35.180 IT终端和其他外围设备 标准查询与下载

JIS B 9527:1998 页式打印机的规范格式

Format of specification for page printers

YD/T 945-1998 公用电话交换网和点对点二线专线电路上使用的数据信号速率高达 33600 bit/s 的调制解调器

本标准规定了在公用电话交换网(PSTN)和点对点二线专线电路上使用的数据信号速率高达33600bit/s的调制解调器的技术要求。 本标准是研制、设计和生产上述音频调制解调器的技术标准。是制定上述音频调制解调器技术规范的主要依据之一。

Modem operating at data signalling rates of up to 33600 bit/s for use on the general switched telephone network and on leased point - to - point 2 - wire telephone - type circuits

ASTM F1942-98(2010) 创建测定喷墨打印机用成像供给的油墨成品的试验目标的标准实施规程

Test targets where the percentage of area coverage has been predetermined are not readily available from commercial sources. Moreover, it is beyond the ability of most users to verify if indeed, the commercially-available test targets contain the advertised area coverage. This procedure allows the user to easily create test targets, using commercially available PC software, which can be easily verified for percentage of area coverage and can provide reproducible interlaboratory results.1.1 This practice describes a method for creating test targets containing varying percentages of area coverage for use in determining the yield of the supplies used by liquid and solid ink jet printers. 1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard may involve hazardous materials, operations and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine limitations prior to use.

Standard Practice for Creating Test Targets for Determining the Ink Yield of the Imaging Supplies Used in Ink Jet Printers

YD/T 929-1997 19.2kbit/s 以下速率基带调制解调器进网技术要求及检测方法

本标准规定了专线电路上使用的19.2kbit/s以下速率基带调制解调器(不包括长线驱动器)的进网技术要求及检测方法。 本标准适用于专线电路止使用的19.2kbit/s以卜速率基带调制解调器(不包括长线V动器)的研制、生产、检测和维护。

Technical requirments and tsting methods for up to 19.2kbit/s baseband modem connected to the telecommunication network

DD ENV 12646-1997 条形码.条形码的扫描仪和译码器的试验规范

Bar coding. Test specifications for bar code scanners and decoders

DD ENV 12647-1997 条形码.条形码验证机的试验规范

Bar coding. Test specifications for bar code verifiers

DD ENV 12648-1997 条形码.条形码打印机的试验规范

Bar coding. Test specifications for bar code printers

SJ 11115-1997 光学标记阅读机通用规范

Generic specification for optical mark reader

DS/ETS 300492:1997 公共电话交换网（PSTN） 每秒 14400、12000、9600、7200 和 4800 位双工调制解调器的 II 类规范，已标准化用于 PSTN

This European Telecommunication Standard (ETS) specifies the technical characteristics required for end-to-end interworking over the Public Switched Telephone Network (PSTN) of 14400, 12000, 9600, 7200 and 4800 bit/s duplex modems standardized for use over the PSTN, in accordance with CCITT Recommendation V.32 bis [1].

Public Switched Telephone Network (PSTN) - Category II specification for 14400, 12000, 9600, 7200 and 4800 bits per second duplex modems standardized for use on the PSTN

DS/ETS 300117:1997 公共电话交换网（PSTN） 每秒 2400 位双工调制解调器的 II 类规范，已标准化用于 PSTN

This ETS contains the technical characteristics required for end-to-end interworking over the Public Switched Telephone Network (PSTN) of 2400 bits per second (bit/s) duplex modems standardized for use over the PSTN, in accordance with CCITT Recommendation V.22bis [2]. The term ""modem"" in the context of this ETS includes all physical implementation practices for voice band modem, which is conductively connected to the PSTN.

Public Switched Telephone Network (PSTN) - Category II specification for 2400 bits per second duplex modems standardized for use on the PSTN

DS/ETS 300116:1997 公共电话交换网（PSTN） 每秒 1200 位双工调制解调器的 II 类规范，已标准化用于 PSTN

This ETS contains the technical characteristics required for end-to-end interworking over the Public Switched Telephone Network (PSTN) of 1200 bits per second (bit/s) duplex modems standardized for use over the PSTN, in accordance with CCITT Recommendation V.22 [1]. NOTE: CCITT Recommendation V.22 [1] also describes a method of transmitting data at 600 bit/s. This ETS specifies the characteristics to be met by such modems and, if requested by the applicant, this feature can also be tested against the specifications.

Public Switched Telephone Network (PSTN) - Category II specification for 1200 bits per second duplex modems standardized for use on the PSTN

DS/ETS 300118:1997 公共电话交换网（PSTN） 每秒 1200 位半双工和每秒 1200/75 位非对称双工调制解调器的 II 类规范，已标准化用于 PSTN

This ETS contains the technical characteristics required for end-to-end interworking over the Public Switched Telephone Network (PSTN) of modems supporting: - half duplex operation over the PSTN at 1200 bit/s, and or - asymmetrical duplex operation over the PSTN at 1200/75 bit/s standardized for use over the PSTN, in accordance with CCITT Recommendation V.23 [3].

Public Switched Telephone Network (PSTN) - Category II specification for 1200 bits per second half duplex and 1200/75 bits per second asymmetrical duplex modems standardized for use on the PSTN

DS/ETS 300114:1997 公共电话交换网（PSTN） 为在 PSTN 上使用而标准化的调制解调器的基本 I 类和 II 类规范

This second edition European Telecommunication Standard (ETS) contains the technical characteristics required for end-to-end interworking over the Public Switched Telephone Network (PSTN). Clauses of this ETS also contain Category II specifications defined for certain features which may be provided by some modems, but the requirements in these parts are only applicable when invoked by a modem specific ETS.

Public Switched Telephone Network (PSTN) - Basic Category I and Category II specifications for modems standardized for use on the PSTN

DS/ETS 300002:1997 公共电话交换网（PSTN） 每秒 9600 或 4800 位双工调制解调器的 II 类规范，已标准化用于 PSTN

This ETS specifies the technical characteristics required for end-to-end interworking over the Public Switched Telephone Network (PSTN) of 9600 bits or 4800 bits modems standardized for use over the PSTN, in accordance with CCITT Recommendation V.32 [2]. The objective of this specification, the application of which is entirely voluntary, is to provide the users with an added degree of assurance that modems in compliance with this specification can interwork with each other, under most network conditions.

Public Switched Telephone Network (PSTN) - Category II specification for 9600 or 4800 bits per second duplex modems standardized for use on the PSTN

DS/ETS 300075/A1:1997 终端设备（TE） 可处理数据 文件传输

The Videotex processable data facility specified in this ETS is intended to be used for data file transfer. These files may contain software or other file types. This ETS may be used to download files from the host to the terminal. It may also be used for transferring files between two end systems in both directions, all the operations then being performed under the control of one or the other system depending on a preliminary negotiation.

Terminal Equipment (TE) - Processable data - File transfer

CNS 12340-1997 终端机检验法

本标准规定终端机之检验方法。

Method of test for terminal

AIIM TR15-1997 图像捕捉文件的准备,规划处理

This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.

Planning Considerations Addressing Preparation of Documents for Image Capture

JIS B 3412:1996 绘图仪.特别条款

Plotters -- Specified items

YD/T 588-1996 电话网上音频调制解调器承受传输损伤能力的基本要求

本标准规定了在公用电话网上使用的音频调制解调器承受电路传输损伤能力的基木要求。 本标准是各类音频调制解调器进电话网检测的技术依据之一。

Basic requirement for ability of telephone online audio modem to withstand transmission impairments

ARINC 644A BOOK-1996 便携式多用途接入终端

Portable Multi-Purpose Access Terminal (PMAT)

Portable Multi-Purpose Access Terminal (PMAT)