23.020.40 低温容器 标准查询与下载

KS B ISO 21028-2-2006(2016) 低温容器低温下材料的韧性要求第2部分:温度在-80℃～-20℃之间

Cryogenic vessels－Toughness requirements for materials at cryogenic temperature－Part 2：Temperatures between －80 ℃ and －20℃

KS B ISO 23208:2006 低温容器.低温装置清洁性

이 규격은 예상되는 모든 작동 조건에서 초저온 유체와 접촉하는 초저온 용기의 표면 및 관련

Cryogenic vessels－Cleanliness for cryogenic service

KS B ISO 21028-2:2006 低温容器.低温下材料的韧性要求.第2部分:温度处于.80℃以上、20℃以下

이 규격은 초저온 용기에 대한 안정성을 보증하기 위해 -80 ℃ 미만의 온도에서 사용하는

Cryogenic vessels-Toughness requirements for materials at cryogenic temperature-Part 2:Temperatures between -80 ℃ and -20℃

KS B ISO 21028-1:2006 低温容器.低温下材料的韧性要求.第1部分:温度低于.80.℃

이 규격은 초저온 용기에 대한 안정성을 보증하기 위해 -80 ℃ 미만의 온도에서 사용하는

Cryogenic vessels-Toughness requirements for material at cryogenic temperature-Part 1:Temperatures below-80 ℃

KS B ISO 21029-2:2006 低温容器.1000升以下的可移动式真空绝缘容器.第2部分:操作要求

이 규격은 2004년에 제1판으로 발행된 ISO 21029-2 Cryogenic vess

Cryogenic vessels－Transportable vacuum insulated vessels of not more than 1 000 litres volume－Part 2：Operational requirements

KS B ISO 21010:2006 低温容器.气体/材料相容性

이 규격은 초저온 용기의 내화학성과 같은 가스/재료의 적합성 요건을 규정한다. 이 규격

Cryogenic vessels－Gas/materials compatibility

KS B ISO 21009-2:2006 低温容器.静压真空绝缘容器.第2部分:操作要求

이 규격은 0.5 bar 이상의 최대 허용 압력을 위해 설계된 고정식 진공 단열 용기에 대

Cryogenic vessels－Static vacuum insulated vessels－Part 2：Operational requirements

KS B ISO 20421-2:2006 低温容器.大型可移动真空隔热容器.第2部分:操作要求

이 규격은 체적 1 000 L 이상의 대용량 이동식 진공 단열 초저온 용기에 대한 사용 요

Cryogenic vessels－Large transportable vacuum-insulated vessels－Part 2：Operational requirements

KS B ISO 24490:2006 低温容器.低温设备用泵

이 규격은 초저온 설비용 펌프의 설계, 생산, 시험에 대한 최소한의 요건에 대해 규정한다

Cryogenic vessels－Pumps for cryogenic service

BS ISO 20421-1:2006 低温容器.大型可运输真空隔热容器.设计,制作,检测和试验

ISO 20421-1:2006 specifies requirements for the design, fabrication, inspection and testing of large transportable vacuum insulated cryogenic vessels of more than 450 l volume, which are permanently (fixed tanks) or not permanently (demountable tanks and portable tanks) attached to a means of transport, for one or more modes of transport. ISO 20421-1:2006 applies to large transportable vacuum insulated cryogenic vessels for cryogenic fluids, and does not apply to vessels designed for toxic fluids. ISO 20421-1:2006 does not include the general vehicle requirements, e.g. running gear, brakes, lighting, etc., which are in accordance with the relevant standards/regulations.

Cryogenic vessels - Large transportable vacuum-insulated vessels - Design, fabrication, inspection and testing

SH/T 3416-2005 石油化工用套管结晶器

本标准规定了石油化工用套管结晶器设计、制造和检验的技术要求。 本标准适用于石油化工用套管结晶器。

Double pipe crystallizers in petrochemical industry

ISO 21013-3:2006 低温容器.低温设施的卸压附件.第3部分:尺寸和容量测定

This part of ISO 21013 provides separate calculation methods for determining the required mass flow to be relieved for each of the following specified conditions. - Vacuum-insulated vessels with insulation system (outer jacket + insulating material) intact under normal vacuum; outer jacket at ambient temperature; inner vessel at temperature of the contents at the relieving pressure. - Vacuum-insulated vessels with insulation system (outer jacket + insulating material) intact under normal vacuum; outer jacket at ambient temperature; inner vessel at temperature of the contents at the relieving pressure; pressure regulator of the pressure build-up system functioning at full potential. - Vacuum-insulated vessels with insulation system remaining in place but with loss of vacuum, or nonvacuum- insulated vessels with insulation system intact; outer jacket at ambient temperature; inner vessel at temperature of the contents at the relieving pressure; vacuum or non-vacuum-insulated vessels with insulation system remaining fully or partially in place, but with loss of vacuum in the case of vacuuminsulated vessels, and fire engulfment; inner vessel at temperature of the contents at the relieving pressure. - Vessels with insulation system totally lost and fire engulfment. Good engineering practice based on well-established theoretical physical science shall be adopted to determine the required mass flow where an appropriate calculation method is not provided for an applicablecondition.

Cryogenic vessels - Pressure-relief accessories for cryogenic service - Part 3: Sizing and capacity determination

NF E86-503-3/A1*NF EN 14197-3/A1:2005 低温容器.固定非真空绝缘容器.第3部分:操作要求

Cryogenic vessels - Static non-vacuum insulated vessels - Part 3 : operational requirements.

NF E86-502-3/A1:2005 低温容器.大型运输真空绝缘容器.第3部分:操作要求

Cryogenic vessels - Large transportable vacuum insulated vessels - Part 3 : operational requirements.

LST EN 14398-3-2004/A1-2005 低温容器 大型可运输非真空绝热容器 第3部分：操作要求

Cryogenic vessels - Large transportable non vacuum insulated vessels - Part 3: Operational requirements

NF E86-504-3/A1:2005 低温容器.静压真空绝热容器.第3部分:操作要求

Cryogenic vessels - Static vacuum insulated vessels - Part 3 : operational requirements.

DIN EN 14398-3:2005 低温容器.大型可运输的非真空绝缘容器.第3部分:操作要求

1.1 This European Standard specifies operational requirements for large transportable non vacuum insulated cryogenic vessels of more than 1000 I volume. 1.2 This European Standard applies to vessels designed for cryogenic fluids specified in EN 14398-1.

Cryogenic vessels - Large transportable non vacuum insulated vessels - Part 3: Operational requirements(includes Amendment A1:2005); English version of DIN EN 14398-3:2003 + A1:2005

DS/EN 13458-3/A1:2005 低温容器 静态真空绝热容器 第3部分：操作要求

This standard specifies operational requirements for static vacuum insulated vessels designed for a maximum allowable pressure of more than 0,5 bar. It may also be used as a guideline for vessels designed for a maximum allowable pressure of less than 0,5 bar.

Cryogenic vessels - Static vacuum insulated vessels - Part 3: Operational requirements

DS/EN 14197-3/A1:2005 低温容器 静态非真空绝热容器 第3部分：操作要求

This European Standard specifies operational requirements for static non vacuum insulated vessels for cryogenic fluids according to EN 14197-1, designed for a maximum allowable pressure greater than 0,5 bar. It can be used as a guideline for vessels designed for a maximum allowable pressure of not more than 0,5 bar. The scope includes installation, putting into service, inspection, filling, maintenance and emergency procedures. This European Standard applies to vessels for cryogenic fluids as specified in EN 14197-1.

Cryogenic vessels - Static non-vacuum insulated vessels - Part 3: Operational requirements

DS/EN 14398-3/A1:2005 低温容器 大型可运输非真空绝热容器 第3部分：操作要求

This standard specifies operational requirements for large transportable non vacuum insulated cryogenic vessels of more than 1000 l volume. This standard applies to vessels designed for cryogenic fluids specified in EN 14398-1.

Cryogenic vessels - Large transportable non-vacuum insulated vessels - Part 3: Operational requirements