29.240.20 标准查询与下载

BS EN 50341-2-16:2016 超过AC 1 kV的架空电力线路. 挪威国家标准方面(NNA) (基于EN 50341-1-2012)

Overhead electrical lines exceeding AC 1 kV. National Normative Aspects (NNA) for NORWAY (based on EN 50341-1:2012)

BS EN 50341-2-13:2017 超过AC 1 kV的架空电力线路. 意大利国家标准方面(NNA) (基于EN 50341-1-2012)

Overhead electrical lines exceeding AC 1 kV. National Normative Aspects (NNA) for ITALY (based on EN 50341-1:2012)

BS EN 50341-2-5:2017 超过AC 1 kV的架空电力线路. 丹麦国家标准方面(NNA) (基于EN 50341-1-2012)

Overhead electrical lines exceeding AC 1 kV. National Normative Aspects (NNA) for DENMARK (based on EN 50341-1:2012)

BS EN 50341-2-18:2016 超过AC 1 kV的架空电力线路. 瑞典国家标准方面(NNA) (基于EN 50341-1-2012)

Overhead electrical lines exceeding AC 1 kV. National Normative Aspects (NNA) for Sweden (based on EN 50341-1:2012)

DL/T 1693-2017 输电线路金具磨损试验方法

Test method for wear of transmission line fittings

DL/T 768.1-2017 电力金具制造质量 第1部分：可锻铸铁件

Manufacturing quality of electrical fittings - Part 1: Malleable iron castings

DB53/T 813.5-2017 配电线路故障指示器及定位系统技术规范 第5部分：系统集成

Technical Specifications for Distribution Line Fault Indicator and Locating System Part 5: System Integration

DB53/T 813.3-2017 配电线路故障指示器及定位系统技术规范 第3部分：工频信号源

Distribution line fault indicator and location system technical specification part 3: power frequency signal source

DB53/T 813.2-2017 配电线路故障指示器及定位系统技术规范 第2部分：监测终端

Distribution line fault indicator and location system technical specification part 2: monitoring terminal

DB53/T 813.1-2017 配电线路故障指示器及定位系统技术规范 第1部分：主站

Technical specifications for distribution line fault indicators and positioning systems Part 1: Master station

DB53/T 813.4-2017 配电线路故障指示器及定位系统技术规范 第4部分：远动协议

Distribution line fault indicator and positioning system technical specification part 4: telecontrol protocol

T/CSEE 0009-2016 输变电工程施工用液压绞磨技术规范

本标准规定了输变电工程施工用液压绞磨（以下简称液压绞磨）的型号，设备组成及性能参数， 技术要求，试验项目及规定，检验、试验方法及要求，标志、包装及贮存等内容。  本标准适用于液压绞磨的设计、制造、试验、验收及使用。

Technical specification for hydraulic winch for overhead transmission and transformation construction project

BS IEC 60826:2017 架空输电线路. 设计标准

Overhead transmission lines. Design criteria

T/CSEE 0011-2016 电力通信机房设计规范

本标准规定了电力通信机房的分级、机房环境、位置与建筑、装修与设备布置、空气调节、给水排水、消防、供配电及照明、机房布线、机房动力环境监控与安全防范系统等方面的要求。  本标准适用于电力调控大楼、电厂及变电站、供电所或营业厅、电力企事业单位、通信独立中继站、无线基站等通信机房的设计与建设。

Design specification for electric power communication room

T/CSEE /Z0020-2016 架空输电线路山火分布图绘制技术导则

本指导性技术文件规定了架空输电线路山火分布图绘制的一般规定、所需的基础资料、山火分级原则和山火分布图的绘制程序和修订原则。  本指导性技术文件适用于架空输电线路山火分布图的绘制。

Guidelines for thematic map drawing of wildfires distribution region along overhead transmission lines

T/CSEE 0023-2016 输电线路舞动区域分布图绘制技术导则

本标准规定了舞动区域分级标准、一般规定、基础资料、舞动区域分级方法、制图要求和舞动区域分布图修订。 本标准适用于绘制输电线路舞动区域分布图。

Technical guideline for galloping region distribution mapping of transmission lines

EN 50341-2-6:2017 超过 AC 1 kV 的架空电线 第 2-6 部分：西班牙国家规范方面（NNA）（基于 EN 50341-1:2012）

This NNA is applicable to any new line between two points, A and B, its modifications and extensions. The design and construction of overhead lines with covered conductors and voltages greater than 45 kV shall respect the same electrical clearances as of overhead lines with bare conductors of the same voltage.

Overhead electrical lines exceeding AC 1 kV - Part 2-6: National Normative Aspects (NNA) for SPAIN (based on EN 50341-1:2012)

IEC 60826:2017 RLV 架空输电线路的设计准则

Design criteria of overhead transmission lines

EN 50341-2-5:2017 超过 AC 1 kV 的架空电线 第 2-5 部分：丹麦的国家规范性方面（NNA）

Overhead electrical lines exceeding AC 1 kV - Part 2-5: National Normative Aspects (NNA) for DENMARK

IEC 60826:2017 架空输电线路.设计标准

This International Standard specifies the loading and strength requirements of overhead lines derived from reliability-based design principles. These requirements apply to lines 45 kV and above, but can also be applied to lines with a lower nominal voltage. This document also provides a framework for the preparation of national standards dealing with overhead transmission lines, using reliability concepts and employing probabilistic or semi-probabilistic methods. These national standards will need to establish the local climatic data for the use and application of this standard, in addition to other data that are country- specific. Although the design criteria in this standard apply to new lines, many concepts can be used to address the design and reliability requirements for refurbishment, upgrading and uprating of existing lines. This document does not cover the detailed design of line components such as supports, foundations, conductors or insulators strings.

Overhead transmission lines - Design criteria