59.100.20 碳纤维材料 标准查询与下载

JB/T 6647-1993 碳化物中总碳含量的测定.气体容量法

本标准规定了用气体容量法测定碳化物总碳含量的方法。 本标准测定碳化物总碳含量范围为5.0%～21.0%。

Determination of total carbon content in carbide Gas volumetric method

BS 7658-2:1993 碳纤维.第2部分:线性密度的测定方法

This International Standard specifies a method for determining the linear density (mass per unit length) of carbon fibre yarns. When the determination of the linear density is car-ried out on sized fibre, a correction shall be made by calculation based on the size content (see 10.2). The linear density determined by the method speci-fied in this International Standard does not consider the influence of twist in the yarn.

Carbon fibre - Method for determination of linear density

ISO 10119:1992 碳纤维.密度测定

Carbon fibre; determination of density

GOST 27939-1988 牌号为ЗПАН的碳素纤维构成的材料.技术条件

Настоящий стандарт распространяется на композиционный материал углеволокнит марки ЭПАН, представляющий собой термореактивную композиц

Carbonfibre composite EPAN. Specifications

NF T25-103:1987 碳纤维.线性密度的测定

Carbon fibers. Determination of linear density.

DIN 65147-2:1987 航空航天.碳纤维.碳纤维长丝织物.技术规范

Aerospace; carbon fibres; fabric of carbon fibre filament yarn; technical specification

NF T25-101:1986 碳纤维.碳纤维浸渍长丝纱拉伸试验

CARBON FIBERS. CARBON FIBRE FILAMENT YARN TENSILE TEST.

ASTM D4102-82(2015) 碳纤维的耐热氧化性的标准试验方法

5.1 The test is used to determine the oxidative resistances of carbon fibers as a means of selecting the most stable fibers for incorporation in high-temperature fiber-reinforced composite systems. It can be used for quality control, material specification, and for research and development of improved carbon fibers. Factors that influence the oxidative resistance and should be reported are fiber identification, precursor type, fiber modulus, and any information on impurities, particularly metals. Also note that the presence of finish on the fiber can affect the oxidative resistance, and thus, alternative specimen preparations that enable the evaluation of finish effects are included. 1.1 This test method covers the apparatus and procedure for the determination of the weight loss of carbon fibers, exposed to ambient hot air, as a means of characterizing their oxidative resistance. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units which are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard information, see Section 8.

Standard Test Method for Thermal Oxidative Resistance of Carbon Fibers