电位器、可变电阻器标准-分析测试百科网

IEC 60393-6:2015 电子设备中使用的电位器第6部分:分段规格 - 表面贴装预置电位器

Potentiometers for use in electronic equipment - Part 6: Sectional specification - Surface mount preset potentiometers

ICS: 31.040.20
CCS
发布: 2015-12-14
实施

IEC 60393-5:2015 电子设备用电位器第5部分:分规范:单圈旋转线绕和非线绕低功率电位器

This part of IEC 60393 applies to single-turn rotary low-power wirewound and non-wirewound potentiometers, with a rated dissipation less than to 10 W. These potentiometers are primarily intended for use in electronic equipment. This part of IEC 60393 prescribes preferred ratings and characteristics and selects from IEC 60393-1, appropriate quality assessment procedures, tests and measuring methods. It provides general performance requirements for this type of potentiometer. This standard gives the minimum performance requirements and test severities.

Potentiometers for use in electronic equipment - Part 5: Sectional specification - Single-turn rotary low-power wirewound and non-wirewound potentiometers

ICS: 31.040.20
CCS: L14
发布: 2015-12
实施: 2015-12-16

GSO IEC 60393-3:2015 电子设备用电位器第3部分：分技术规范：精密旋转电位器

This standard is applicable to rotary precision potentiometers. These potentiometers are primarily intended for use in electronic equipment.

Potentiometers for use in electronic equipment - Part 3: Sectional specification: Rotary precision potentiometers

ICS: 31.040.20
CCS
发布: 2015-09-03
实施

GSO IEC 60393-4:2015 电子设备用电位器第4部分：分规范：单圈旋转功率电位器

This standard is applicable to single-turn rotary power potentiometers. These potentiometers are primarily intended for use in electronic equipment.

Potentiometers for use in electronic equipment - Part 4: Sectional specification: Single-turn rotary power potentiometers

ICS: 31.040.20
CCS
发布: 2015-09-03
实施

GSO IEC 60393-1:2015 电子设备中使用的电位器第1部分：通用规范

This part of IEC 60393 is applicable to all types of resistive potentiometers, including leadscrew actuated types, presets, multi-turn units, etc. to be used in electronic equipment. It establishes standard terms, inspection procedures and methods of test for use in sectional and detail specifications of electronic components for quality assessment or any other purpose. It has been mainly written, and the test methods described, to conform to the widely used single-turn rotary potentiometer with an operating shaft. For other types of potentiometers: • the angle of rotation may be several turns; • the reference to an operating shaft shall apply to any other actuating device; • the angular rotation shall be taken to mean mechanical travel of the actuating device; • a value for force shall be prescribed instead of a value for torque if the actuating device moves in a linear instead of a rotary manner. These alternative prescriptions will be found in the sectional or detail specification. When a component is constructed as a variable resistor, i.e. as a two-terminal device, the detail specification shall prescribe the modifications required in the standard tests.

Potentiometers for use in electronic equipment - Part 1: Generic specification

ICS: 31.040.20
CCS
发布: 2015-09-03
实施

GSO IEC 61051-2-2:2014 电子设备中使用的可变电阻器零件编号 (2)：可变日期淬火电阻器的行业规范

Scope is not provided for this standard

Varistors for use in electronic equipment - Part 2: Blank detail specification for zinc oxide surge suppression varistors. Assessment level E

ICS: 31.040.20
CCS
发布: 2014-12-25
实施

GSO IEC 61051-2:2014 电子设备用压敏电阻第2部分：浪涌抑制压敏电阻分规范

This standard is applicable to surge suppression varistors intended to protect electronic and other sensitive equipment from surges, operating from a d.c. supply, or an a.c. supply having a frequency not greater than 400 Hz. Varistors which are the subject of this sectional specification are not intended to give primary protection against lightning surges.

Varistors for use in electronic equipment - Part 2: Sectional specification for surge suppression varistors

ICS: 31.040.20
CCS
发布: 2014-12-25
实施

JIS C 5260-1:2014 电子设备用电位计.第1部分:通用规范

Potentiometers for use in electronic equipment -- Part 1: Generic specification

ICS: 31.040.20
CCS: L13
发布: 2014-09-22
实施

KS C IEC 61051-2-2-2013 电子设备用压敏电阻第2部分：氧化锌浪涌抑制压敏电阻空白详细规范评估等级E

Varistors for use in electronic equipment－Part 2：Blank detail specification for zinc oxide surgesuppression varistors－Assessment level E

ICS: 31.040.20
CCS
发布: 20131231
实施: 20131231

KS C IEC 60393-2-2-2013 电子设备用电位器第2部分：空白详细规范丝杠驱动和旋转预置电位器，评定等级F

Potentiometers for use in electronic equipment－Part 2：Blank detail specification－Lead－screw actuated and rotary preset potentiometers, Assessment level F

ICS: 31.040.20
CCS
发布: 20131231
实施: 20131231

KS C IEC 60393-2-1-2013 电子设备用电位器第2部分：空白详细规范丝杠驱动和旋转预置电位器，评估等级E

Potentiometers for use in electronic equipment－Part 2：Blank detail specification－Lead－screw actuated and rotary preset potentiometers, Assessment level E

ICS: 31.040.20
CCS
发布: 20131231
实施: 20131231

KS C IEC 60393-5-1-2013 电子设备用电位器第5部分：空白详细规范：单圈旋转小功率电位器，评定等级E

Potentiometers for use in electronic equipment－Part 5：Blank detail specification：Single-turn rotary low-power potentiometers, Assessment level E

ICS: 31.040.20
CCS
发布: 20131231
实施: 20131231

KS C IEC 60393-5-1:2013 电子设备用电位器第5-1部分：空白详细规范单圈旋转低功率电位器评定水平E

Potentiometers for use in electronic equipment－Part 5：Blank detail specification：Single-turn rotary low-power potentiometers, Assessment level E

ICS: 31.040.20
CCS
发布: 2013-12-31
实施

KS C 5393-42-2013 电子装置用电位器第4部分：单项标准指南：功率型单圈旋转可变电阻器评价等级F

Potentiometers for use in electronic equipment－Part 4：Blank detail specification：Single-turn rotary power potentiometers Assessment level F

ICS: 31.040.20
CCS
发布: 2013-12-31
实施

KS C IEC 60393-2-2:2013 电子设备用电位器第2部分：空白详细规范第2节丝杆驱动和旋转预调电位器 F级评定

Potentiometers for use in electronic equipment－Part 2：Blank detail specification－Lead－screw actuated and rotary preset potentiometers, Assessment level F

ICS: 31.040.20
CCS
发布: 2013-12-31
实施

KS C IEC 61051-2-2:2013 电子设备用压敏电阻器第2-2部分：氧化锌浪涌抑制型压敏电阻器的空白详细规范评定水平E