共找到 486 条与 垫圈和其他锁紧元件 相关的标准,共 33 页
Tapered Washers for Axial Clamping
Locating pins for rack type locators
Rotary guide bush for needle roller high speed reaming
Gear sleeve for rack type positioner
One vertical slot square backing plate
One vertical groove rectangular backing plate
This standard specifies the characteristics of solid rivets, with 100" countersunk normal head, in titanium alloy Ti 443 Cb, with aluminium pigmented coating, metric series, for maximum operating temperature 31 5 OC.
Aerospace Series Washers, Concave Issue P 1
This industry standard covers *e general requirements for cermet or metal film type resistor networks, prhrily intended for incorporation into electronic circuits
Leaded Surface Mount Resistor Networks Fixed Film
The purpose of this test is to measure the resolution capability of a cathode ray display tube.Raster scan is the most widely used method of displaying information on a CRT.
Line Profile Measurements in Shadow Mask and Other Structured Screen Cathode Ray Tubes
This standard specifies methods for measuring resistance unbalance for digital data transmission cable. It shall be used together with EN 3475-100.
Aerospace Series Washers, Lock for Flight Control Rods Dimensions Issue P 1
This standard specifies the characteristics of single-pole circuit breakers, temperature compensated with a rated current from 1 A to 25 A, used in aircraft on-board circuits at a temperature between – 55 °C and 125 °C and at a maximum altitude of Z = 22 000 m. These circuits breakers are operated by a push-pull type single push button (actuator), with delayed action "trip-free" tripping with a polarized signal contact which is open when main contacts are closed, and inversely. They will continue to function up to the short-circuit current.
Washers, Lock, with Radial Serrations, in Corrosion Resisting Steel, Cadmium Plated Dimensions Aerospace Series Edition 1
Support gasket H=0.6~2.1mm
本标准系根据我部飞机制造厂高强度合金钢筒形零件生产实践经验编制的。其基本尺寸系列为直径50~150毫米共35种深孔镗刀,应优先选用。为扩大该标准的使用范围,考虑工序间加工尺寸的需要,在基本尺寸系列的基础上,采用加垫片的简单方法编制了辅助尺寸系列,用来加工直径51~149毫米直径范围内任何整数的直径尺寸,可供选用。对易损件也被单独列为标准,可直接订货。 本标准适用于在深孔机床设备或改装的深孔机床设备上进行粗加工及半精加工。
Gasket b=1~1.5mm
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号