共找到 47 条与 有关绝缘的其他标准 相关的标准,共 4 页
本文件规定了10?kV交流架空输配电线路用复合外套带串联固定间隙金属氧化物避雷器的术语和定义、标志及分类、标准额定值、运行条件、技术要求、试验方法、检验规则、包装、随行文件、运输及储藏等要求。
Metal oxide arrester with fixed gap in series with composite jacket for 10kV AC transmission line
本文件规定了10kV交流输电线路用复合外套无间隙金属氧化物避雷器的术语和定义、分类和使用环境、技术要求、试验方法、检验规则、标志、包装、运输及贮存。 本文件适用于10kV交流输电线路下限制瞬态过电压而设计的复合外套无间隙金属氧化物避雷器。
10kV AC Transmission Line Composite Jacket Gapless Metal Oxide Surge Arrester
本文件规定了低压交流配电系统用复合外套无间隙内置脱离器金属氧化物避雷器(即内置脱离器低压交流避雷器,以下简称避雷器)的分类、标准额定值和运行条件、技术要求、试验方法、标志、包装、运输和保管方面的要求。
Technical specification of low-voltage surge arresters with built-in disconnector for a.c. systems
High-voltage switchgear and controlgear - Part 200 : AC metal-enclosed switchgear and controlgear for rated voltages above 1 kV and up to and including 52 kV
This standard specifies product testing and requirements of insulating joints, also in combination with valves, which are suitable for the use in gas lines, in the nominal pressure/nominal size range of table 1 and design temperatures from -10 to +60°C. It applies also to insulat
Ready-made insulated joint - Part 1: Insulating couplings for service lines and gas installations - Requirements and tests
This Standard specifies product testing and requirements of ready-made insulated joints which are suitable for the use in gas pipelines and gas installations above 5 bar up to 100 bar and design temperatures from -10 to +60 °C.
Ready-made insulated joint - Part 2: Insulating couplings for gas distribution and transportation - Requirements and tests
This standard draft DIN 3389-3 lays down the requirements regarding the conformity assessment of ready-made insulated joints for gas supply for maximum operating pressures up to and including 5 bar and for gas pipelines and gas stations of more than 5 bar and up to 100 bar.
Ready-made insulated joint - Part 3: Conformity assessment
本标准规定了750kV 交流气体绝缘金属封闭开关设备(GIS)用纤维增强复合绝缘拉杆的原材料、技术要求、试验方法、抽样与检验规则、标识、包装、运输、贮存等。
Fiber reinforced composite insulated tension pole used in 750kV AC gas-insulated metal-enclosed switchgear(GIS)
本标准规定了绝缘子用防覆冰涂层的测试方法。 本标准适用于标称电压高于 1000V 的交、直流系统覆冰地区使用的高压绝缘子防覆冰涂层。
Testing of anti-icing coatings for insulators
Gapless metal oxide arrester for 25kV railway AC system
本标准规定了额定电压大于lkV的交流电力系统金属氧化物避雷器用脱离器(以下简称脱离器)的技术要求、试验方法和检验规则等内容。本标准仅适用于将故障避雷器从交流系统中退出并能明显识别而设计的脱离器。
Disconnectors of metal-oxide surge arresters for a.c. systems
本标准规定了额定电压4.8kV及以下瓷外套和复合外套直流无间隙金属氧化物避雷器(以下简称避雷器)的技术要求、试验方法和检验规则等内容。本标准适用于3kV及以下直流系统中保护牵引电机及电气设备免受过电压损坏的避雷器。
Metal-oxide surge arresters without gaps for d.c. systems of 3kV and below
本标准规定了交流电力系统阻波器用有串联间隙金属氧化物避雷器(以下简称避雷器)的技术要求、试验方法、检验规则等内容。本标准仅适用于交流电力系统阻波器过电压保护用避雷器。
Metal oxide surge arresters with series gaps for line trap for a.c. power systems
本标准规定了氧化锌的技术条件、试验方法、检验规则及标志、包装、运输和贮存。本标准适用于以GB/T 470-2008规定的牌号为Zn99.995锌锭为原料,采用间接法生产的、用于生产金属氧化物避雷器电阻片的主要原料氧化锌。
Zinc oxide for the varistor of metal oxide surge arresters
本标准规定了避雷器用橡胶密封件的结构型式、材料规范、试验方法和检验规则等内容。本标准适用于避雷器用橡胶密封件。
Specification for rubber sealing gaskets and meterials for surge arresters
JB/T 9672的本部分规定了额定电压4 kV及以下瓷外套和复合外套直流有串联间隙金属氧化物避雷器(以下简称避雷器)的技术要求、试验方法和检验规则等内容。本部分适用于3 kV及以下直流供电系统中保护直流牵引电机及直流电气设备免受过电压损坏的避雷器。
Metal-oxide surge arresters with series gaps.Part 1: Metal-oxide surge arresters with series gaps for d.c. systems of 3 kV and below
本标准规定了避雷器产品及其派生产品、附属产品的型号命名原则、组成及编制方法。 本标准适用于交流系统和直流系统用避雷器及其派生产品、附属产品等产品的型号编制。
Designation for surge arrester products
本标准适用于避雷器的密封试验的技术要求和试验方法等内容。 本标准规定了金属氧化物避雷器(简称为避雷器)的密封试验。 本标准不排斥其他有效的方法。
Sealing tests of surge arresters
本标准规定了避雷器用监测装置的技术要求、试验方法和检验规则等内容。 本标准适用于金属氧化物避雷器(以下简称避雷器)用监测装置,包括避雷器用监测器和避雷器用放电计数器(以下分别简称监测器和计数器)。
Monitoring devices for metal-oxide surge arresters
Describes how the concentrations of dissolved gases or free gases may be interpreted to diagnose the condition of oil-filled electrical equipment in service and suggests future action. Applicable to electrical equipment filled with mineral insulating oil and insulated with cellulosic paper or pressboard-based solid insulation. Information about specific types of equipment such as transformers (power, instrument, industrial, railways, distribution), reactors, bushings, switchgear and oil-filled cables is given only as an indication in the application notes. May be applied only with caution to other liquid-solid insulating systems. In any case, the indication
Mineral oil-impregnated electrical equipment in service - Guide to the interpretation of dissolved and free gases analysis
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号