification for Fabrication of Flexible Removable and Reusable Blanket Insulation for Hot Service

ASTM F3272-18 标准选择 护理和使用电弧防护毯的指南

1.1 This guide provides information for the selection, care, and use of arc protective blankets for personnel protection. 1.2 This guide covers positioning and securing arc protective blankets (tested to Test Method F2676) and channeling the thermal, ballistic, and concussive forces generated by an arc flash event using arc protective blankets. 1.3 This guide describes the use of the arc protective blanket to maximize its protective effectiveness to workers exposed to energized electrical equipment where complete de-energizing of the work zone cannot be achieved or for low-risk exposures with sufficient arc flash incident energy to warrant secondary protective means in the event of an arc flash. 1.4 The values stated in SI units are to be regarded as the standard. See IEEE/ASTM SI-10. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Guide for Selection, Care, and Use of Arc Protective Blankets

ISO 21924-5:2017 武术 - 武术防护装备 - 第5部分:额外保护器和腹部保护器的附加要求和试验方法

This document specifies additional requirements and test methods for genital protectors and abdominal protectors used in unarmed martial arts such as taekwondo, karate, kick-boxing and similar disciplines.

Protective equipment for martial arts — Part 5: Additional requirements and test methods for genital protectors and abdominal protectors

ISO 21924-3:2017 武术保护装备 - 第3部分:中继保护装置的附加要求和测试方法

This document specifies additional requirements and test methods for trunk protectors used in unarmed martial arts such as taekwondo, karate, kick-boxing and similar disciplines. It also applies to breast protectors for men. For general requirements and test methods for protective equipment for martial arts, see ISO 21924-1.

Protective equipment for martial arts — Part 3: Additional requirements and test methods for trunk protectors

ASTM F3272-17 标准选择 护理和使用电弧防护毯的指南

Standard Guide for Selection, Care, and Use of Arc Protective Blankets

CSA Z259.15-2017 锚固连接器

1.1 This Standard specifies performance, design, testing, marking, classification, and other requirements related to anchorage connectors in travel-restraint, fall-arrest, work-positioning, and suspended component/tie-back line systems. 1.2 The requirements of this Standard include (where applicable) anchorage connectors attached to an anchorage. Methods of verifying the actual strength of anchorages in the field are not included. Note: See CSA Z259.16 for anchorage design and construction requirements. 1.3 This Standard does not differentiate between temporary, portable, and permanent anchorage connectors. 1.4 With the exception of multi-legged frames (e.g., tripods) and personnel davit arms, this Standard does not apply to ballasted, friction, counterweight, or vacuum anchorage connectors that rest on but are not fastened to an anchorage. Note: See CSA Z259.16 for requirements for some of these types of anchorage connectors. 1.5 This Standard does not apply to a) equipment davit arms meeting the requirements of CAN/CSA-Z271; b) anchorage connectors that are i) custom engineered for limited or site-specific applications for fall protection in accordance with CSA Z259.16; or ii) custom engineered for suspended component/tie-back line applications only meeting the requirements of CAN/CSA-Z271; c) installation requirements for the anchorage connectors with the exception of information for use [see Clause 9.2 a)]; and d) verification of the strength of the structures or anchorage with the exception of information for use [see Clause 9.2 a)]. 1.6 In CSA standards, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (nonmandatory) to define their application. 1.7 The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only. Unless otherwise stated within this Standard, all units have an acceptable tolerance range of ± 2%.

Anchorage connectors

KS K 0944-2016 防侧坠髋保护器 冲击减少率评价试验方法

Hip protector against side fall — Test method for evaluation of impact reduction rate

KS K 0944-2016(2021) 防侧面坠落的髋部保护装置.碰撞减少率评估的试验方法

Hip protector against side fall — Test method for evaluation of impact reduction rate

GOST R 57379-2016 职业安全标准系统. 防止从高处坠落的个人防护设备. 下降救援设备. 通用技术要求. 试验方法

Occupational safety standards system. Personal protective equipment against falls from a height. Descender devices for rescue. General technical requirements. Test methods

GSO ISO 11810-2:2015 激光和激光相关设备 手术衣和/或患者覆盖物的测试方法和激光阻抗等级 第2部分：二次点火

  Scope is not provided for this standard

Lasers and laser-related equipment -- Test method and classification for the laser-resistance of surgical drapes and/or patient-protective covers -- Part 2: Secondary ignition

GA 423-2015 警用防弹盾牌

本标准规定了警用防弹盾牌的术语和定义、分类和代号、技术要求、试验方法、检验规则、质量保证规定及包装、运输与贮存。 本标准适用于警用防弹盾牌的研制、生产和检验。

Police ballistic shields

CB/T 3749-2015 阻燃安全网

本标准规定了阻燃安全网(以下简称安全网)的分类和标记、要求、试验方法、检验规则以及标志、包装和贮运等。本标准适用于船舶和海洋工程结构物等建造、修理中明火作业处所使用的安全网。建筑作业用阻燃安全网亦可参照使用。

Retardant safety nets

DB44/T 1502-2014 游泳眼镜

本标准规定了游泳眼镜的术语和定义、要求、试验方法、标志及包装。 本标准适用于成人或儿童（36个月以上）在游泳池或类似场所使用的游泳眼镜。

swimming glasses

GOST EN 12841-2014 职业安全标准体系. 防止从高处坠落的个人防护设备. 绳索接近系统. 绳索调整设备. 通用技术要求. 试验方法

Occupational safety standards system. Personal protective equipment against falls from a height. Rope access systems. Rope adjustment devices. General technical requirements. Test methods

GOST EN 1891-2014 职业安全标准体系. 防止从高处坠落的个人防护设备. 低弹力纤维绳索. 通用技术要求. 试验方法

Occupational safety standards system. Personal protective equipment against falls from a height. Low stretch kernmantel ropes. General technical requirements. Test methods

GOST EN 1497-2014 职业安全标准体系. 防止从高处坠落的个人防护设备. 救生带. 通用技术要求. 试验方法

Occupational safety standards system. Personal protective equipment against falls from a height. Rescue harness. General technical requirements. Test methods

GOST EN 1498-2014 职业安全标准体系. 人员坠落防护设备. 救生圈. 通用技术要求. 试验方法

Occupational safety standards system. Personal fall protection equipment. Rescue loops. General technical requirements. Test methods

GOST EN 795-2014 职业安全标准体系. 防止从高处坠落的个人防护设备. 锚固装置. 通用技术要求. 试验方法

Occupational safety standards system. Personal protective equipment against falls from a height. Anchor devices. General technical requirements. Test methods