29.130.20 低压开关装置和控制器 标准查询与下载

DB44/T 1391-2014 家用和类似用途磁敏温控开关

本标准规定了家用和类似用途磁敏温控开关（以下简称：温控开关）的术语和定义、分类、型号与基本参数、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准仅适用于额定电压不超过AC 250 V/50 Hz-60 Hz或DC 36V、额定电流不超过16A、动作温度范围在-80°C~+280°C的家用和类似用途磁敏温控开关。

Magnetic thermostat switches for household and similar purposes

GSO 2426:2014 用于服务连接的低压模制断路器

This specification describes the minimum technical requirements for design, material, manufacture, testing and performance of Molded Case Circuit Breakers (MCCB) for indoor or outdoor installation in an enclosure and intended to be used for Service Connections in the Low Voltage System of Electricity Utilities (EU) in GCC countries.

Low Voltage Molded Case Circuit Breakers for Service Connections

IEC 61439-5:2014 低压开关设备和控制设备配件.第5部分:公共网络配电用配件

Low-voltage switchgear and controlgear assemblies - Part 5: Assemblies for power distribution in public networks

IEC 62026-3:2014 低压开关设备和控制设备.控制器-器件的接口(CDIs).第3部分:器件网络

Low-voltage switchgear and controlgear - Controller-device interfaces (CDIs) - Part 3: DeviceNet

DIN EN 60947-7-4:2014 低压开关设备和控制设备. 第7-4部分: 辅助设备. 铜导体的PCB接线端子(IEC 60947-7-4-2013); 德文版本EN 60947-7-4-2013

Low-voltage switchgear and controlgear - Part 7-4: Ancillary equipment - PCB terminal blocks for copper conductors (IEC 60947-7-4:2013); German version EN 60947-7-4:2013

NF C63-160/A1*NF EN 60947-6-1/A1:2014 低压开关设备和控制设备. 第6-1部分: 多功能设备. 转换开关设备

Le présent amendement inclut les modifications techniques significatives suivantes par rapport à la NF EN 60947-6-1, de février 2006 : clarification du domaine d'application et de l'objet ; mise à jour des références normatives ; clarification de la classification de l'Article 4 ; nouvel essai CEM : harmoniques de tension ; essai minimal pour les TSE dérivés ; alignements selon l'Amendement 1, de septembre 2011 à la NF EN 60947-1, d'octobre 2007 ; alignements selon l'Amendement 1, de décembre 2012 à la NF EN 60947-4-1 d'août 2010 ; création de la bibliographie.Le présent document entre dans le champ d'application de la Directive Basse Tension no2006/95/CE d

Low-voltage switchgear and controlgear - Part 6-1 : multiple function equipment - Transfer switching equipment

DIN EN 61439-1 Bb.1:2014 低压开关设备和控制设备组件. 第1部分:总则; 补充件1:指定装配用指南 (IEC/TR 61439-0-2013)

Low-voltage switchgear and controlgear assemblies - Part 1: General rules; Supplement 1: Guidance to specifying assemblies (IEC/TR 61439-0:2013)

JB/T 5791-2014 船用组合开关

本标准规定了HZ910系列船用组合开关的型号与分类、标志、正常工作条件和安装条件、技术要求、试验方法、检验规则及包装、运输和贮存及保用期。 本标准适用于额定电压交流380 V (或440 V)、50 Hz (或60 Hz)及以下或直流220 V及以下电气线路中，供手动作不频繁接通或分断电路和换接电路的HZ910系列船用组合开关（以下简称开关），25 A及以下开关可控制小容量电动机。

Rotary switch for ship

IEC 60947-4-3:2014 低压开关装置和控制装置.第4-3部分:接触器和电动机起动器.非电动机负载用交流半导体控制器和接触器

This part of IEC 60947 applies to a.c. semiconductor non-motor load controllers and contactors intended for performing electrical operations by changing the state of a.c. electric circuits between the ON-state and the OFF-state. Typical applications are classified by utilization categories given in Table 2. As controllers@ they may be used to reduce the amplitude of the r.m.s. a.c. voltage on the load terminals from that of the applied voltage ?C either continuously or for a specified period of time. The half-wave period of the a.c. wave form remains unchanged from that of the applied voltage. They may include a series mechanical switching device and are intended to be connected to circuits@ the rated voltage of which does not exceed 1 000 V a.c. This standard characterizes controllers and contactors for use with or without bypass switching devices. The semiconductor controllers and contactors dealt with in this standard are not normally intended to interrupt short-circuit currents. Therefore@ suitable short-circuit protection (see 8.2.5) should form part of the installation but not necessarily of the controller itself. In this context@ this standard gives requirements for semiconductor controllers and contactors associated with separate short-circuit protective devices. This standard does not apply to: ? operation of a.c. and d.c. motors; ? low-voltage a.c. semiconductor motor controllers and starters covered by IEC 60947-4-2; ? electronic a.c. power controllers covered by the IEC 60146 series; ? all-or-nothing solid-state relays. Contactors and control-circuit devices used in semiconductor controllers and contactors should comply with the requirements of their relevant product standard. Where mechanical switching devices are used@ they should meet the requirements of their own IEC product standard and the additional requirements of this standard. The object of this standard is to state a) the characteristics of semiconductor controllers and contactors and associated equipment; b) the conditions with which semiconductor controllers and contactors should comply with reference to: - their operation and behaviour; - their dielectric properties; - the degrees of protection provided by their enclosures@ where applicable; - their construction; c) the tests intended for confirming that these conditions have been met@ and the methods to be adopted for these tests; d) the information to be given with the equipment or in the manufacturer's literature.

Low-voltage switchgear and controlgear - Part 4-3: Contactors and motor-starters - AC semiconductor controllers and contactors for non-motor loads

IEC TR 60890:2014 通过计算评估低压开关开光装置和控制装置总成温升的方法

A method of temperature-rise verification of low-voltage switchgear and controlgear assemblies by calculation

DB53/T 577-2014 高原用交流40.5 kV金属封闭高压开关设备最小安全距离

本标准规定了额定电压为交流40.5 kV户内交流金属封闭高压开关设备的最小安全距离。 本标准适用于海拔1 000 m以上至3 000 m地区交流40.5 kV户内交流金属封闭高压开关设备的设计、安装使用中最小安全距离的选用。

The minimum safe distance of AC 40.5 kV metal-enclosed high-voltage switchgear for plateau use

KS C IEC 62208:2014 低电压控制装置的外壳 一般要求

Empty enclosures for low-voltage switchgear and controlgear assemblies-General requirements

CAN/CSA-C22.2 No.60947-4-2-2014 低压开关设备和控制设备 第4-2部分：接触器和电机起动器 交流半导体电机控制器和起动器（双国标准 符合 UL 60947-4-2）

Scope and object This standard applies to controllers and starters, which may include a series mechanical switching device, intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V a.c. This standard characterizes controllers and starters with and without bypass means. Controllers and starters dealt with in this standard are not normally designed to interrupt short-circuit currents. Therefore, suitable short-circuit protection (see 8.2.5) should form part of the installation, but not necessarily of the controller or starter. In this context, this standard gives requirements for controllers and starters associated with separate short-circuit protective devices. This standard does not apply to: - continuous operation of a.c. motors at motor speeds other than the normal speed; - semiconductor equipment, including semiconductor contactors (see 2.2.13 of IEC 60947-1) controlling non-motor loads; - electronic a.c. power controllers covered by IEC 60146. Contactors, overload relays and control circuit devices used in controllers and starters should comply with the requirements of their relevant product standard. Where mechanical switching devices are used, they should meet the requirements of their own IEC product standard, and the additional requirements of this standard. The object of this standard is to state as follows: - the characteristics of controllers and starters and associated equipment; - the conditions with which controllers and starters shall comply with reference to: a) their operation and behaviour; b) their dielectric properties; c) the degrees of protection provided by their enclosures where applicable; d) their construction; - the tests intended for confirming that these conditions have been met, and the methods to be adopted for these tests; - the information to be given with the equipment, or in the manufacturer's literature. 1DV DC Modification of 1 by adding the following: 1DV.1 Circuit breakers used as short-circuit protective devices in combination starters and protected starters shall comply with the requirements of Annex DVB, Table DVB.3, Ref. No. 3. IEC 60947-2 Part 2: Circuit-breakers does not apply. 1DV.2 Disconnect switches shall comply with the requirements of Annex DVB, Table DVB.3, Ref. No 1. IEC 60947-3 Part 3: Switches, disconnectors, switch-disconnectors and fuse combination units does not apply. 1DV.3 Fuses used as short-circuit protective devices in combination and protected starters shall comply with the requirements of Annex DVB, Table DVB.3, Ref. No. 2. 1DV.4 Molded case switches in combination with fuses used as short-circuit protective devices in combination starters shall comply with the requirements of Annex DVB, Table DVB.3, Ref. No. 3, and Annex DVB, Table DVB.3, Ref. No. 2.

Low-voltage switchgear and controlgear - Part 4-2: Contactors and motor-starters - AC semiconductor motor controllers and starters (Bi-national standard, with UL 60947-4-2)

DIN EN 62683:2014 低压开关设备和控制设备. 信息交换用产品数据和性能 (IEC 62683-2013); 德文版本EN 62683-2013

Low-voltage switchgear and controlgear - Product data and properties for information exchange (IEC 62683:2013); German version EN 62683:2013

IEC TS 61439-7:2014 低压开关装置和控制装置装配件.第7部分:码头、露营地点、市集广场、电动汽车充电站专门应用装配件

Low-voltage switchgear and controlgear assemblies - Part 7: Assemblies for specific applications such as marinas, camping sites, market squares, electric vehicles charging stations

DIN EN 60947-4-1:2014 低压开关装置和控制装置.第4-1部分:接触器和电机启动器.机电式接触器和电机启动器(IEC 60947-4-1-2009+A1-2012).德文版本EN 60947-4-1-2010+A1-2012

Low-voltage switchgear and controlgear - Part 4-1: Contactors and motor-starters - Electromechanical contactors and motor-starters (IEC 60947-4-1:2009 + A1:2012); German version EN 60947-4-1:2010 + A1:2012

BS EN 62026-2:2013 低压开关设备和控制设备.控制器装置接口(CDIs).促动器传感元件接口(AS-i)

Low-voltage switchgear and controlgear. Controller-device interfaces (CDIs). Actuator sensor interface (AS-i)

DIN EN 60947-5-2:2014 低压开关装置和控制装置.第5-2部分:控制电路装置和开关元件.接近开关(IEC 60947-5-2-2007+A1-2012).德文版本EN 60947-5-2-2007+A1-2012

Low-voltage switchgear and controlgear.Part 5-2: Control circuit devices and switching elements.Proximity switches (IEC 60947-5-2:2007 + A1:2012); German version EN 60947-5-2:2007 + A1:2012

DIN EN 60947-2:2014 低压开关设备.第2部分:断路器(IEC 60947-2-2006+A1-2009+A2-2013).德文版本EN 60947-2-2006+A1-2009+A2-2013

Low-voltage switchgear and controlgear.Part 2: Circuit-breakers (IEC 60947-2:2006 + A1:2009 + A2:2013); German version EN 60947-2:2006 + A1:2009 + A2:2013

GOST IEC 60947-1-2014 低压开关设备和控制设备. 第1部分. 通用规则

Low-voltage switchgear and controlgear. Part 1. General rules