85.080 纸制品 标准查询与下载

ASTM F415-87(2005) 碳纸卷曲度的标准试验方法

Standard Test Method for Curl in Carbon Paper

DB42/T 314-2005 中小学生课业簿册

本标准规定了中小学生课业簿册的术语、要求、试验方法、检验规则和标志、包装、运输、贮存。本标准适用于武汉市中小学生使用的非正式出版的各种软面课业簿册（即地方俗称的练习本）。

Exerxise Book for Primary and Secondary School

EN ISO 12625-5:2005 薄纸和薄纸产品.第5部分:湿拉伸强度的测定

This part of ISO 12625 specifies a test method for the determination of the wet tensile strength of tissue paperand tissue products after soaking with water, using a tensile-strength-testing apparatus operating with a constantrate of elongation.

Tissue paper and tissue products - Part 5: Determination of wet tensile strength

QB/T 1437-2005 课业簿册

本标准规定了课业簿册的产品分类、要求、试验方法、检验规则和标志、包装、运输、贮存。 本标准适用于各种规格的课业簿册。

Exercise book

QB/T 1439-2005 帐册

本标准规定了帐册的产品分类、要求、试验方法、检验规则和标志、包装、运输、贮存。 本标准适用于各种规格的帐册。

Account book

SNI 14-0937-2005 印刷纸C

Printing paper C

SNI 14-0588-2005 教材书籍封面用纸

Paper for school material book cover

SNI 14-7100-2005 无碳复写纸类型机械更换

NCR paper type mechanical change

KS M 7304-2004(2009) Galpo壁纸原纸

Base paper for grass cloth wall paper

LST EN 12281-2003 印刷和商业用纸 干墨粉成像工艺用复印纸的要求

Printing and business paper - Requirements for copy paper for dry toner imaging processes

LST EN 12283-2003 印刷和商业用纸 墨粉附着力的测定

Printing and business paper - Determination of toner adhesion

KS M ISO 353-2003 加工书写纸和某些印刷品尺寸表示法

Processed writing paper and certain classes of printed matter－Method of expression of dimensions

KS M ISO 353:2003 加工书写纸和某些印刷品尺寸表示法

Processed writing paper and certain classes of printed matter－Method of expression of dimensions

GSO 1234:2002 学校笔记本

  Scope is not provided for this standard

School note books

GSO ISO 1388-7:2002 工业用乙醇的测试方法 通过测量光强度估算 0.01 0.20%（体积/体积）之间的甲醇含量百分比

This Gulf standard is concerned with determination of methanol in ethanol for industrial use, using a photometric method. This method is applicable to products having methanol contents between 0.01 and 0.20 % (v/v).

Ethanol for industrial use metod of test : determination of methanol content between 0.01 and 0.20 % (v/v ) - photometric method .

ASTM D6833-02e1 用污染室曝光装置对印刷和书写纸加速污染物老化的试验方法

1.1 This test method describes a laboratory procedure for the exposure of printing and writing paper to common atmospheric pollutant gas at elevated levels of concentration to permit accelerated aging of such paper. 1.2 This test method specifies the sample preparation and conditions of exposure required to obtain information on the relative stability of paper with regard to change in mechanical strength and optical properties brought about by exposure of such paper to common atmospheric pollutant gas. 1.3 This test method provides qualitative results regarding paper stability and does not define the exact life expectancy for a given paper to reach a specified set of strength or optical properties. The limit(s) of acceptability for a specified set of properties must be defined by each end user and will determine the life expectancy of the paper to be tested. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Accelerated Pollutant Aging of Printing and Writing Paper by Pollution Chamber Exposure Apparatus

ASTM D6819-02e1 用干烘箱曝光装置对印刷纸和书写纸加速温度老化的试验方法

Standard Test Method for Accelerated Temperature Aging of Printing and Writing Paper by Dry Oven Exposure Apparatus

ASTM D6787-02 可重定位笔记本的标准规范

1.1 This specification covers pads of repositionable, colored, note paper. Each sheet has a strip of pressure-sensitive adhesive on the back side.1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently, without combining values in any way.1.3 The following safety hazards caveat pertains only to Section 14, Performance Requirements. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Standard Specification for Repositionable Note Pad

EN 12281:2002 印刷纸和商务用纸.干色粉成像工艺用复印纸的要求;代替ENV 12281-1996

This standard specifies the performance requirements for uncoated cut-size paper for dry toner imaging processes (i.e. Copy paper),in 80 g/m2 and in A4 format based on EN ISO-A series are covered byThis European Standard,as long asThe requirements specified inThis European Standard are fulfilled.

Printing and business paper - Requirements for copy paper for dry toner imaging processes

EN 12283:2002 印刷纸和商务用纸.调色剂粘性的测定;代替ENV 12283-1996

This European Standard specifies the determination of the adhesion of dry toner on paper sheet, printed with imagingmachines such as copier machines and printers.The chosen measuring range allows discrimination of toner adhesionaroundThe level found with many common paper and machine combinations.Since divers imaging processes give different toner adhesion,The described method at constant IGT speed is notadvised to compare degree of toner adhesion between different types of machines.

Printing and business paper - Determination of toner adhesion