共找到 327 条与 组合单元和其他装置 相关的标准,共 22 页
Dimensions of pallets used with machine tools and in manufacturing systems.
Modular units for machine tools. Specification for workholding pallets over 800 mm nominal size
Includes load and life ratings for ball nuts. Applies to ball nuts with both internal and external return systems. Gives marking requirements and ordering instructions.
Machine tool ball screws - Specification for ball nuts and principal dimensions of ball screws
Dimensions of workholding pallets.
Modular units for machine tools. Specification for workholding pallets up to 800 mm nominal size
This part of ISO 8526 specifies the dimensions of workholding pallets for use with machine tools and in manufacturing sys-tems. It applies to the following nominal sizes of pallet: 320 mm, 400 mm, 500 mm, 630 mm and 800 mm
Modular units for machine tools; workholding pallets; part 1: workholding pallets up to 800 mm nominal size
This part of ISO 8526 specifies the dimensions of workholding pallets for use with machine tools and in manufacturing sys-tems. It applies to the following nominal sizes of pallet: 1 000 mm, 1 250 mm, 1 600 mm and 2 000 mm
Modular units for machine tools; workholding pallets; part 2: workholding pallets of nominal size greater than 800 mm
This standard specifies the dimensions of T-slots for machine tool tables.
Machine tools; T-slots; dimensions
This standard specifies the spacing of T-slots for machine tool tables.
Machine tools; spacing of T-slots; dimensions
This standard specifies technical acceptance conditions and acceptance tests including tolerances for the respective tolerance classes of ball screws.
Machine tools; ball screws; acceptance conditions and acceptance tests
This standard specifies nominal diameters and corresponding nominal leads of ball screws.
Machine tools; ball screws; nominal diameters and nominal leads
FMS. Flexible turning cells. Main parameters and dimensions
Machine tools; pallets for machine tools; nominal sizes over 800 mm; form B
This Part of BS 6101 gives a method of calculating the static axial rigidity of machine tool ball screws. For the purposes of this Part of BS 6101, where the term 'rigidity' is used, it means static axial rigidity. NOTE. The titles of publications referred to are listed on the inside back cover.
Machine tool ball screws - Method of calculation of static axial rigidity
Настоящий стандарт распространяется на столы-спутники для крепления обрабатываемых заготовок корпусных и плоских (призматических) загот
Flexible manufacturing modules and machining centres. Workholding pallets. Basic and coupling dimensions
Rectangular electromagnetic chucks. General specifications
Modular units for machine tool construction. Multi-spindle heads. Adjustable adaptors. Long series.
Modular units for machine tool construction. Multi-spindle heads. Adjustable adaptors. Usual series (smaller diameters).
Modular units for machine tool construction. Multi-spiondle heads. Ajustable adaptors. Usual series.
Modular units for machine tool construction. Multi-spindle heads. Adjustable adaptors. "Creater morse taper" series.
Rotary round table with hand and mechanical drives. Technical requirements
This German Standard specifies certain dimensions relating to the interchangeability of wing bases for slide units used in special machines constructed from modular units.
Machine tools; modular units; wing bases for slide units; constructional sizes
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号