共找到 913 条与 连接装置 相关的标准,共 61 页
This standard gives the dimensional requirements for insert arrangements used is AS 81569 Series 1 and 2 electrical connectors AS31571 permits the cancellation and supersession of MS3157 with this document. Government documentation references are removed.
Insert Arrangements for AS81659 Series 1 and 2 Electrical Connectors
Insert Arrangements, Electric Connector, Shell Size 3 (for AS81703 connectors)
Establishes a method to determine the effects of impacts on electrical connectors.
Impact Test Procedure for Electrical Connectors
Couplers for appliances for household and similar purposes Part 2-4: Couplers depending on weight of appliance application
Connecting devices. Devices for the connection of aluminium conductors in clamping units of any material and copper conductors in aluminium bodied clamping units. General requirements and methods of tests
Wiring Devices - Dimensional Specifications
Connecting devices for low-voltage circuits for household and similar purposes - Part 2-4: Particular requirements for twist-on connecting devices
Connecting devices for low-voltage circuits for household and similar purposes. Part 1. General requirements
IEEE Standard for Extruded and Laminated Dielectric Shielded Cable Joints Rated 2.5 kV to 500 kV
Dust (Fine Sand) Test Procedure for Electrical Connectors
This standard applies to the materials, constructions, and testing of single conductor cables and assemblies of completed single conductor cables used for the distribution of electrical energy at phase-to-phase voltages not exceeding 600 volts or phase to ground not exceeding 480V, and at temperatures not exceeding 75°C or 90°C, as applicable to the construction. It requires the use of ruggedized extruded insulations.
Standard for 600 Volt Rated Cables of Ruggedized Design for Direct Burial Installation As Single Conductors or Assemblies of Single Conductors
This standard establishes a method to determine the integrity of the seal of the shell, insert and contact interfaces in an electrical connector.
Air Leakage Test Procedure for Electrical Connectors
This standard establishes a method to determine the ability of an insert to withstand axial forces in electrical connectors
Insert Retention Test Procedure for Electrical Connectors
Connecting devices. Safety requirements for screw-type and screwless-type clamping units for electrical copper coductors. Part 2. Particular reqirements for conductors from 35 up to 300 kv. mm
Firewall Flame Test Procedure for Electrical Connectors
(1) Proposed Sixth Edition: Modifications to clauses 7.18.2 and 8.33.1.1 after consideration of comments; (2) Proposed changes to clause 8.3.1 to specify smaller range of sheet metal thicknesses for snap-in type fittings.
Standard for Safety for Conduit, Tubing, and Cable Fittings
Connecting devices. Electrical copper conductors. Safety requirements for screw-type and screwless-type clamping units. Part 1. General requirements and particular requirements for clamping units for conductors from 0,2 up to 35 sq. mm (included)
Marking Permanence Test Procedure for Electrical Connectors and Sockets
Connecting devices for low-voltage circuits for household and similar purposes. Part 2-3: Particular requirements for connecting devices as separate entities with insulation-piercing clamping units
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号