29.060.01 电线和电缆综合 标准查询与下载
共找到 528 条与 电线和电缆综合 相关的标准，共 36 页
This clause of Part 1 is replaced by: This part of IEC 61084 specifies requirements for cable trunking systems and cable ducting systems intended for the accommodation, and where necessary for the segregation, of conductors, cables or cords and/or other electrical equipment in electrical installations. This standard applies to cable trunking systems and cable ducting systems which are mounted beneath or flush with the top face of the finished floor, including their system components. This specification does not apply to conduits, cable trays or cable ladders or to current-carrying parts within the system. NOTE 1 Types and applications are shown in Figures 101, 102. NOTE 2 There are many different designs of systems (see Figure 101) for which a part 2 is under consideration. NOTE 3 Systems partly or totally above the floor are not covered by this Part 2-2 but may be covered by an amendment to this part or by another part 2.
Cable trunking and ducting systems for electrical installations - Part 2-2: Particular requirements - Cable trunking systems and cable ducting systems intended for underfloor and flushfloor installations
- ICS
- 29.060.01
- CCS
- 发布
- 2014-12-25
- 实施
This standard specifies requirements for cable trunking and cable ducting systems intended for the accommodation, and where necessary for the segregation, of conductors, cables or cords and/or other electrical equipment in electrical installations. This specification does not apply to conduit, cable tray or cable ladder or current-carrying parts within the system. NOTE - There are many different designs of systems (see annex A) for which a Part 2 is under consideration.
Cable trunking and ducting systems for electrical installations - Part 1: General requirements
- ICS
- 29.060.01
- CCS
- 发布
- 2014-12-25
- 实施
This Technical Report serves as a supplement to IEC 60364-5-52:2009 and explains the rules so as to facilitate the design, selection, erection and maintenance of wiring systems. It is written for everyone concerned with the design, the selection and supply of equipment, as well as the persons who install, maintain and use electrical installations.
Electrical installation guide - Part 52: Selection and erection of electrical equipment - Wiring systems
- ICS
- 29.060.01
- CCS
- 发布
- 2014-12-25
- 实施
Cable trunking and ducting systems for electrical installations — Part 1: General requirements
- ICS
- 29.060.01
- CCS
- 发布
- 2014-10-27
- 实施
이 표준은 전기설비용 도체, 케이블 또는 코드 및 기타 전기설비를 수용하고, 필요한 경우 이격하기 위해 설계된 케이블 트렁킹 및 케이블 덕트 시스템에 대한 요구사항을 규정한다.이 표준은 설비 내에 포함된 전선관, 케이블 트레이 및 케이블 래더 등에는 적용하지 않는다.?
Cable trunking and ducting systems for electrical installations — Part 1: General requirements
- ICS
- 29.060.01
- CCS
- 发布
- 2014-10-27
- 实施
- 2014/10/27
本导则适用于火电、水电、核电常规岛及其他类发电工程和输变电工程等电力工程的电缆防火封堵施工作业，主要包括电缆穿墙，电缆穿楼板，电缆进盘、柜、箱，电缆桥架，电缆竖井，电缆隧(沟)道，电缆穿保护管，电力电缆中间接头等部位的防火封堵施工。
Construction workmanship guide for cable fireproof sealing of electrical engineering
- ICS
- 29.060.01
- CCS
- K13
- 发布
- 2014-10-15
- 实施
- 2015-03-01
本标准规定了总则，技术要求，试验方法，检验规则，标志、包装、运输与储存。
MFPT plastics-steel complex cable duct
- ICS
- 29.060.01
- CCS
- C3833
- 发布
- 2014-04-11
- 实施
- 2016-07-25
NB/T 31048的本部分规定了聚酰亚胺薄膜补强云母带绕包铜扁线的技术要求和检验规则。本部分适用于风力发电机用聚酰亚胺薄膜补强云母带绕包铜扁线和聚酰亚胺薄膜绕包层或聚酰亚胺薄膜绕包烧结层外包聚酰亚胺薄膜补强云母带绕包铜扁线。
Winding wires for wind turbine generator.Part 6: Polyimide film-backed mica tape wrapped rectangular copper wire
- ICS
- 29.060.01
- CCS
- K12
- 发布
- 2014-03-18
- 实施
- 2014-08-01
NB/T 31048的本部分规定了180级及以上浸漆玻璃丝包漆包铜扁线的技术要求和检验规则。本部分适用于风力发电机用180级及以上浸漆玻璃丝包漆包铜扁线。
Winding wires for wind turbine generator.Part 5: Glass-fiber wound resin or varnish impregnated, enamelled rectangular copper wire, temperature index including and above 180
- ICS
- 29.060.01
- CCS
- K12
- 发布
- 2014-03-18
- 实施
- 2014-08-01
NB/T 31048的本部分规定了风力发电机用绕组线的产品品种、型号、结构、技术要求、验收规则、包装、标志、贮存和运输。本部分适用于NB/T 31048.2-2014~NB/T 31048.6-2014规定的用于1.0MW及以上的风力发电机用绕组线。
Winding wires for wind turbine generator.Part 1: General requirements
- ICS
- 29.060.01
- CCS
- K12
- 发布
- 2014-03-18
- 实施
- 2014-08-01
NB/T 31048的本部分规定了240级芳族聚酰亚胺薄膜绕包烧结铜扁线的技术要求和检验规则。本部分适用于风力发电机用240级芳族聚酰亚胺薄膜绕包烧结铜扁线和240级芳族耐电晕聚酰亚胺薄膜绕包烧结铜扁线。
Winding wires for wind turbine generator.Part 2: Aromatic polyimide tape wrapped and sintered rectangular copper wire, class 240
- ICS
- 29.060.01
- CCS
- K12
- 发布
- 2014-03-18
- 实施
- 2014-08-01
NB/T 31048的本部分规定了聚酯薄膜补强云母带绕包铜扁线的技术要求和检验规则。本部分适用于风力发电机用聚酯薄膜补强云母带绕包铜扁线或薄膜绕包层外包聚酯薄膜补强云母带绕包铜扁线。
Winding wires for wind turbine generator.Part 3: Polyester film-backed mica tape wrapped rectangular copper wire
- ICS
- 29.060.01
- CCS
- K12
- 发布
- 2014-03-18
- 实施
- 2014-08-01
NB/T 31048的本部分规定了玻璃丝包薄膜绕包铜扁线的技术要求和检验规则。本部分适用于风力发电机用玻璃丝包薄膜绕包铜扁线。
Winding wires for wind turbine generator.Part 4: Glass-fiber and film wound rectangular copper wire
- ICS
- 29.060.01
- CCS
- K12
- 发布
- 2014-03-18
- 实施
- 2014-08-01
Scope 1.1 General This standard specifies the requirements for flexible cords, elevator cables, electric vehicle cables, electric vehicle cables, and hoistway cables rated 600 V maximum and intended for use in accordance with CSA C22.1, Canadian Electrical Code (CEC), Part I and CAN/CSA-C22.2 No. 0, General Requirements - Canadian Electrical Code, Part II, in Canada, NOM-001-SEDE, La Norma de Instalaciones Electricas (Mexican Electrical Code [MEC]), in Mexico, and NFPA 70, National Electrical Code (NEC), in the United States. 1.2 Products included This standard covers the following products: a) Service cords; b) Elevator cables; c) Hoistway cables; d) Heater cords; e) Range and dryer cords; f) Cords for decorative lighting; g) Tinsel and lamp cords; h) Special use cords; and i) Electric vehicle cables.
Flexible cords and cables (Tri-national standard, with UL 62 and ANCE NMX-J-436-2014)
- ICS
- 29.060.01
- CCS
- 发布
- 2014-03-01
- 实施
Cable trunking and ducting systems for electrical installations－Part 2－2：Particular requirements－Cable trunking systems and cable ducting systems intended for underfloor and flushfloor installations
- ICS
- 29.060.01
- CCS
- 发布
- 20140131
- 实施
- 20140131
Cable trunking and ducting systems for electrical installations－Part 2－2：Particular requirements－Cable trunking systems and cable ducting systems intended for underfloor and flushfloor installations
- ICS
- 29.060.01
- CCS
- 发布
- 2014-01-31
- 实施
Rods composite polymer for the manufacture of cores uninsulated wires. Specifications
- ICS
- 29.060.01
- CCS
- 发布
- 2014
- 实施
- 2016-01-01
JB/T 8997的本部分规定了电线电缆大孔径机用线盘的型号、材料、规格、技术要求、验收规则、检测方法、包装及标志等。本部分适用于电线电缆生产过程中使用的大孔径机用线盘,简称线盘。
Machine spools with large bore for processing of wires and cables.Part 1: General specifies
- ICS
- 29.060.01
- CCS
- K13
- 发布
- 2013-12-31
- 实施
- 2014-07-01
JB/T 7599的本部分规定了155级聚氨酯漆包线漆的技术要求、检验规则、包装、标志、贮存及运输。本部分适用于155级以多异氰酸酯系的聚氨酯树脂为基的、用合适的溶剂溶解稀释制成的聚氨酯漆包线漆(以下简称155级聚氨酯漆)。
Insulating enamel for enamelled winding wires. Part 9:Polyurethane enamel, class 155
- ICS
- 29.060.01
- CCS
- K15
- 发布
- 2013-12-31
- 实施
- 2014-07-01
JB/T 7599的本部分规定了180级聚酯亚胺漆包线漆的技术要求、检验规则、包装、标志、贮存及运输。本部分适用于180级以聚酯亚胺树脂为基的,用合适的溶剂溶解稀释制成的聚酯亚胺漆包线漆(以下简称180级聚酯亚胺漆)。
Insulating enamel for enamelled winding wires.Part 6:Polyesterimide enamel, class 180
- ICS
- 29.060.01
- CCS
- K15
- 发布
- 2013-12-31
- 实施
- 2014-07-01
