71.100.20 工业气体 标准查询与下载
共找到 540 条与 工业气体 相关的标准，共 36 页
本标准规定了低温液体贮运设备的安全要求和措施、事故处理。 本标准适用于氧、氮、氩低温液体容器及槽车的低温液体贮运设备。 本标准对于二氧化碳液体贮运设备可参照使用。
Storage and shipping device for low temperature liquid - Safety use manual
- ICS
- 71.100.20
- CCS
- J76
- 发布
- 1997-03-04
- 实施
- 1997-10-01
本标准规定了工业用压滤式水电解制氢设备的产品分类、基本参数、型号、技术要求、试验方法、检验规则及标志、包装、运输和贮存。 本标准适用于工业用压滤式水电解制氢设备。 注：本标准中的氢、氧气体体积为标准状态，即0℃，101.325 kPa(绝压)状态下的气体体积，单位为m3
Water electrolysis hydrogen production equipment
- ICS
- 71.100.20
- CCS
- J76
- 发布
- 1996-09-03
- 实施
- 1997-07-01
Describes test methods for the sampling and quantitative analysis of aerosol oil content and liquid oil (excluding oil vapour) normally present in the air discharged from compressors and compressed air systems. Gives detailed instructions on the equipment to be used and the test methods to be employed for the measurement of oil content. Applies to compressed air systems up to 30 bar working pressure, but excluding systems intended for medical use or for direct breathing.
Compressed air for general use - Part 2: Test methods for aerosol oil content
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1996-06
- 实施
Describes a test method for the determination of the toxicity of a gas or gas mixture in order to eliminate difficulties involved in the application of ISO 5145. A calculation method enables the toxicity of gas mixtures to be determined in the absence of valid experimental data.
Determination of toxicity of a gas or gas mixture
- ICS
- 71.100.20
- CCS
- E46
- 发布
- 1995-12
- 实施
Gives a complete list of the corrosiveness for pure gases and a calculation method relating to the corrosiveness of gas mixtures which is applicable in the absence of experimental data to each of their components.
Determination of tissue corrosiveness of a gas or gas mixture
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1995-11
- 实施
本标准规定了医用氧化亚氮的技术要求、试验方法、检验规则、包装、标志、贮存及运输。 本标准适用于硝酸铵热分解工艺制取的氧化亚氮。用于手术麻醉、镇痛等医疗目的。 分子式：N|(2)O 相对分子质量：44.01(按1991年国际相对原子质量)
Medical Nitrous Oxide
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1995-04-05
- 实施
- 1996-01-01
本标准规定了天然气分离与液化设备的术语。 本标准适用于制、修订标准，编制技术文件，绘制图样，编写和翻译专业手册、教材及书刊。
Natural gas separation and LPG equipment - Terminology
- ICS
- 71.100.20
- CCS
- J76
- 发布
- 1994-12-09
- 实施
- 1995-10-01
This Gulf standard is concerned with the method for determination of chlorine residue on evaporation expressed as a percentage by mass of the liquid chlorine.
Methods of test for liquid chlorine - determination of evaporation residue.
- ICS
- 71.100.20
- CCS
- 发布
- 1994-11-16
- 实施
This gulf standard is concerned with the methods of test for dissolved acetylene (gas) used in cutting and welding
Methods of test for dissolved acetylene gas.
- ICS
- 71.100.20
- CCS
- 发布
- 1994-11-16
- 实施
This standard is concerned with dissolved acetylene, packed in cylinders, used in industrial purposes for cutting and welding and as an illumination gas for navigation purposes.
Dissolved acetylene.
- ICS
- 71.100.20
- CCS
- 发布
- 1994-11-16
- 实施
This Gulf standard specifies the methods of determination of mercury content in liquid chlorine with a lower limit of detection of 0. 1 ppb.
Methods of test for liquid chlorine - Determination of mercury content .
- ICS
- 71.100.20
- CCS
- 发布
- 1994-11-16
- 实施
本标准规定了用作焊接保护介质并以气瓶或贮槽包装供应的液态以及用管道输送供应的气态二氧化碳的技术要求、试验方法、验收规则、标志、包装、运输．贮存、安全要求等。 本标准适用于以石灰窑气、合成氨厂气、炼油厂气、矿井气、发酵池气等方法所得的二氧化碳。
carbon dioxide for welding
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1993-09-06
- 实施
- 1994-07-01
This document specifies a method for the determination of the volume part of C-C-hydrocarbons in nitrogen in the range between 0,2 and 10 ?l.#,,#
Testing of materials for semiconductor technology; determination of impurities in carrier gases and dopant gases; determination of C1-C3-hydrocarbons in nitrogen by gas-chromatography
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1993-09
- 实施
この規格は，圧力スイング吸着装置()の性能試験方法について規定する。注()吸着剤を入れた筒状の容器に原料ガスを供給し，高い圧力下で吸着させる操作と低い圧力下で脱離させる操作とを繰り返し，原料ガス中の成分を濃縮・分離することによって，必要とする製品ガスを得る装置。この操作をPSA (pressure swing adsorption)操作といい，したがって，この装置をPSA装置ということもある。
Pressure swing adsorption apparatus -- Test methods
- ICS
- 71.100.20
- CCS
- N11
- 发布
- 1993-08-01
- 实施
Not applicable to oxygen for medical, breathing or electronics applications.
Specification for industrial oxygen
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1993-02-15
- 实施
- 1993-02-15
Not applicable to nitrogen for medical, breathing, electronics applications.
Specification for industrial nitrogen
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1993-02-15
- 实施
- 1993-02-15
This test method shall yield data that will form a “performance profile” for a fuel ethanol manufacturing facility. The significance of this profile is that it can be compared directly to another facilityrsquo;performance profile and yield a relative measurement and shall provide a measure of expected facility performance under field conditions. Based on the four main parameters highlighted above, facilities of significantly different designs can be compared relatively. The single black box technique applied to performance evaluation examines only the overall input/output relationship. This implies that the operation of the facility during the tests shall be conducted to achieve design conditions in accordance with established procedures.1.1 This test method covers the determination of performance characteristics of fuel ethanol manufacturing facilities. 1.2 This test method is applicable for all starch, sugar, and combination starch/sugar based fermentable feedstocks. 1.3 This test method is applicable to both batch and continuous fuel ethanol manufacturing processes.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Performance Evaluation of Fuel Ethanol Manufacturing Facilities
- ICS
- 71.100.20
- CCS
- G91
- 发布
- 1993
- 实施
Compressed air for general use; part 1: contaminants and quality classes
- ICS
- 71.100.20
- CCS
- G86
- 发布
- 1991-12
- 实施
