共找到 656 条与 白炽灯 相关的标准,共 44 页
This International Standard specifies requirements for miniature halogen and non-halogen lamps with a nominal voltage up to 30 V and a nominal wattage up to 25 W. It covers: - lamps to be used in road vehicles not subject to regulation and which therefore are not included in IEC 809 (section 2); - lamps for electric torches (section 3); - lamps for miners' caplights (section 4). Aircraft lamps are standardized in IEC 434.
Miniature lamps
Amendment 1 - Procedure for use in the preparation of maximum lamp outlines
This notice should be filed in front of MS90451(AS), dated 17 May 1967.
LAMP, INCANDESCENT, T-1 BULB, SHORT, INTEGRAL LIGHTING
MS90452A(AS) is inactive for new design and is no longer used, except for replacement purposes.
LAMP, INCANDESCENT, T-3/4 BULB, INTEGRAL LIGHTING
本规范规定了飞机用白炽灯泡的技术要求、试验方法、检测规则、包装、标志、运输、贮存的一般要求。 本规范适用于飞机用白炽灯泡(以下简称“灯泡”)。
General specifications for incandescent bulbs used in airplanes
Tungsten halogen lamps (non vehicle); Amendment 10
Safety specifications for incandescent lamps - Part 2: Tungsten halogen lamps for domestic and similar general lighting purposes; Amendment 1
This notice should be filed in front of MS289264 dated 7 March 1972.
LAMP, INCANDESCENT, PAR-36 BULB, SCREW TERMINAL BASE, TAXIING
This ncice should be filed in front of MS25239A, dated 27 July 1962.
LAMP, INCANDESCENT, PAR-36 BULB, SCREW TERMINAL BASE, SIGNALING
MS25243A is inactive for new design and is no longer used, except for replacement purposes.
LAMP, INCANDESCENT, PAR-36 BULB, SCREW TERMINAL BASE
This notice should be filed in front of MS25241E, dated 21 March 1972.MS25241E is inactive for new design and is no longer used, except for replacement purposes.
LAMP, INCANDESCENT, PAR-36 BULB, SCREW TERMINAL BASE, LANDING
This CID covers requirements for four types of miniature incandescent lamps used in military ground vehicles.
LAMP BULBS, INCANDESCENT, MINIATURE, SINGLE AND DOUBLE CONTACT, BAYONET CANDELABRA BASE
D.C. or a.c. supplied electronic step-down convertors for filament lamps - Performance requirements; Amendment 1
この規格は,道路交通法に基づき設置された信号機に用いる電球について規定する。
Traffic signal lamps
この規格は,電源としてJIS C 8501及びJIS C 8511に規定する一次電池を使用する携帯電灯に用いる電球について規定する。ただし,一次電池以外の電池に使用する電球及び携帯電灯以外の電池器具に使用する電球についでも,形式が同ヒものは,この規格を準用する。
Torch lamps
Incandescent lamps for general lighting purpose
This International Standard applies to tungsten filament incandescent lamps for general lighting service (GLS) which comply with the safety requirements in IEC 60432-1 and having: — rated wattage of 25 W to 200 W, inclusive; — rated voltage 100 V to 250 V, including marked voltage range not exceeding ±2,5 % of the mean voltage1); — bulbs of the A or PS shapes; — bulbs with clear, frosted or equivalently coated finishes, or white finishes; — ?caps B22d or E27?. Specific lamp types are covered in Section 8. This standard states the performance requirements for lamps, including test methods and means of confirming compliance with the requirements. Whole production appraisal methods regarding a lamp manufacturer’s test record on finished products are defined. This method can be applied for certification purposes. Details of a batch test procedure, which can be used to make an assessment of specific batches, are included, but it is not suitable for certification purposes. #For some of the requirements given in this standard reference is made to “the relevant data sheet”. For some lamps these data sheets are contained in this standard. For other lamps, falling under the scope of this standard, the relevant data are supplied by the lamp manufacturer or responsible vendor.$ The test and measurement methods contained in this standard are also applicable for the assessment of tungsten filament incandescent lamps not directly covered by the scope of this standard e.g. other bulb shapes, finishes etc.
Tungsten filament lamps for domestic and similar general lighting purposes - Performance requirements
Tungsten filament lamps for domestic and similar general lighting purposes. Performance requirements
For lamps which comply with BS EN 60432-1:1995.
Tungsten filament lamps for domestic and similar general lighting purposes - Performance requirements
This International Standard applies to tungsten filament incandescent lamps for general lighting service (GLS) which comply with the safety requirements in IEC 60432-1 and having: — rated wattage of 25 W to 200 W, inclusive; — rated voltage 100 V to 250 V, including marked voltage range not exceeding ±2,5 % of the mean voltage1); — bulbs of the A or PS shapes; — bulbs with clear, frosted or equivalently coated finishes, or white finishes; — ?caps B22d or E27?. Specific lamp types are covered in Section 8. This standard states the performance requirements for lamps, including test methods and means of confirming compliance with the requirements. Whole production appraisal methods regarding a lamp manufacturer’s test record on finished products are defined. This method can be applied for certification purposes. Details of a batch test procedure, which can be used to make an assessment of specific batches, are included, but it is not suitable for certification purposes. #For some of the requirements given in this standard reference is made to “the relevant data sheet”. For some lamps these data sheets are contained in this standard. For other lamps, falling under the scope of this standard, the relevant data are supplied by the lamp manufacturer or responsible vendor.$ NOTE 1 A lamp used in China having a rated wattage 15 W and rated voltage 220 V is included. ?Note deleted?
Tungsten filament lamps for domestic and similar general lighting purposes - Performance requirements
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号