29.180 变压器、电抗器、电感器 标准查询与下载

DL/T 2622-2023 1000kV高压并联电抗器局部放电现场测量技术导则

本文件规定了1000kV高压并联电抗器（以下简称高抗）现场局部放电测量的试验要求、试验方法、现场干扰的抑制措施。 本文件适用于额定频率为50Hz、电压等级为1000kV的单相油浸式高抗局部放电现场测量，用以现场考核1000kV电抗器在运输和现场安装后的绝缘性能。现场绝缘诊断性试验可参照执行。

Technical Guidelines for On-site Measurement of Partial Discharge of 1000kV High Voltage Shunt Reactor

DL/T 1400.3-2023 变压器测试仪校准规范 第3部分：油浸式变压器测温装置

本文件规定了油浸式电力变压器（电抗器、换流变压器）测温装置（以下简称“测温装置”）的计量特性、校准条件、校准项目和校准方法、校准结果表达、复校时间间隔的要求等。 本文件适用于测温装置的实验室校准、现场校准，不适用于光纤传感器测温装置的校准。

Calibration specifications for transformer testers Part 3: Oil-immersed transformer temperature measurement device

DL/T 2599.1-2023 电力变压器用组部件和原材料选用导则 第1部分：总则

本文件规定了电力变压器、电抗器用组部件和原材料选用的产品分类和选用原则、技术要求、组部件试验、原材料检验、安装和运维、安全和环境、标志、标签和随行文件、包装、运输和贮存等要求。 本文件适用于液浸式和干式电力变压器、电抗器用组部件和原材料的选择和使用。

Guidelines for the selection of components and raw materials for power transformers Part 1: General principles

T/CEEIA 683-2023 高压/特高压换流变压器 分接开关隔板防爆能力 试验方法

本文件规定了高压/特高压换流变压器分接开关隔板防爆能力总则、试验样品准备、试验参数、试验准备、试验方法、合格判定等。 本文件适用于高压/特高压换流变压器分接开关隔板防爆能力验证试验。其他变压器可参照使用。

Test method for flameproof performance of tap-changer separators of HV/UHV converter transformers

T/CEEIA 684-2023 高压/特高压换流变压器 网侧升高座模拟内部电弧放电 试验方法

本文件规定了高压/特高压换流变压器网侧升高座模拟内部放电的总则、试验样品准备、试验参数、试验准备、试验方法和合格判定等。 本文件适用于高压/特高压换流变压器产品鉴定及安全性检测,其他变压器可参照使用。

Test method for simulating internal discharge of HV/UHV grid side risers of converter transformers

T/CEEIA 686-2023 高压/特高压换流变压器 关键部件燃弧试验 安全导则

本文件给出了高压/特高压换流变压器关键部件燃弧试验的基本安全、安全技术措施、燃弧试验安全和其他安全措施。 本文件用于指导开展高压\特高压换流变压器关键部件燃弧试验安全措施等。

Safety guide for key components arcing test of HV/UHV converter transformers

T/CEEIA 682-2023 高压/特高压换流变压器 分接开关压力释放装置 试验方法

本文件规定了高压/特高压换流变压器分接开关压力释放装置试验方法的试验参数、试验准备、试验程序和合格判据。 本文件适用于高压/特高压换流变压器分接开关压力释放装置验证试验，其他变压器可参照使用。

Test method for tap-changer pressure relief device of HV/UHV converter transformers

T/CEEIA 685-2023 高压/特高压换流变压器 关键部件燃弧试验室 电气火灾消防配置导则

本文件给出了高压/特高压换流变压器关键部件燃弧试验室电气火灾消防配置基本安全、消防与环保措施、燃弧试验安全等。 本文件用于指导开展高压/特高压换流变压器燃弧试验室电气火灾消防配置。

Electrical fire configuration guideline for key components arcing test lab Of HV/UHV converter transformers

IEC 60076-19-1:2023 电力变压器.第19-1部分:电力变压器损耗测量中不确定度的测定规则

Power transformers - Part 19 - 1: Rules for the determination of uncertainties in the measurement of the losses of power transformers

GSO IEC 60076-22-6:2023 电力变压器 第22-6部分：电力变压器和电抗器配件 变压器用电风扇

IEC 60076-22-6:2021 covers the electric fans used in the cooling circuits of power transformers and reactors. It applies to electric fans mounted on liquid immersed power transformers according to IEC 60076-1 and reactors according to IEC 60076-6 with and without conservator for indoor or outdoor installation. It outlines the service conditions and the mechanical and electrical requirements that are common to all the equipment. The electric fans concerned by this document are of the axially operating type and are for use on liquid to air coolers and for blowing out radiators. This document also outlines the operation requirements specific to each equipment as well as the preferred dimensions relevant for interchangeability and uniform fan assembly and the type and routine tests to be performed.

Power transformers - Part 22-6: Power transformer and reactor fittings - Electric fans for transformers

GSO IEC 60076-22-5:2023 电力变压器 第22-5部分：电力变压器和电抗器配件 变压器用电动泵

IEC 60076-22-5:2021 covers electric pumps used in the cooling circuits of power transformers and reactors. It applies to electric pumps mounted on liquid immersed power transformers according to IEC 60076-1 and reactors according to IEC 60076-6 with and without conservator for indoor or outdoor installation. It outlines the operation requirements for the electrical and hydraulic performance, mechanical design, routine testing and type testing. Additionally, performance and dimensions of preferred sizes of pump sets are specified in informative annexes. The pumps covered in this document are rotodynamic pumps driven by a squirrel cage induction motor that is immersed in the insulating liquid. Pump sets conforming to this document can be of in-line or end suction design.

Power transformers - Part 22-5: Power transformer and reactor fittings - Electric pumps for transformers

BS EN IEC 60076-25:2023 电力变压器 中性点接地电阻

This part of IEC 60076 applies to dry type natural air-cooled resistors, for neutral grounding of transformers and generators, in order to limit the earth fault current in power systems by means of metallic resistive elements. For the purposes of this document, the resistor can be: • used alone or in combination with other electrotechnical products not covered by this document, such as (but not limited to): a step-down single-phase transformer, an open triangle or zig-zag transformer (where the neutral point is not available) and a Petersen coil reactor (in order to increase active power contribution to the fault or reduce time constant for proper protection operation or both); • designed, manufactured and verified on a one-off basis or fully standardized and manufactured in quantity. Both terms "neutral grounding resistor" (NGR) and "neutral earthing resistor" (NER) can be used. However, for the purposes of this document and in order to avoid any confusion with "neutral earthing reactor" (NER), the term "neutral grounding resistor" (NGR) is used. This document specifies: • the characteristics of the NGR; • the service conditions requirements for NGRs; • the tests and test methods for confirming that these conditions have been met; • the requirements relating to marking for NGRs. Annex A provides guidance on how to consider the effect of resistance variation with temperature.

Power transformers - Neutral grounding resistors

T/QGCML 727-2023 高稳定性节能变压器

本标准规定了高稳定性节能变压器的术语定义、技术要求、试验方法、检验规则、标志、包装、运输及贮存。 本标准适用于生产高稳定性节能变压器的企业。

High Stability Energy Saving Transformer

EN IEC 60076-25:2023 电力变压器 第25部分：中性点接地电阻器

IEC 60076-25:2023 applies to dry type natural air-cooled resistors, for neutral grounding of transformers and generators, in order to limit the earth fault current in power systems by means of metallic resistive elements. For the purposes of this document, the resistor can be: used alone or in combination with other electrotechnical products not covered by this document, such as (but not limited to): a step-down single-phase transformer, an open triangle or zig-zag transformer (where the neutral point is not available) and a Petersen coil reactor (in order to increase active power contribution to the fault or reduce time constant for proper protection operation or both); designed, manufactured and verified on a one-off basis or fully standardized and manufactured in quantity. Both terms "neutral grounding resistor" (NGR) and "neutral earthing resistor" (NER) can be used. However, for the purposes of this document and in order to avoid any confusion with "neutral earthing reactor" (NER), the term "neutral grounding resistor" (NGR) is used. This document specifies: the characteristics of the NGR; the service conditions requirements for NGRs; the tests and test methods for confirming that these conditions have been met; the requirements relating to marking for NGRs. Annex A provides guidance on how to consider the effect of resistance variation with temperature.

Power transformers - Part 25: Neutral grounding resistors

T/JSEE 001-2023 电力变压器有载分接开关振动在线监测装置技术规范

本文件规定了电力变压器有载分接开关振动在线监测装置（以下简称装置）的组成、工作条件、技术要求、试验项目及要求、检验规则和标志、包装、运输、贮存等要求。  本文件适用于电力变压器有载分接开关振动在线监测装置的设计、生产、采购和检验。

Technical specifications for on-load tap-changer vibration on-line monitoring device for power transformers

IEC 61558-2-3:2023 变压器、电抗器、电源装置及其组合的安全性 第 2-3 部分：燃气和燃油燃烧器用点火变压器的特殊要求和试验

Safety of transformers, reactors, power supply units and combinations thereof - Part 2-3: Particular requirements and tests for ignition transformers for gas and oil burners

23/30470527 DC BS EN IEC 61558-2-5 变压器、电抗器、电源装置及其组合的安全 第 2-5 部分 剃须刀变压器、剃须刀电源装置和剃须刀供电装置的特殊要求和试验

BS EN IEC 61558-2-5. Safety of transformers, reactors, power supply units and combinations thereof - Part 2-5. Particular requirements and test for transformer for shavers, power supply units for shavers and shaver supply units

IEC 60076-25:2023 电力变压器第25部分:中性点接地电阻器

Power transformers - Part 25: Neutral grounding resistors

23/30468415 DC BS EN 50719 用于绝缘液体填充变压器的 250A 至 4000A 套管的连接端子标志

BS EN 50719. Connecting terminal flags for bushings from 250A to 4000A for insulating liquid filled transformers

KS C IEC 61558-2-1-2022 变压器、电抗器、电源装置及其组合的安全.第2-1部分:一般应用的分离变压器和包含分离变压器的电源装置的特殊要求和试验

Safety of transformers, reactors, power supply units and combinations thereof — Part 2-1: Particular requirements and tests for separating transformers and power supply units incorporating separating