19.020 试验条件和规程综合 标准查询与下载



共找到 701 条与 试验条件和规程综合 相关的标准,共 47

本文件规定了采用浸入式动态图像法测量液体介质中微气泡的粒径及数量为基础的粒径分布的装置和操作,适用于分散在透明液体中气泡直径为1微米-100微米,浓度不超过1×1010气泡/毫升的测量。主要涉及到采用浸入式动态图像法测量微气泡粒径的原理、测量过程、图像采集和处理、目标选取和分析、粒径的计算、结果的不确定度和测量报告内容等。

Particle technology—Microbubble size analysis —Submerged dynamic image analysis method

ICS
19.020
CCS
M731
发布
2021-11-22
实施
2021-11-22

本文件提出热带湿热海洋、温带海洋、亚热带工业、干热沙漠、寒冷乡村大气环境下电子装备结构件有机防护涂层的选用导则。 本文件可为电子装备研制阶段有机防护涂层选用提供支撑。

Guidance for choosing organic protective coating of electronic equipment structuresin typical environment

ICS
19.020
CCS
M732
发布
2021-11-12
实施
2021-11-12

Determination of Population Marker Cotinine in Aquatic Environment by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Determination of Methcathinone Content in Water Environment by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Determination of 3,4-Methylenedioxymethamphetamine (MDMA) and 3,4-Methylenedioxyamphetamine (MDA) in Aquatic Environments by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Determination of Ketamine and Norketamine in Water Environment by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Sampling technical specification for drug testing in water environment

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Determination of Methamphetamine and Amphetamine in Water Environment by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Determination of Cocaine and Benzoylecgonine in Water Environment by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

Determination of Maca and O6-Monoethyl Maca in Water Environment by Liquid Chromatography-Tandem Mass Spectrometry

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

General rules for testing 12 kinds of drugs and their metabolites and population markers in water environment

ICS
19.020
CCS
N50
发布
2021-11-09
实施
2022-01-09

1.1 This practice covers a method of determining rational specification limits by inclusion of the precision of the test method used in the specification. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for Inclusion of Precision Statement Variation in Specification Limits

ICS
19.020
CCS
发布
2021-11-01
实施

艇长大于等于5m但小于20m的无人艇在海上测试场开展海上测试的管理,超过该尺度范围的无人船艇可参照本规范执行

Management specification for sea testing of unmanned surface vehicles

ICS
19.020
CCS
U 01
发布
2021-10-27
实施
2022-01-01

Continuous mechanical handling equipment for loose bulk materials —Wagon tipplers handling rail-borne wagons (rotary, side discharge and end discharge) — Safety code

ICS
19.020
CCS
发布
20211012
实施
20211012

Fire hazard testing - Part 11-11: Test flames - Determination of the characteristic heat flux for ignition from a non-contacting flame source (IEC 60695-11-11:2021)

ICS
19.020
CCS
发布
2021-09-30
实施
2021-09-30

本文件规定了电力系统稳定分析计算用的柔性直流电网机电暂态仿真数学模型的建立、参数校核 试验及建模报告编写要求。 本文件适用于采用以 IGBT(绝缘栅双极型晶体管)等双向可控电力电子器件为核心换流元件的模 块化多电平电压源型换流器,直流对地电压±100 kV 及以上的高压直流电网的机电暂态建模,不适用 于采用电流源型换流器的高压直流输电系统。 本文件建立的模型不用于分析三相不对称故障。电压等级低于 100 kV 和非模块化多电平电压源型 换流器建模可参考本文件。

Flexible DC Grids Part 6: Modeling Technical Guidelines Electromechanical Transient Models

ICS
19.020
CCS
D4420
发布
2021-09-17
实施
2023-04-18

本文件规定了统一潮流控制器(UPFC)相关术语和定义,以及符号和缩略语。 本文件适用于 220 kV 及以上电压等级采用模块化多电平换流器(MMC)的 UPFC,其他电压等级 或形式的 UPFC 术语可参照执行。

Unified Power Flow Controller (UPFC) Part 1: Terminology

ICS
19.020
CCS
D4420
发布
2021-09-17
实施
2023-04-18

本文件规定了统一潮流控制器阀冷却设备的使用条件、技术性能、生产、试验要求,以及包装、 运输和贮存、标识。 本文件适用于统一潮流控制器阀冷却设备,其他阀冷却设备可参照使用。

Unified power flow controller (UPFC) — Part 20: Technical specifications for valve cooling equipment

ICS
19.020
CCS
D4420
发布
2021-09-17
实施
2023-04-18

本文件规定了统一潮流控制器电压源型换流器的使用条件、组成、技术要求、试验、铭牌,以及 包装、运输和贮存要求。 本文件适用于 220 kV 及以上电压等级的模块化多电平统一潮流控制器电压源型换流器,其他电压 等级和拓扑统一潮流控制器电压源型换流器参照使用。

Unified power flow controller (UPFC) — Part 22:Technical specification for VSC

ICS
19.020
CCS
D4420
发布
2021-09-17
实施
2023-04-18

本文件规定了统一潮流控制器晶闸管旁路开关的使用条件、技术要求、试验及包装、运输、贮存 的要求。 本文件适用于 220 kV 及以上电压等级的统一潮流控制器晶闸管旁路开关,其他电压等级可参照执行。

Unified power flow controller (UPFC) — Part 24: Technical specifications for thyristor bypass switch

ICS
19.020
CCS
D4420
发布
2021-09-17
实施
2023-04-18



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号