共找到 1267 条与 数据通信网 相关的标准,共 85 页
Network Functions Virtualisation (NFV) Release 3 - Protocols and Data Models - RESTful protocols specification for the Ve-Vnfm Reference Point
Requirements and capability framework of the edge-computing-enabled gateway in the Internet of things
本文件规定了2 MHz~12 MHz 低压电力线高速载波通信系统高速载波通信网络的数据链路层技术。 本文件适用于2 MHz~12 MHz 低压电力线高速载波通信系统通信单元之间的数据交换。
2MHz~12MHz Low Voltage Power Line High Speed Carrier Communication System Part 4-2: Data Link Layer Communication Protocol
本文件规定了2 MHz~12 MHz 低压电力线高速载波通信系统用电信息采集的应用层通信协议。 本文件适用于2 MHz~12 MHz 低压电力线高速载波通信系统通信单元之间的数据交换。
2MHz~12MHz Low Voltage Power Line High Speed Carrier Communication System Part 4-3: Application Layer Communication Protocol
本文件规定了2 MHz~12 MHz 低压电力线高速载波通信系统高速载波通信单元的一般要求、检验规则等要求。 本文件适用于2 MHz~12 MHz 低压电力线高速载波通信系统及通信单元相关设备的制造、检验、验收和使用。
2MHz~12MHz Low Voltage Power Line High Speed Carrier Communication System Part 2: Technical Requirements
本文件规定了2 MHz~12 MHz 低压电力线高速载波通信系统的物理层通信协议及服务。 本文件适用于2 MHz~12 MHz 低压电力线高速载波通信系统通信单元之间的数据交换。
2MHz~12MHz Low Voltage Power Line High Speed Carrier Communication System Part 4-1: Physical Layer Communication Protocol
本文件规定了2 MHz~12 MHz 低压电力线高速载波通信系统高速载波通信单元的检验项目、顺序和检测方法。 本文件适用于2 MHz~12 MHz 低压电力线高速载波通信系统高速载波通信单元的型式试验、出厂检验和验收检验。
2MHz~12MHz Low Voltage Power Line High Speed Carrier Communication System Part 3: Inspection Method
本文件规定了IPTV业务平台进行IPv4/IPv6双栈改造的平台改造概述、双栈功能要求、业务流程、接口升级要求等技术内容。 本文件适用于IPTV业务平台的改造开发与升级部署。
Technical specification on IPTV service platform based on service deployment via IPv4/IPv6 protocol
Smart Body Area Network (SmartBAN) - Measurements and modelling of SmartBAN Radio Frequency (RF) environment
Precision time protocol telecom profile for frequency synchronization
Precision time protocol telecom profile for time/phase synchronization with partial timing support from the network; Amendment 2
Precision time protocol telecom profile for phase/time synchronization with full timing support from the network; Amendment 2
Management information model for management-control components and functions
This part of IEC 61850 defines the general requirements, mainly regarding construction, design and environmental conditions for utility communication and automation IEDs and systems in power plant and substation environments. The standard references in various tables have been co
Communication networks and systems for power utility automation - Part 3: General requirements (IEC 61850-3:2013); German version EN 61850-3:2014; Corrigendum 1
Architecture for mobile/multi-access edge computing enabled content delivery networks
YANG data model technical requirements for BGP protocol
Internet service quality monitoring system interface technical requirements
Delay Tolerant Network LTP Protocol Technical Requirements
IP source address verification technical requirements framework
Delay Tolerant Network Architecture
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号