59.100.30 聚芳基酰胺材料 标准查询与下载
共找到 98 条与 聚芳基酰胺材料 相关的标准，共 7 页
GB/T 23914的本部分规定了合成纤维栓紧带总成（以下简称为栓紧带）的风险提示、要求、试验方法和检验规则、试验报告、标识、包装、运输和贮存等。 本部分规定的最大操作力为500N的手动拉紧装置，适用于装载物的栓紧、捆绑及安全固定。 本部分不适用于吊装用合成纤维栓紧带。
Load restraint assemblies on road vehicles.Safety.Part 2:Web lashing assembly made from synthetic fibres
- ICS
- 59.100.30
- CCS
- R12;W52
- 发布
- 2009-06-04
- 实施
- 2010-01-01
Standard for inspection of synthetic fiber filament yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2022-12-12
- 实施
1.1 This test method covers the tensile testing of aramid paper with thickness less than 1 mm. This test method includes testing procedures only and includes no specifications or tolerances. 1.2 The procedures given in this test method are for use with computer-controlled constant-rate-of-elongation tensile testing equipment. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Tensile Testing of Aramid Paper
- ICS
- 59.100.30
- CCS
- 发布
- 2022-11-01
- 实施
Test method for tensile strength and elongation of filament yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2022-08-24
- 实施
Test method for resin finished textiles
- ICS
- 59.100.30
- CCS
- 发布
- 2021-07-01
- 实施
1.1 This test method covers the determination of the volatiles content, in mass percent of composite material prepregs. This standard focuses on composites with thermosetting resins, which tend to lose a few percent of the matrix mass when heated due to loss of both retained water and low molecular weight matrix constituents that volatilize during heating. 1.2 Use of this test method is limited to maximum temperature of circulating air ovens, approximately 300 °C (572 °F). 1.3 Use of this test method is limited to temperatures below which the matrix flows from the reinforcement. 1.4 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Volatiles Content of Composite Material Prepreg
- ICS
- 59.100.30
- CCS
- 发布
- 2020-09-01
- 实施
Test method for elastic recovery percentage of elongation of rayon filament yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2019-12-17
- 实施
Test method for crimp recovery of stretch filament yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2019-12-17
- 实施
Test method for titanium dioxide content of rayon yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2019-12-17
- 实施
Measuring method for average degree of polymerization of rayon yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2019-12-17
- 实施
Test method for fineness of stretch filament yarn
- ICS
- 59.100.30
- CCS
- 发布
- 2019-12-17
- 实施
Test method for resin content in resin finished textiles
- ICS
- 59.100.30
- CCS
- 发布
- 2019-11-27
- 实施
