29.130.20 低压开关装置和控制器 标准查询与下载

IEC 61439-3:2012/COR1:2013 低压成套开关装置和控制装置组合.第3部分:拟由普通人员操作的配电板(DBO).勘误表1

Low-voltage switchgear and controlgear assemblies - Part 3: Distribution boards intended to be operated by ordinary persons (DBO); Corrigendum 1

NF C63-026-2*NF EN 62026-2:2013 低压开关装置和控制装置.控制器-装置的接口(CDIs).第2部分:执行器传感器接口(AS-i)

Low-voltage switchgear and controlgear - Controller-device interfaces (CDIs) - Part 2: actuator sensor interface (AS-i)

NF C63-026-7*NF EN 62026-7:2013 低压开关装置和控制装置.控制器装置的接口(CDIs).第7部分:元器件网(CompoNet)

Low-voltage switchgear and controlgear - Controller-device interface (CDIs) - Part 7: CompoNet

NF C63-083:2013 低压开关设备和控制装置.信息交换用产品数据和性能

Low-voltage switchgear and controlgear - Product data and properties for information exchange

NF C63-120/A2:2013 低压开关装置和控制装置.第2部分:断路器

Low-voltage switchgear and controlgear - Part 2: circuit-breakers

IEC 60947-5-3:2013 低压开关设备和控制装置.第5-3部分:控制电路器件和开关元件.在故障条件下具有规定特性的接近装置(PDDB)的要求

Low-voltage switchgear and controlgear - Part 5-3: Control circuit devices and switching elements - Requirements for proximity devices with defined behaviour under fault conditions (PDDB)

DIN EN 60947-6-1 Berichtigung 1:2013 低压开关装置和控制装置 第6-1部分 多功能设备 转换开关设备 (IEC 60947-6-1-2005) 德文版本EN 60947-6-1-2005、DIN EN 60947-6-1 (VDE 0660-114)-2006-07标准的勘误表

Low-voltage switchgear and controlgear - Part 6-1: Multiple function equipment - Transfer switching equipment (IEC 60947-6-1:2005); German version EN 60947-6-1:2005, Corrigendum to DIN EN 60947-6-1 (VDE 0660-114):2006-07

IEC 60947-7-4:2013 低压开关设备和控制设备.第7-4部分:辅助设备.铜导线用PCB接线端子

"This part of IEC 60947 specifies requirements for PCB terminal blocks primarily intended for industrial or similar use. Mounting and fixing on the printed circuit board is made by soldering@ press-in or equivalent methods to provide electrical and mechanical connection between copper conductors and the printed circuit board. This standard applies to PCB terminal blocks intended to connect copper conductors@ with or without special preparation@ having a cross-section between 0@05 mm2 and 300 mm2 (AWG 30/600 kcmil)@ intended to be used in circuits of a rated voltage not exceeding 1 000 V a.c. up to 1 000 Hz or 1 500 V d.c. NOTE 1 Large cross section terminal blocks are dedicated to specific design of high current PCBs. The range up to 300 mm? is kept to cover any possible application. Examples of high current PCBs and PCB terminal blocks are shown in Annex C. NOTE 2 AWG is the abbreviation of ""American Wire Gage"" (Gage (US) = Gauge (UK)); kcmil = 1 000 cmil; 1 cmil = 1 circular mil = surface of a circle having a diameter of 1 mil; 1 mil = 1/1 000 inch. This standard may be used as a guide for special types of PCB terminal blocks with components@ such as disconnect units@ integrated cartridge fuse-links and the like. If applicable@ in this standard the term ""clamping unit"" is used instead of ""terminal"". This is taken into account in case of references to IEC 60947-1."

Low-voltage switchgear and controlgear - Part 7-4: Ancillary equipment - PCB terminal blocks for copper conductors

UL 60947-1-2013 低压开关设备和控制设备.第1部分:一般规则

UL Standard for Safety Low-Voltage Switchgear and Controlgear �C Part 1: General rules (Fifth Edition)

BS EN 62683:2013 低压开关设备和装置.信息交换用产品数据和性能

Low-voltage switchgear and controlgear. Product data and properties for information exchange

CAN/CSA-C22.2 NO.60947-2013 低压开关设备和控制设备 第1部分：一般规则（第二版）

Low-Voltage Switchgear and Controlgear - Part 1: General rules (Second Edition)

BS EN 62026-7:2013 低压开关设备和控制设备. 控制器设备接口(CDI). CompoNet

Low-voltage switchgear and controlgear. Controller-device interfaces (CDIs). CompoNet

DS/EN 62683:2013 低压开关设备和控制设备 用于信息交换的产品数据和特性

IEC 62683:2013 is used to facilitate the exchange in electronic format of data describing low voltage switchgear and controlgear. This standard provides clear and unambiguous definitions of a limited number of properties and classes which are mainly used

Low-voltage switchgear and controlgear - Product data and properties for information exchange

DS/EN 62026-2:2013 低压开关设备和控制设备 控制器设备接口（CDI） 第2部分：执行器传感器接口（AS-i）

This part of IEC 62026 specifies a method for communication between a single control device and switching elements, and establishes a system for the interoperability of components with the specified communication interfaces. The complete system is called

Low-voltage switchgear and controlgear - Controller-device interfaces (CDIs) - Part 2: Actuator sensor interface (AS-i)

CAN/CSA-C22.2 No.60947-1-2013 低压开关设备 第1部分：一般规则

La présente norme est applicable, lorsque la norme de matériel correspondante le précise, à l'appareillage désigné ci-après «matériel», et destiné à être relié à des circuits dont la tension assignée ne dépasse pas 1 000 V en courant alternatif ou 1 500 V en courant continu. Elle ne s'applique pas aux ensembles d'appareillage à basse tension qui sont traités dans la CEI 60439. désigné «appareil» pour des raisons d'homogénéité avec le texte de ces articles ou paragraphes. La présente norme a pour objet de fixer les règles et exigences générales communes au matériel à basse tension défini en 1.1, comprenant par exemple: – les définitions; – les caractéristiques; – les informations fournies avec le matériel; – les conditions normales de service, de montage et de transport; – les exigences de construction et de fonctionnement; – la vérification des caractéristiques et du fonctionnement. Les entrées tout-ou-rien et/ou les sorties tout-ou-rien contenues dans l’appareillage, et destinées à être compatibles avec les automates programmables (PLC) sont couverts par l’Annexe S.

Low voltage switchgear — Part 1: General rules

DIN EN 60947-8:2013 低压开关设备和控制设备.第8部分:旋转电机内置热保护(PTC)控制装置(IEC 60947-8-2003+A1-2006+A2-2011).德文版本EN 60947-8-2003+A1-2006+A2-2012

Low-voltage switchgear and controlgear - Part 8: Control units for built-in thermal protection (PTC) for rotating electrical machines (IEC 60947-8:2003 + A1:2006 + A2:2011); German version EN 60947-8:2003 + A1:2006 + A2:2012

DS/IEC/TR 61439-0:2013 低压开关设备和控制设备组件 第0部分：指定组件的指南

Se engelsk abstract.

Low-voltage switchgear and controlgear assemblies - Part 0: Guidance to specifying assemblies

DS/EN 60947-2/A2:2013 低压开关设备和控制设备 第2部分：断路器

Applies to circuit-breakers, the main contacts of which are intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V a.c. or 1 500 V d.c.; it also contains additional requirements for integrally fused circuit-breakers. It a

Low-voltage switchgear and controlgear - Part 2: Circuit-breakers

DIN EN 61439-6:2013 低压开关装置和控制装置组件.第6部分:中继系统(母线槽)(IEC 61439-6-2012).德文版本EN 61439-6-2012

Low-voltage switchgear and controlgear assemblies - Part 6: Busbar trunking systems (busways) (IEC 61439-6:2012); German version EN 61439-6:2012

LST EN 61439-4-2013 低压成套开关设备和控制设备. 第4部分: 对建筑工地用成套设备的特殊要求(IEC 61439-4-2012)

Low-voltage switchgear and controlgear assemblies -- Part 4: Particular requirements for assemblies for construction sites (ACS) (IEC 61439-4:2012)