53.020.30 起重设备附件 标准查询与下载

KS B ISO 1834-2003(2018) 리프트용 짧은 링크 체인 - 허용치의 일반조건

Short link chains for lifts - general conditions of tolerances

KS B ISO 1834:2003 起重用短环链.公差值的一般条件

이 규격은 국제 표준 허용값의 일반 조건에서 전기 용접을 한 들어올리는 용도의 원형 철

Short link chain for lifting purposes－General conditions of acceptance

KS B ISO 1834-2003(2023) 用于提升的短链接链-允许值的一般条件

Short link chains for lifts - general conditions of tolerances

EN 13414-1:2003 钢丝绳吊索的安全性.第1部分:通用提升用吊索;包含修改件 A2-2008

This European Standard specifies the construction requirements; calculation of WLL; verification; certification and marking of steel wire rope slings for general lifting service. It covers single-; two-; three- and four-leg slings; with ferrule-secured or spliced eye terminations and spliced or ferrule-secured endless slings made from 8 mm to 60 mm diameter 6 strand ordinary lay steel wire rope with fibre or steel core and 8 strand ordinary lay steel wire rope with a steel core conforming to EN 12385-4. The standard assumes a working coefficient (factor of safety) of five.This standard does not cover slings for single use; i.e. one trip slings; having a working coefficient lower than 5.This standard does not cover matched sets of slings with spliced eyes.This document is not applicable to slings which are manufactured before the date of publication of this document by CEN. The hazards covered byThis part of EN 13414 are identified in clause 4. These wire rope slings are intended for lifting objects; materials or goods. Guidance on the information which should be provided with an enquiry or order is given in annex A. NOTE Information for use and maintenance; including operating temperature ranges; is given in Part 2 of this standard.

Steel wire rope slings - Safety - Part 1: Slings for general lifting service (Incorporates Amendment A2: 2008)

BS EN 13414-1:2003+A2:2008 钢丝绳吊索.安全性.第1部分:通用提升吊索

This European Standard specifies the construction requirements, calculation of WLL, verification, certification and marking of steel wire rope slings for general lifting service. It covers single-, two-, three- and four-leg slings, with ferrule-secured or spliced eye terminations and spliced or ferrule-secured endless slings made from 8 mm to 60 mm diameter 6 strand ordinary lay steel wire rope with fibre or steel core and 8 strand ordinary lay steel wire rope with a steel core conforming to EN 12385-4. The standard assumes a working coefficient (factor of safety) of five. This standard does not cover slings for single use, i.e. one trip slings, having a working coefficient lower than 5." This standard does not cover matched sets of slings with spliced eyes. This document is not applicable to slings which are manufactured before the date of publication of this document by CEN. The hazards covered by this Part of EN 13414 are identified in clause 4. These wire rope slings are intended for lifting objects, materials or goods. Guidance on the information which should be provided with an enquiry or order is given in annex A. NOTE Information for use and maintenance, including operating temperature ranges, is given in Part 2 of this standard.

Steel wire rope slings — Safety — Part 1: Slings for general lifting service

BS EN 13414-1:2003 钢丝绳吊索.安全.通用提升吊索

This European Standard specifies the construction requirements, calculation of WLL, verification, certification and marking of steel wire rope slings for general lifting service. It covers single-, two-, three- and four-leg slings, with ferrule-secured or spliced eye terminations and spliced or ferrule-secured endless slings made from 8 mm to 60 mm diameter 6 strand ordinary lay steel wire rope with fibre or steel core and 8 strand ordinary lay steel wire rope with a steel core conforming to EN 12385-4. The standard assumes a working coefficient (factor of safety) of five. This standard does not cover slings for single use, i.e. one trip slings. This standard does not cover matched sets of slings with spliced eyes. This document is not applicable to slings which are manufactured before the date of publication of this document by CEN. The hazards covered by this Part of EN 13414 are identified in clause 4. These wire rope slings are intended for lifting objects, materials or goods. Guidance on the information which should be provided with an enquiry or order is given in annex A. NOTE Information for use and maintenance, including operating temperature ranges, is given in Part 2 of this standard.

Steel wire rope slings - Safety - Slings for general lifting service

BS EN 13155:2003+A2:2009 起重机.安全性.非固定式装载升降机

Cranes - Safety - Non-fixed load lifting attachments

BS EN 13155:2003 起重机.安全.非固定式荷载提升附属装置

This European Standard specifies safety requirements for the following non-fixed load lifting attachments for cranes, hoists and manually controlled load manipulating devices: — plate clamps; — vacuum lifters; — self priming, — non-self priming (pump, venturi, turbine); — electric lifting magnets (battery fed and main-fed); — permanent lifting magnets; — electro-permanent lifting magnets; — lifting beams; — C-hooks; — lifting forks; — clamps; defined in clause 3. This standard does not specify the additional requirements for: — non fixed load lifting attachments in direct contact with foodstuffs or Pharmaceuticals requiring a high level of cleanliness for hygiene reasons; — hazards resulting from handling specific hazardous materials (e.g. explosives, hot molten masses, radiating materials); — hazards caused by operation in an explosive atmosphere; — hazards caused by noise; — electrical hazards; — hazards due to hydraulic and pneumatic components. This standard does not cover the hazards related to mechanical strength of structural elements of attachments designed for more than 20 000 lifting cycles. NOTE The coefficient of utilization specified in clause 5.1.1 ensures that no fatigue verification is needed for less than 20 000 cycles. This is in accordance with the well accepted calculation codes e.g. FEM 1001. This standard does not cover attachments intended to lift above people. This standard does not cover slings, ladles, expanding mandrels, buckets, grabs, or grab buckets. The hazards covered by this European Standard are identified in clause 4. This European Standard does not cover hazards related to the lifting of persons. This European Standard is applicable to non-fixed load lifting attachments which are manufactured after the date of approval by CEN of this standard.

Cranes - Safety - Non-fixed load lifting attachments

NF E52-141:2003 一般提升用锻造钢钩环.D形钩环和弓形钩环.6级.安全性

Forged steel shackles for general lifting purposes - Dee shackles and bow schakles - Grade 6 - Safety.

EN 13155:2003 起重机.非固定式荷载提升附属装置.包含修改件A2-2009

This European Standard specifies safety requirements for the following non-fixed load lifting attachments for

Cranes - Safety - Non-fixed load lifting attachments (Incorporates Amendment A2: 2009)

SANS 1824:2003 单轨小车

Specifies the requirements for beam trolleys (crawls) for lifting equipment of combined beam trolley and chain block, manually propelled beam trolleys, mechanically propelled beam trolleys, and power driven beam trolleys.

Beam trolleys (crawls)

EN 13889:2003 一般提升用锻钢带销U形环.固定D形环钩和弓形环钩.6级.安全要求.包含修改件A1-2008

This European Standard specifies requirements for forged steel Dee and bow shackles of grade 6 for general lifting purposes in a range of working load limits 0,5 t to 25 t maximum. This standard applies only to those shackles with threaded pins. Annex A gives information on the safe use of shackles, annex B gives information on types of pins, and annex C gives an example of a designation system for forged steel shackles. The hazards covered are identified in clause 4.

Forged steel shackles for general lifting purposes - Dee shackles and bow shackles - Grade 6 - Safety (Incorporates Amendment A1: 2008)

ISO 4308-1:2003 起重机和提升设备.钢丝绳的选用.第1部分:总则

This part of ISO 4308 specifies two methods for the selection of wire rope to be used on lifting appliances as designated in ISO 4306-1, one based on the value of the rope selection factor C and the other based on the value of the coefficient of utilization Zp This part of ISO 4308 establishes the minimum requirements for acceptable strength and performance levels of wire ropes with respect to the design, application and maintenance of the lifting appliance. This part of ISO 4308-1 establishes the minimum requirements for the diameters of drums and sheaves that are to be associated with the selected wire rope. A non-exhaustive list of types of lifting appliance to which this part of ISO 4308 is applicable is given in Annex A. Annex B provides some examples of rope selection. Annex C gives factors, additional to those mentioned above, which may need consideration when selecting the wire rope. Annex D specifies the selection method for the diameter of the compensating sheave when used in relation to hoists.

Cranes and lifting appliances - Selection of wire ropes - Part 1: General

JIS B 8807:2003 起重机滑轮

この規格は，クレーン及び移動式クレーン()に用いるシーブについて規定する。ただし，エコライザシーブは除く。

Cranes-sheave

ASME B30.9-2003 悬带

Volume B30.9 includes provisions that apply to the fabrication, attachment, use, inspection, and maintenance of slings used for lifting purposes, used in conjunction with equipment described in other volumes of the B30 Standard, except B30.1 and except as specified in B30.12 and B30.23. Slings are not mentioned in B30.1 and are restricted by certain provisions in B30.12 and B30.23. Slings fabricated from alloy steel chain, wire rope, metal mesh, synthetic fiber rope, synthetic webbing, and synthetic fiber yarns in a protective cover(s) are addressed. Slings fabricated from other materials or constructions other than those detailed in this volume shall be used only in accordance with the recommendations of the sling manufacturer or a qualified person.

Slings

SANS 1594:2003 手动操作的起重机

This standard specifies requirements for chain blocks that require the use of a hand chain for hoisting and lowering.

Manually operated chain blocks

ANSI/ASME B30.9-2003 吊索

Includes provisions that apply to the fabrication, attachment, use, inspection and maintenance of slings used for lifting purposes in conjunction with equipment described in other volumes of the B30 Standard.

Slings

SANS 7592:1983 经校准的圆钢链起重链．适当使用和维护指南

Specifies the main principles for the use, inspection, in-service testing and maintenance of calibrated round steel link chains operating over chain wheels. The principal applications include manual and power driven hoists.

Calibrated round steel link lifting chains - Guidelines to proper use and maintenance

ASME B29.24-2002 架空提升机的滚子链

This Standard covers specialized roller chains that are designed specifically as load chains for use in overhead hoists.

Roller Load Chains for Overhead Hoists

ANSI/ASME B29.24M-2002 高架提升机滚子载重链

Covers specialized roller chains that are designed specifically as load chains for use in overhead hoists.

Roller Load Chains for Overhead Hoists