共找到 2470 条与 压力容器、气瓶 相关的标准,共 165 页
Unfired pressure vessels - Part 8: Additional requirements for pressure vessels of aluminium and aluminium alloys
Unfired pressure vessels - Part 10: Additional requirements for pressure vessels of nickel and nickel alloys
Unfired pressure vessels - Part 3: Design
Unfired pressure vessels - Part 4: Fabrication
Unfired pressure vessels - Part 1: General
Drawing method of container inspection and test report with drawings
Unfired pressure vessels - Part 2: Materials
Gas cylinder traceability management system specification
Rules for Periodic Inspection of Polyethylene (PE) Public Pipelines
Routine maintenance and regular inspection requirements for urban gas pipelines
Unfired pressure vessels. Design
Unfired pressure vessels. General
1.1 This practice covers guidance and direction to suppliers, purchasers, and users in the handling, transportation, and storage of IG-100 (nitrogen). 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Handling, Transportation, and Storage of IG-100 (Nitrogen)
1.1 This practice describes a method for determining the leakage rate of a vessel subject to a positive pressure difference. The technique is based upon evaluation of the change of mass within the test object based on a pressure decay measurement. The pressure decay measurement uses the ideal gas equation of state and the measured pressures, temperatures, and time to determine the mass loss from the vessel. This method does not apply to deformable vessels. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Pressure Decay Leak Test Method
1.1 This practice covers guidance and direction to suppliers, purchasers, and users in the handling, transportation, and storage of IG-541. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Handling, Transportation, and Storage of IG-541 N
Welded steel cylinders for liquefied petroleum gas(Refillable)
Unfired pressure vessels. Materials
Unfired pressure vessels – Part 8: Additional requirements for pressure vessels of aluminium and aluminium alloys
Unfired pressure vessels – Part 2: Materials
Unfired pressure vessels. Fabrication
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号