17.120.20 明渠中流量的测量 标准查询与下载

ISO 9213:1992 明渠中总流量的测量 应用全渠宽线圈的电磁法

Measurement of total discharge in open channels; electromagnetic method using a full-channel-width coil

ISO/TR 9210:1992 明渠水流测量 弯曲河流和水流边界不稳定河流的流量测验

Provides guidelines for discharge measurements (especially for site selection) in meandering and braided rivers, and from bridges, following the provisions of ISO 748.

Measurement of liquid flow in open channels; measurement in meandering rivers and in streams with unstable boundaries

ISO 1070:1992 明渠水流测量 比降-面积法

The method is suitable for use under somewhat special conditions when direct measurement of discharge by more accurate methods is not possible. It can be used with reasonable accuracy in open channels having stable boundaries, bed and sides (e.g. rock), in lined channels and in channels with relatively coarse material. In other cases it is subject to large uncertainties, and it is not suitable for use in very large channels, channels with very flat surface slopes and high sediment load or channnels having significant curvature.

Liquid flow measurement in open channels; slope-area method

ISO 9195:1992 明渠水流测量 砾石河床质取样和分析

Applies to surface and subsurface material having diameters of 2 mm and over. Two sampling techniques are applicable: one is to collect a definable in situ volume of material which is subsequently dealt with as a bulk sample, the second is to sample material from the surface, using one of several procedures.

Liquid flow measurement in open channels; sampling and analysis of gravel-bed material

ISO 9196:1992 明渠水流测量 结冰状态下的水流测量

Describes four water discharge measurement methods and two water stage measurement methods. Figures illustrate the principles.

Liquid flow measurement in open channels; flow measurements under ice conditions

SNI 03-2820-1992 河流与开放渠道流量测量方法

Measurement methods for rate of flow of river and open channel by surface buoy

SNI 03-2819-1992 河流与开放渠道水流量测量方法

Measurement methods for rate of flow of river and open channel by flow measuring apparatus, propeller type

CAN/CGSB-157.4-M91-1991 明渠中液体的流量测量 第2部分：高度 流量关系的确定

La présente Norme nationale du Canada est équivalente à la Norme internationale ISO 1100-2:1982. La présente Norme internationale spécifie des méthodes de détermination de la relation hauteur-débit pour une station de jaugeage. Pour pouvoir déterminer la relation hauteur-débit avec le degré d'exactitude requis par la présente Norme internationale, il faut un nombre suffisant de mesures de débit associées aux mesures de niveau correspondantes. On considère les chenaux stables et instables, y compris ceux qui sont susceptibles de geler, mais il faut procéder avec le plus grand soin si l'on applique la présente Norme internationale dans des conditions où le débit varie brusquement ou rapidement. Une analyse des erreurs limites qu'impliquent la préparation et l'utilisation de la relation hauteur-débit a été incluse.

Flow measurement of liquids in open channels - Part 2: Determination of the height-flow relationship

CAN/CGSB-157.2-M91-1991 明渠中的液体流量测量 速度面积法

This National Standard of Canada is equivalent to International Standard ISO 748:1979. This International Standard specifies methods for determining the velocity and cross-sectional area of water flowing in open channels (with or without ice cover), and or computing the discharge therefrom. It covers methods of employing current-meters and floats to measure the velocities. Although, in most cases, these measurements are intended to determine the stage-discharge relation by means of readings at several stages, this International Standard deals only with single measurements of the discharge; the continuous recording of discharges over a period of time is covered in ISO 1100. NOTE - Measurements for the purpose of determining the discharge in efficiency tests of hydraulic turbines are specified in IEC Publication 41, International code for the field acceptance tests of hydraulic turbines.

Liquid Flow Measurement in Open Channels - Velocity-Area Methods

KS A 0516-1990(2001) 流量测量BY涡街流量计方法

METHODS OF FLOW MEASUREMENT BY VORTEX FLOWMETERS

NF X10-316:1990 明渠液体流量的测量.V形平面溢流堰

Liquid flow measurement in open channels. Flat-V weirs.

NF X10-315:1990 用溢流堰和水槽测定明渠中的水流量.矩形宽顶溢流堰

Liquid flow measurement in open channels by weirs and flumes. Rectangular braod-crested weirs.

ISO/TR 9823:1990 明渠水流测量 用有限垂线数测验的速度面积法

This Technical Report describes a velocity-area method which can be carried out using three verti-cals only, without significant loss of accuracy, and gives advice on when such a "short-cut" method should be used. The method specified in this Technical Report is not an alternative to the velocity-area method specified in ISO 748, which gives accurate results and should be used under normal conditions. This short-cut method has a limited field of application and is in-tended for use only in special circumstances, ex-amples of which are given in clause 7.

Liquid flow measurement in open channels; velocity-area method using a restricted number of verticals

BS 3680-4E:1990 明渠流量测量.第4部分:溢流堰和斜槽.第4E节:矩形宽顶堰

Measurement of flow of clean water under free flow conditions. Covers installation conditions, maintenance, head measurement, discharge, relationships, computation of discharge and errors in flow measurement.

Methods of measurement of liquid flow in open channels - Weirs and flumes - Rectangular broad-crested weirs

BS 3680-4F:1990 明渠中液体流量的测量方法 堰和水槽 圆鼻水平宽顶堰

Deals with the measurement of flow under steady flow conditions. Covers installation, maintenance, head measurement, design details, discharge equation, uncertainties in flow measurement and an example on computation of discharge.

Methods of measurement of liquid flow in open channels. Weirs and flumes. Round nose horizontal broad-crested weirs

BS 3680-3M:1990 明渠流量测量.第3部分:河川流量测量.第3M节:大流量测定方法指南

Guidance on the applicability and extension for use of existing methods of discharge measurement under conditions of high discharge. Site selection under those conditions is also considered.

Measurement of liquid flow in open channels - Stream flow measurement - Guide to the methods of measuring high discharges in rivers

ISO 4374:1990 明渠水流测量 圆缘水平宽顶堰

Deals with the measurement of flow in rivers and artificial channels. The flow conditions considered are limited to steady flows which are uniquely dependent on the upstream head. Drowned flows, which depend on downstream as well as upstream levels, are not covered. Cancels and replaces the first edition (ISO 4374 :1982), of which it constitutes a technical revision.

Liquid flow measurement in open channels; round-nose horizontal broad-crested weirs

ISO/TR 9209:1989 明渠水流测量 湿绳改正的确定

This Technical Report provides an alternative to the procedure given in ISO 748 : 1979, annex C, for the determination of the wetline correction.

Measurement of liquid flow in open channels; determination of the wetline correction

HYS-2-1989 明渠污水流量计、液压计暂行技术要求

The provision technical regulation for flowmeter and liquidometer of wastewater in open channel

NF X10-320:1989 明渠中液体流量的测定.旋转元件流速计

Liquid flow measurement in open channels. Rotating element current-meters.