33.180.99 其他光纤设备 标准查询与下载

YD/T 778-2006 光纤配线架

本标准规定了光纤配线架（以下简称ODF）的定义、命名、要求、试验方法、检验规则和标志、包装、运输和贮存。 本标准适用于连接光缆或光通信设备的ODF。 其他类似光配线设备（如光纤配线箱）也可参照本标准执行。

Optical fiber distribution frames

NF C93-917:2006 光纤过滤器.总规范

Fibre optic filters - Generic specification.

SJ 20927-2005 光纤电压传感器通用规范

本规范规定了光纤电压传感器的要求和质量保证规定等。 本规范适用于光纤电压传感器（以下简称传感器），其它光纤传感器也可参照采用。

General specification for fibre optic voltage sensor

NF C93-804:2005 光时域反射计(OTDRs)的校准

Calibration of optical time-domain reflectometers (OTDR).

YD/T 814.2-2005 光缆接头盒 第二部分:光纤复合架空地线接头盒

YD/T 814的本部分规定了光纤复合架空地线(OPGW)光缆接头盒(以下简称接头盒)的产品分类、型号、结构、组成、技术要求、试验方法、检验规则和标志、包装、运输、贮存和安装等要求。 本部分适用于架空电力通信线路中OPGW用接头盒。

Closure for optical fibre cables Part 2:Closure for optical fibre composite overhead ground wires

YD/T 814.3-2005 光缆接头盒 第三部分:浅海光缆接头盒

YD/T 814的本部分规定了浅海光缆接头盒(以下简称接头盒)的术语和定义、分类和命名、要求、试验方法、检验规则及标志、包装、运输、贮存和安装。 本部分适用于海底光纤通信线路中浅海光缆之间的接续和维修用接头盒。

Closure for optical fiber cables Part 3:Closure for shallow water submarine optical fiber cables

BS EN 61746:2005 光学时域反射计(OTDR)的校准

This International Standard provides procedures for calibrating single-mode optical time domain reflectometers (OTDR). It only covers OTDR measurement errors and uncertainties. This standard does not cover correction of the OTDR response. In order for an OTDR to qualify as a candidate for complete calibration using this standard, it must be equipped with the following minimum feature set: a) a programmable index of refraction, or equivalent parameter; b) the ability to present a display of a trace representation, with a logarithmic power scale and a linear distance scale; c) two markers/cursors, which display the loss and distance between any two points on a trace display; d) the ability to measure absolute distance (location) from the OTDR's zero-distance reference; e) the ability to measure the displayed power level relative to a reference level (for example, the clipping level). f) the ability to evaluate the reflectance of a reflective event.

Calibration of optical time-domain reflectometers (OTDR)

IEC 61746:2005 光时域反射计(OTDRs)的校准

Provides procedures for calibrating single-mode optical time domain reflectometers (OTDR). It only covers OTDR measurement errors and uncertainties. This standard does not cover correction of the OTDR response.

Calibration of optical time-domain reflectometers (OTDR)

YD/T 814.1-2004 光缆接头盒.第一部分: 室外光缆接头盒

本部分规定了室外光缆接头盒的产品分类、型号、结构、组成、技术要求、试验方法、检验规则和包装、标志、运输、贮存等要求。 本部分适用于通信用光缆线路中架空、管道(隧道)和直埋等敷设方式安装使用的光缆接头盒。

Closure for optical fiber cables Part 1: Closure for outdoor optical fiber cables

BS EN 62149-6:2004 纤维光学有源元件和器件.性能标准.650nm、250Mbit/s塑料光纤无线电收发信机

Fibre optic active components and devices - Performance standards - 650-nm 250-Mbit/s plastic optical fibre transceivers

BS EN 62149-5:2004 纤维光学有源元件和器件.性能标准.带LD驱动及CDR IC的ATM-PON无线电收发信机

Fibre optic active components and devices - Performance standards - ATM-PON transceivers with LD driver and CDR ICs

ASTM F2350-04(2010) 选择适合于光纤系统安装的天然气管道的标准实施规程

This practice is intended to assist engineers, LDC''s and installers in determining the suitability of gas pipelines for a secondary use as carriers for optical fiber systems. It must be kept in mind that the primary use of the gas pipelines is to deliver natural gas to the end customer. Any secondary use of the system shall have minimal impact on its primary function. It is up to the engineer to decide upon the order of operations and any exceptions that may be involved in the selection process. Before the selection procedure begins, the LDC must have developed an explicit agreement authorizing an installer to place optical fiber cables within their piping system. The relevant LDC engineers should also be cognizant of how the installation of optical fiber cable will impact the future gas deliverability, operation, maintenance, and rehabilitation needs of the pipelines to be used as carriers of optical fiber systems.1.1 This practice specifically addresses the criteria for determining the suitability of natural gas pipelines for use as conduits for optical fiber cable systems, as opposed to standards for the operation and maintenance of such a system. 1.2 This practice does not apply to natural gas transmission lines. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Selection of Natural Gas Pipelines Suitable for Installation of Optical Fiber Systems

LST EN 61757-1-2003 光纤传感器 第1部分：通用规范（IEC 61757-1:1998）

Fibre optic sensors. Part 1: Generic specification (IEC 61757-1:1998)

KS C IEC 61757-1-2003(2023) 光纤传感器-第1部分:产品规格

Fiber Optic Sensors - Part 1: Item Specifications

KS C IEC 61757-1:2003 纤维光学传感器.第1部分:总规范

이 규격은 일반적인 광섬유 센서의 응용와 관련 있는 부품, 하부 조립품 등을 다루는 일

Fiber optics sensors ? Part 1：Generic specification

KS C IEC 61757-1-2003(2018) 光纤传感器 - 第1部分:总规范

Fiber Optic Sensors - Part 1: Item Specifications

YD/T 1272.1-2003 光纤活动连接器 第1部分:LC型

Optical fiber connector Part 1:type LC

ITU-T L.156-2003 光缆气助敷设

Air-assisted installation of optical fibre cables

IEC 62148-9/COR1:2003 纤维光学有源元件和器件.包装和接口标准.第9部分:SFF MU双工10针无线电收发信机

This is Technical Corrigendum 1 to IEC 62148-9-2003 (Fibre optic active components and devices -Package and interface standards - Part 9: SFF MU duplex 10-pin transceivers )

Fibre optic active components and devices - Package and interface standards - Part 9: SFF MU duplex 10-pin transceivers

ITU-T L.153-2003 微沟安装技术

Mini-trench installation technique