53.020.20 起重机 标准查询与下载

KS B ISO 4301-2:2022 起重机.分类.第2部分:移动式起重机

Cranes — Classification — Part 2: Mobile cranes

KS B ISO 4301-2-2022 起重机.分类.第2部分:移动式起重机

Cranes — Classification — Part 2: Mobile cranes

KS B ISO 12480-3:2022 起重机.安全使用.第3部分:塔式起重机

Cranes — Safe use — Part 3: Tower cranes

T/SDAS 423-2022 自动化轨道式集装箱门式起重机远程控制系统测试规范

本文件规定了自动化轨道式集装箱门式起重机远程控制系统的测试准备、测试内容与方法和测试记录与判定。 本文件适用于自动化轨道式集装箱门式起重机远程控制系统的测试。

Test specification for remote control system of automatic rail-mounted container gantry crane

T/CPHA 10-2022 港口门座起重机结构健康监测、检测与诊断

规定了港口门座起重机结构的健康监测、检测、健康状态诊断方法和诊断报告要求。

Structural health monitoring, detection and diagnosis of port portal crane

22/30441562 DC BS EN 14492-2:2019 AMD1 起重机 动力驱动绞车和提升机 第 2 部分：动力驱动提升机

BS EN 14492-2:2019 AMD1. Cranes. Power driven winches and hoists - Part 2. Power driven hoists

ASME B30.23-2022 人员升降系统

Within the general scope defined in B30 Standard Introduction, Section I , ASME B30.2 3 may apply to hoisting and accessory equipment covered within certain volumes of the ASME B3 0 Standard, which is used to lift, lower, hold, or transport personnel in a platform, bywire rope or chain, fromhoist equipment, or by a platform that is mounted on a boom of the hoist equipment. The lifting of personnel is not allowed using some ASME B30 Standard equipment. The ASME B30 Standard addressing the hoisting equipment to be used shall be consulted for the applicabi lity of the ASME B30.23 volume. 在 B30 标准简介第 I 节定义的一般范围内，ASME B30.2 3 可能适用于 ASME B3 0 标准某些体积内涵盖的起重和附件设备，用于提升、降低、固定或运输平台、钢丝绳或链条、葫芦设备或安装在葫芦设备吊臂上的平台中的人员。不允许使用某些ASME B30标准设备提升人员。ASME B30 卷的适用性应参考 ASME B30 标准，以应对要使用的起重设备进行参考。

Personnel Lifting Systems

DB14/T 2470-2022 在用起重机械无损检测 通用技术条件

本文件规定了在用桥式和门式起重机械无损检测 通用技术条件，包括检测方法和验收要求。 本文件适用于在用桥式和门式起重机械的无损检测，其他在用起重机械的无损检测亦可参照执行。

General technical conditions for non-destructive testing of lifting machinery in use

22/30440249 DC BS EN 13001-3-1 起重机 总体设计 第 3-1 部分 钢结构极限状态及证明能力

BS EN 13001-3-1. Cranes. General design - Part 3-1. Limit states and proof competence of steel structure

GSO ISO 8686-3:2022 起重机 载荷和载荷组合的设计原则 第3部分：塔式起重机

This document establishes the application of ISO 8686-1 to tower cranes for construction work as defined in ISO 4306-3, and gives specific requirements and values for factors to be used at the structural calculation. Tower cranes for construction work are exclusively equipped with a hook as the load-handling device. For tower cranes intended to be used for other purposes and/or with other load-handling devices, other values can be necessary according to the tower crane usage specification.

Cranes — Design principles for loads and load combinations — Part 3: Tower cranes

GSO ISO 9927-5:2022 起重机 检查 第5部分：桥式和龙门式起重机 包括门式和半门式起重机及其支撑结构

ISO 9927-5:2017 specifies the inspections to be carried out on bridge and gantry cranes. It is intended to be used in conjunction with ISO 9927‑1. It does not cover inspection prior to the first use of a bridge or gantry crane.

Cranes — Inspections — Part 5: Bridge and gantry cranes, including portal and semi-portal cranes and their supporting structures

ASME B30.16-2022 悬挂式和固定式葫芦

Volume B30.16 includes provisions that apply to the construction, installation, operation, inspection, testing, and maintenance of overhead underhung and stationary hoists, including hand-chain-operated, electric-powered, and air-powered chain and wire rope hoists used for, but not limited to, vertical lifting and lowering of freely suspended, unguided loads that consist of equipment and materials (see Figures 16-0.1-1 through 16-0.1-6). Requirements for a hoist that is used for a special purpose, such as, but not limited to, tensioning a load, nonvertical lifting service, lifting a guided load, lifting personnel, or drawing both the load and the hoist up or down the load chain or rope when the hoist is attached to the load, are not included in this Volume. B30.16 卷包括适用于高架悬挂式和固定式葫芦的建造、安装、操作、检查、测试和维护的规定，包括手链操作、电动和气动链条和钢丝绳葫芦，用于但不限于垂直提升和降低由设备和材料组成的自由悬挂、非导向负载（见图 16-0.1-1 至 16-0.1-6）。 本卷不包括对用于特殊用途的葫芦的要求，例如但不限于张紧负载、非垂直起重服务、提升引导负载、起重人员，或在葫芦连接到负载时将负载和葫芦拉上或拉下负载链或绳索。

Underhung and Stationary Hoists

T/ZZB 2691-2022 塔式起重机司机室

本文件规定了塔式起重机司机室的术语和定义、基本要求、技术要求、试验方法、检验规则、标志、包装、运输与储存以及质量承诺。 本文件适用于塔式起重司机室（以下简称司机室），但不包括电控、卫生间等设备。

Tower crane cabin

DB4403/T 233-2022 起重机械维护保养规范

本文件适用于纳入特种设备安全监督管理的起重机械，不适用于房屋建筑工地和市政工程工地所用的起重机械。

Lifting machinery maintenance specification

DB41/T 2261-2022 垂直循环类机械式停车设备油漆涂装工艺

Paint coating process of vertical circulation mechanical parking equipment

T/CCMA 0127-2022 塔式起重机测力环式起重量限制器

本文件规定了塔式起重机测力环式起重量限制器（以下简称测力环起重量限制器）的型号、技术要求、试验方法、标志、包装、运输及贮存等。 本文件适用于测力环起重量限制器。

Load measuring ring type lifting limiter of tower crane

T/CCMA 0128-2022 塔式起重机弓形起重力矩限制器

本文件规定了塔式起重机弓形起重力矩限制器（以下简称弓形起重力矩限制器）的型号、技术要求、试验、检验规则、标志、包装、运输及贮存等。 本文件适用于弓形起重力矩限制器。

Cambered-plate type moment limiter of tower crane

T/CCMA 0126-2022 汽车起重机 操控性

本文件规定了汽车起重机（以下简称起重机）的起升机构、变幅机构、回转机构、伸缩机构操控性的技术要求、试验方法及评价方法、评价指标。 本文件适用于开式液控操纵系统的汽车起重机，其它操纵形式的起重机可参照执行。

Truck crane—Controllability

BS 7121-2-7:2012+A2:2022 起重机安全使用操作规范 检查、维护和彻底检查 桥式起重机和龙门起重机 包括轻型起重机系统

  What is BS 7121-2-7:2012+A2:2022 -  Safe use of cranes  about? This is a sub-part of the second British Standard in a four-part series that gives guidance on the safe use of cranes. BS 7121-2-7:2012+A2:2022 covers overhead travelling cranes and includes a second amendment that was made to resolve a conflict between it and two revised European standards. Who is BS 7121-2-7:2012+A2:2022 -  Safe use of cranes  for? Those responsible for managing the maintenance, inspection and thorough examination of cranes in plant and equipment hire, plant and equipment maintenance, and insurance, typically: Health and safety advisors and specialists Crane maintenance and inspection specialists Professional bodies for construction management Specialist consulting engineers Construction companies Consultancy practices Training organizations and providers Plant hire companies Trade bodies Insurers What does BS 7121-2-7:2012+A2:2022 -  Safe use of cranes  cover? It gives recommendations for the pre-use checks, in-service inspection, maintenance, thorough examination (in service and following exceptional circumstances) and supplementary testing of overhead travelling cranes, including portal and semi-portal cranes, hoists, and their supporting structures. NOTE: This sub-part of BS 7121-2 does not ...

Code of practice for the safe use of cranes - Inspection, maintenance and thorough examination. Bridge and gantry cranes, including light crane systems

JIS B 8833-1:2022 起重机 载荷和载荷组合的设计原则 第1部分：总则

Cranes -- Design principles for loads and load combinations -- Part 1: General