29.140.20 白炽灯 标准查询与下载

IEC 60630:1994/AMD5:2005 修改件5.白炽灯最大外形尺寸

This standard is Amendment 5 - Maximum lamp outlines for incandescent lamps.

Amendment 5 - Maximum lamp outlines for incandescent lamps

IEC 60432-3/AMD1:2005 修改件1.白炽灯.安全规范.第3部分:钨卤灯(非车用)

This is Amendment 1 to IEC 60432-3-2002 (Incandescent lamps Safety specifications Part 3: Tungsten-halogen lamps (non-vehicle))

Amendment 1 - Incandescent lamps - Safety specifications - Part 3: Tungsten-halogen lamps (non-vehicle)

IEC 60432-1:1999/AMD1:2005 修改件1.白炽灯.安全规范.第1部分:家用和类似场合普通照明用钨丝灯

This is Amendment 1 to IEC 60432-1-1999 (Incandescent lamps Safety specifications Part1: Tungsten filament lamps for domestic and similar general lighting purposes)

Amendment 1 - Incandescent lamps - Safety specifications - Part 1: Tungsten filament lamps for domestic and similar general lighting purposes

IEC 60064:1993/AMD3:2005 修改件3.家用及类似场合普通照明用钨丝灯.性能要求

This is Amendment 3 to IEC 60064-1993 (Tungsten filament lamps for domestic and similar general lighting purposes -Performance requirements)

Amendment 3 - Tungsten filament lamps for domestic and similar general lighting purposes - Performance requirements

DS/EN 61047:2005 白炽灯用直流或交流供电的电子降压转换器 性能要求

This standard specifies performance requirements for electronic step-down convertors for use on d.c. supplies up to 250 V and a.c. supplies up to 1000 V at 50 Hz or 60 Hz with operating frequencies deviating from the supply frequency, associated with tungsten halogen lamps as specified in IEC 60357 and other filament lamps. NOTE 1 The tests in this standard are type tests. Requirements for testing individual convertors during production are not included. NOTE 2 Requirements for convertors which incorporate means for varying the lamp power are under consideration. NOTE 3 It may be expected that convertors complying with this standard will ensure satisfactory

DC or AC supplied electronic step-down convertors for filament lamps - Performance requirements

UL 2388 BULLETINS-2005

UL is seeking ANSI approval for the First Edition of the Standard for Flexible Lighting Products. Contact Dixie Stevens at UL for the full scope of the standard

12/16/2005 (18p)

IEC 60983:2005 小型灯

本标准规定了对额定电压不大于30 V，额定功率不大于25 W的小型卤素和非卤素灯泡的要求。 包括： ——在道路机动车辆上使用，不是法规所涉及因而没有包含在IEC 60809中的灯泡(第2章)； ——手电筒灯泡(第3章)； ——矿用头灯灯泡(第4章)。 有关飞机灯泡的要求见GB／T 21095。 本标准规定了尺寸、光电性能要求以及关于寿命和机械强度的要求。 注：这些要求是对产品灯泡的要求。个别灯泡可能不完全在这些要求之内，这就需要一致性的条件，它们在相应的 章中规定。 对本标准规定的一些要求，见“有关的灯泡数据活页”。对某些灯泡，其数据活页包含在本标准中。 对属于本标准范围的其他灯泡，有关数据由灯泡制造商或负责的销售商提供。 本标准也可用于将来的光源开发，例如，由发光二极管(LED)发光的光源。

Miniature lamps

LST EN 61047-2004 用于白炽灯的直流或交流供电电子降压转换器 性能要求（IEC 61047:2004）

DC or AC supplied electronic step down convertors for filament lamps. Performance requirements (IEC 61047:2004)

NF R13-629/A3:2004 道路车辆用灯.尺寸、电和照明要求

Lamps for road vehicles - Dimensional, electrical and luminous requirements.

ANSI C78.1460-2004 GZ9.5基座,T6灯泡,36.5毫米LCL,76.2毫米MOL,有近反射器的单端钨卤素灯

This project is a revision of ANSI C78.1460-1991. This standard defines the dimensional, physical, and other characteristics to assist in the proper application of tungsten-halogen lamps with GZ9.5 bases, T6 (T19) bulbs at 36.5 mm LCL and 76.2 mm maximum

Single-Ended Tungsten-Halogen Lamps, GZ9.5 Base, T6 Bulb, 36.5 mm LCL, 76.2 mm MOL with Proximity Reflector

DLA MS25236 REV G-2004 滚花螺钉座T-1-1/4白炽灯

THREADS SHALL BE IN ACCORDANCE WITH FEDERAL HANDBOOK H-28.

LAMPS, INCANDESCENT T-1-1/4, KNURLED SCREW BASE

DLA MS25231 REV G-2004 (T-3-1/4灯泡)小型卡口灯座接触中心白炽灯

This specification sheet is approved for use by all Departments and Agencies of the Department of Defense.

LAMPS, INCANDESCENT, CENTER CONTACT, MINIATURE BAYONET BASE (T-3-1/4 BULB)

LST EN 60630+A3-2001/A4-2004 白炽灯的最大灯外形（IEC 60630:1994/A4:2002，已修改）

Maximum lamp outlines for incandescent lamps (IEC 60630:1994/A4:2002, modified)

ANSI C78.1407-2004 电灯.聚光器反光镜、四脚、预聚焦底座投影灯.尺寸

This project is a revision of ANSI C78.1407-1985

Electric Lamps - Condenser-Reflector, Four-Pin Prefocus-Base Projection Lamps - Dimensions

ANSI C78.1406-2004 电灯.灯座向下操作基于投影灯的P28单触点中等预聚焦.尺寸

This project is a revision of ANSI C78.1406-1983 This standard established the dimensions essential to the interchangeability of single-contact medium prefocus based projection lamps of T-10 and T-12 bulb sizes.

Electric Lamps - P28 Single-Contact Medium Prefocus Based Projection Lamps for Base-Down Operation - Dimensions

ANSI C78.1402-2004 投影灯的尺寸.灯座向下操作基于四脚、预聚焦的G17q和GX17q

This standard established the dimensions essential to the interchangeability of four-pin, prefocus projection lamps for base-down operation of T10 and T12 bulb sizes.

Dimensions for Projection Lamps - G17q and GX17q Based Four-pin, Prefocus, for Base-down Operation

ANSI C78.1401-2004 电灯.双触点、中等环(专门B型)、灯头向上型投影灯的尺寸规格

This standard established the dimensions essential to the interchangeability of lamps of the double-contact, medium ring (Special B) base-up type.

Electric lamps - Dimensions for Projection Lamps - Double-Contact, Medium Ring (Special B), Base-up Type

ANSI C78.60432.2-2004 电灯.白炽灯.安全规范.家用和类似一般照明用钨卤灯.第2部分

This standard concerns Incandescent lamps-Safety Specifications-Part II: Tungsten Halogen Lamps for Domestic and Similar General Lighting Purposes

Electric Lamps - Incandescent Lamps - Safety Specifications - Tungsten Halogen Lamps for Domestic and Similar General Lighting Purposes - Part 2

KS C IEC 61126:2003 最大灯泡外形图绘制中采用的程序

이 규격에서는 램프 외곽 치수 도면과 이 치수를 적용한 제조 및 검사 과정에 대해 다룬

Procedure for use in the preparation of maximum lamp outlines

KS C IEC 60064:2003 家用和类似普通照明用钨灯泡.性能要求

이 규격은 KS C IEC 60432-1의 안전 요구 사항에 적합하며 다음의 요건을 갖

Tungsten filament lamps for domestic and similar general lighting purposes－Performance requirements