23.040.50 其他材料的管和配件 标准查询与下载
共找到 367 条与 其他材料的管和配件 相关的标准，共 25 页
1.1 This specification establishes the criteria for acceptance, prior to installation, of extra strength and standard strength vitrified clay pipe and fittings to be used for the conveyance of sewage, industrial wastes, and storm water; and extra strength perforated and standard strength perforated vitrified clay pipe to be used for underdrainage, filter fields, leaching fields, and similar subdrainage installations.1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. Note 18212;Attention is called to Specification C 425, Test Method C 828, Test Method C 1091, Test Methods C 301, and Terminology C 896.1.3 The following precautionary caveat pertains only to the Test Method portion, 5.2-5.2.3.2 of this standard: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Vitrified Clay Pipe, Extra Strength, Standard Strength, and Perforated
- ICS
- 23.040.50
- CCS
- 发布
- 2002-01-10
- 实施
Fibre-cement products - Pressure pipes and joints
- ICS
- 23.040.50
- CCS
- 发布
- 2002-01-07
- 实施
- 2002-01-07
1.1 This test method covers procedures for testing precast concrete manhole sections when using the vacuum test method to demonstrate the integrity of the installed materials and the construction procedures. This test method is used for testing concrete manhole sections utilizing mortar, mastic, or gasketed joints.1.2 This test method is intended to be used as a preliminary test to enable the installer to demonstrate the condition of the concrete manholes prior to backfill.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.4 This test method is the companion to metric Test Method C 1244M; therefore, no SI equivalents are shown in this test method. Note 18212;Vacuum test criteria presented in this test method are similar to those in general use. The test and criteria have been widely and successfully used in testing manholes.Note 28212;It should be understood that no correlation has been found between vacuum (air) and hydrostatic tests.
Standard Test Method for Concrete Sewer Manholes by the Negative Air Pressure (Vacuum) Test Prior to Backfill
- ICS
- 23.040.50
- CCS
- Q14
- 发布
- 2002
- 实施
Addresses functional performance and requires physical characteristics of devices and systems, which provide backflow protection consistent with the level of risk associated with the plumbing fixture fitting application. The Standard establishes specific performance criteria and provides the test methods to prove compliance. It is applicable to all plumbing fixture fittings with outlets not protected by an air gap.
Performance Requirements for Backflow Protection Devices and Systems in Plumbing Fixture Fittings
- ICS
- 23.040.50
- CCS
- J71
- 发布
- 2002
- 实施
Fibre-cement products - Pressure pipes and joints; Amendment A1
- ICS
- 23.040.50
- CCS
- 发布
- 2001-08
- 实施
The document specifies procedures for construction and connection of fibre-cement pipelines operating under pressure. It covers additional guidance to general laying procedures as given in EN 805.
Fibre-cement pipelines - Guide for laying and on-site work practices; German version EN 1444:2000
- ICS
- 23.040.50
- CCS
- Q14
- 发布
- 2001-03
- 实施
To be read in conjunction with BS EN 805:2000
Fibre-cement pipelines - Guide for laying and on-site work practices
- ICS
- 23.040.50
- CCS
- Q14
- 发布
- 2001-02-15
- 实施
- 2001-02-15
This draft European Standard, applies to both types of fibre-cement pipes AT and NT as defined in EN 512:1994, gives installation recommendations for this pipelines in above or below ground situations. It complements the general principles for all types of water supply systems specified in EN 805:2000, "Water supply - Requirements for systems and components outside buildings", and should be used in conjunction with that standard. This standard gives guidance in on-site working methods and in the selection and use of approved tools for cutting and machining fibre-cement pipes. This standard does not cover the following : a) installation by thrust boring and pipe jacking methods which require the use of highly specialized techniques ; b) problems caused by the use of special installations procedures (e.g. removal of pile sheeting in very deep trenches, etc.).
Fibre-cement pipelines - Guide for laying and on-site work practices
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-13
- 实施
- 2001-03-31
Prestressed concrete pressure pipes, cylinder and non-cylinder, including joints, fittings and specific requirements for prestressing steel for pipes
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Reinforced concrete pressure pipes, cylinder type, including joints and fittings
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Common requirements for concrete pressure pipes including joints and fittings
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Vitrified clay pipes and fittings and pipe joints for drains and sewers - Part 4: Requirements for special fittings, adaptors and compatible accessories
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Vitrified clay pipes and fittings and pipe joints for drains and sewers - Part 2: Quality control
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Vitrified clay pipes and fittings and pipe joints for drains and sewers - Part 1: Requirements
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Vitrified clay pipes and fitting and pipe joints for drains and sewers - Part 7: Requirements for vitrified clay pipes and joints for pipe jacking
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Vitrified clay pipes and fittings and pipe joints for drains and sewers - Part 6: Requirements for vitrified clay manholes
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Fibre-cement products - Pressure pipes and joints
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Vitrified clay pipes and fittings and pipe joints for drains and sewers - Part 5: Requirements for perforated vitrified clay pipes and fittings
- ICS
- 23.040.50
- CCS
- 发布
- 2000-12-11
- 实施
- 2000-12-11
Esta Norma Europeia especifica as características gerais para os seguintes componentes: tubos de bet?o para press?o, juntas, acessórios e pe?as especiais. Estes componentes destinam-se a ser usados em redes de abastecimento de água para consumo humano, em condutas industriais, na irriga??o ou em redes de águas residuais.
Common requirements for concrete pressure pipes including joints and fittings
- ICS
- 23.040.50
- CCS
- 发布
- 2000-06
- 实施
- 2000-06
PE80 and PE 100 Polyethylene Pipe Fittings - Hydrostatic Strength Test
- ICS
- 23.040.50
- CCS
- 发布
- 2000-02-28
- 实施
- 2000-03-31
