87.060.99 其他涂料配料 标准查询与下载

T/YTQB 0002-2019 油漆用色浆

表1　技术要求 项    目　性能指标 容器中状态　搅拌混合后无硬块，呈均匀状态 不挥发物含量/%                                                    ≥　40 细度/μm                                                          ≤　60 干燥时间/h  表干                                                             ≤  实干                                                             ≤　 5 24 遮盖力/（g/m2）                                                   ≤　100 表1 技术要求（续） 项    目　性能指标 耐盐水性（3%NaCl）                                                           　24h无异常 重金属质量分数/(mg/kg)　汞（以总汞计）/mg/kg                   ≤　300 　铬（以总铬计）/mg/kg                   ≤　500 　镉（以总镉计）/mg/kg             ≤　300 　铅（以总铅计）/mg/kg             ≤　500

color paste for paint

BS EN ISO 4619:2018 油漆和清漆干燥剂

What is this standard about? This document specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. It applies to driers in the solid or liquid form. It does not apply to emulsifiable driers.

Driers for paints and varnishes

DIN 55901:2018 油漆和清漆用催干剂 混合催干剂中金属含量的测定方法

In addition to DIN ISO 4619 this standard contains test methods for the metal contents of mixed driers.

Driers for paints and varnishes - Methods for determination of metal contents of mixed driers

ISO 4619:2018 油漆和清漆干燥剂

This document specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. It applies to driers in the solid or liquid form. It does not apply to emulsifiable driers.

Driers for paints and varnishes

T/ZZB 0415-2018 多元酸咪唑啉消光固化剂

本标准规定了多元酸咪唑啉消光固化剂的术语和定义、产品分类、基本要求、技术要求、试验方法、检验规则、标志、包装、运输、贮存和质量承诺。 本标准适用于以咪唑啉与均苯四甲酸等多元酸为起始原料经化学合成形成的多元酸咪唑啉盐，作为环氧粉末涂料或环氧-聚酯粉末涂料的消光固化剂。

Polyacid imidazoline matting hardener

T/ZZB 0414-2018 羟烷基酰胺固化剂

本标准规定了羟烷基酰胺固化剂的产品分级、基本要求、技术要求、试验方法、检验规则、标志、包装、运输、贮存和质量承诺。 本标准适用于以二乙醇胺和己二酸二甲酯为起始原料经化学合成的羟烷基酰胺，用于纯聚酯粉末涂料的固化剂。

Hydroxyl alkyl amide curing agent

T/GDTL 003-2018 水性涂料用硬脂酸锌乳液

3　要求 3.1　产品性能应符合表1的要求。 3.2　产品中添加生物杀伤剂、含量应符合GB/T35602-2017中表5的要求。 3.3　产品中不得添加烷基酚聚氧乙烯醚(APEO)。 （详见本标准表1）

Zinc stearate emulsion for water-based coatings

ASTM D4140-07(2018) 确定干燥剂 干燥油 海军商店和溶剂的挥发性和非挥发性含量的标准指南

1.1 This guide is intended to aid in the selection of the proper ASTM test method for determining the volatile and nonvolatile content of driers, drying oils, naval stores, and solvents. NOTE 1—Test methods for determining the composition of the volatile fraction are not covered by this guide. 1.2 The test methods included are as follows: Standard Section ASTM Designation Driers 5.1 D1644 Drying oils 5.2 D555 D1960 Naval stores 5.3 D233 D889 D1131 Solvents 5.4 D1353 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Guide for Determining Volatile and Nonvolatile Content of Driers, Drying Oils, Naval Stores, and Solvents

KS M ISO 8623-2016 色漆和清漆用塔尔油脂肪酸规范和试验方法

Tall-oil fatty acids for paints and varnishes－Specifications and test methods

KS M ISO 8623:2016 油漆和清漆用高脂油脂肪酸规范和试验方法

Tall-oil fatty acids for paints and varnishes－Specifications and test methods

HG/T 5066-2016 水性涂料用分散剂

Dispersants for water-based coatings

BS EN ISO 8623:2015 涂料和清漆用松焦油脂肪酸.试验方法和特征值

Tall-oil fatty acids for paints and varnishes. Test methods and characteristic values

T/CFA 020206-1-2014 球墨铸铁管、管件和附件的环氧陶瓷内涂层

球墨铸铁管（以下简称球铁管）、管件和附件环氧陶瓷内防腐涂层的技术要求、试验方法和检验规则

Ceramic epoxy lining for ductile iron pipes, fittings and accessories

ASTM D3804-02(2014) EDTA法测定油漆干燥剂中铁的标准试验方法

1.1 This test method covers the titrimetric determination of iron in liquid iron driers soluble in isopropyl alcohol and utilizes the disodium salt of ethylenediaminetetraacetic acid dihydrate (EDTA). 1.2 This test method is limited to the determination of the iron content of a liquid drier that does not contain other drier elements. This method is not applicable to drier blends. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Iron in Paint Driers by EDTA Method

KS M ISO 4619:2013 涂料用干燥剂

이 표준은 페인트, 바니시 및 관련 제품용 건조제의 요구사항 및 대응되는 시험방법에 대하여 규정한다. 요구사항은 고형 또는 액상의 건조제에 적용한다.

Driers for paints and varnishes

ASTM D4140-07(2013) 确定干燥剂 干燥油 海军商店和溶剂的挥发性和非挥发性含量的标准指南

1.1 This guide is intended to aid in the selection of the proper ASTM test method for determining the volatile and nonvolatile content of driers, drying oils, naval stores, and solvents. NOTE 1—Test methods for determining the composition of the volatile fraction are not covered by this guide. 1.2 The test methods included are as follows: Standard Section ASTM Designation Driers 5.1 D1644 Drying oils 5.2 D555 D1960 Naval stores 5.3 D233 D889 D1131 Solvents 5.4 D1353

Standard Guide for Determining Volatile and Nonvolatile Content of Driers, Drying Oils, Naval Stores, and Solvents

DS/EN ISO 4619:2011 油漆和清漆的干燥剂

The document specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. The requirements relate to driers in the solid or liquid form.

Driers for paints and varnishes

LST EN ISO 8623:2011 油漆和清漆用妥尔油脂肪酸 规格和测试方法（ISO 8623:1997）

Tall-oil fatty acids for paints and varnishes - Specifications and test methods (ISO 8623:1997)

LST EN ISO 4619:2011 油漆和清漆的催干剂（ISO 4619:1998）

Driers for paints and varnishes (ISO 4619:1998)

DIN EN ISO 4619:2011 涂料和清漆用干燥剂(ISO 4619-1998);德文版本EN ISO 4619-2010

This International Standard specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. The requirements relate to driers in the solid or liquid form.

Driers for paints and varnishes (ISO 4619:1998); German version EN ISO 4619:2010