87.060.99 其他涂料配料 标准查询与下载

NF T30-305:2011 涂料和清漆用干燥剂.

Driers for paints and varnishes.

EN ISO 4619:2010 涂料和清漆用干燥剂

This International Standard specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. The requirements relate to driers in the solid or liquid form

Driers for paints and varnishes (ISO 4619:1998)

JB/T 9226-2008 砂型铸造用涂料

本标准规定了砂型（芯）铸造用涂料的术语和定义、分类和牌号、技术要求、试验方法、检验规则以及标签、包装、运输和贮存。 本标准适用于砂型（芯）铸造用载体为水或有机溶剂的浆状、膏状和粉（粒）状涂料。

Coatings for sand casting

KS M ISO 8623:2007 油漆和清漆用高脂油脂肪酸规范和试验方法

이 규격은 도료와 바니시용 증류 톨-유지방산의 품질조건과 시험방법에 대하여 규정한다.

Tall-oil fatty acids for paints and varnishes-Specifications and test methods

ASTM D600-07 液体油漆干燥器的标准规格

1.1 This specification covers liquids for use in paints, varnishes, enamels, and similar organic coatings and are solutions of metallic salts of:1.1.1 Class A - 2-Ethyl hexanoic acids in petroleum spirits.1.1.2 Class B - Naphthenic acids in petroleum spirits.1.1.3 Class C - Neodecanoic acids in petroleum spirits.1.1.4 Class D - Tall oil fatty acids in petroleum spirits.1.1.5 Class E - Any of the above acids or acid blends, but containing additives that make the liquid drier water dispersible. Some other driers may also contain complexing agents.1.1.6 Class F - Other acids and acid blends unidentified by their producers.1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit in accordance with the rounding-off method of Practice E 29.1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.4 For specific hazard information and guidance, see the supplier's Material Safety Data Sheets for materials listed in this specification.

Standard Specification for Liquid Paint Driers

KS M ISO 6271-2005 透明液体 铂钴标尺颜色评价

Clear liquids－Estimation of colour by the platinum-cobalt scale

KS M ISO 6271:2005 透明液体用铂钴标度法测定颜色

Clear liquids－Estimation of colour by the platinum-cobalt scale

SANS 6279:2003 油漆和清漆．滤网上残渣的测定

Describes a method for determining the residue on sieve from a sample of paint, varnish, paste or powder.

Paints and varnishes - Determination of residue on sieve

ASTM D964-03(2014) 防污涂料用金属铜粉的标准规格

1.1 This specification covers copper powder for use in antifouling paints. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Standard Specification for Metallic Copper Powder for Use in Antifouling Paints

DIN 55901:2002 涂料和清漆用干燥剂.混合干燥剂中金属含量测定方法

In addition to DIN ISO 4619 the document contains test methods for the metal content of mixed driers.

Driers for paints and varnishes - Methods for determination of metal contents of mixed driers

KS M ISO 6271:2002 透明液体用铂钴标度法测定颜色

Clear liquids－Estimation of colour by the platinum-cobalt scale

KS M ISO 6271-2002 透明液体用铂钴标度法测定颜色

Clear liquids－Estimation of colour by the platinum-cobalt scale

CAN/CGSB-1.4-2000 石油精稀释剂

Scope 1.1 This standard applies to mineral or white spirits petroleum distillate that may be used as a paint and varnish thinner. It is not be used in special applications where low-flash or high solvency thinners are required. 1.2 This thinner may be used to clean brushes and spraying equipment. 1.3 The testing and evaluation of a product against this standard may require the use of materials and/or equipment that could be hazardous. This document does not purport to address all the safety aspects associated with its use. Anyone using this standard has the responsibility to consult the appropriate authorities and to establish appropriate health and safety practices in conjunction with any applicable regulatory requirements prior to its use.

Petroleum Spirits Thinner

ASTM D267-82(1999) 金青铜粉标准规格

Standard Specification for Gold Bronze Powder

ASTM D2373-85(1999) 用EDTA法测定涂料烘干机中钴的标准试验方法

1.1 This test method covers a titrimetric determination of cobalt in liquid paint driers that can be dissolved in glacial acetic acid and utilizes the disodium salt of ethylenediaminetetraacetic acid dihydrate (EDTA). 1.2 This test method is not applicable to drier blends. If driers other than cobalt are present, they may interfere by reacting with EDTA under the conditions used for analysis. 1.3 All cations that can be titrated with EDTA in alkaline media interfere and must not be present in the sample. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Determination of Cobalt in Paint Driers by EDTA Method

BS ISO 4619:1998 涂料和清漆用干燥剂

This International Standard specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. The requirements relate to driers in the solid or liquid form. CAUTION —The procedures described in this International Standard are intended to be carried out by qualified chemist or by other suitably trained and/or supervised personnel. The substances and procedures used in this method may be injurious to health if adequate precautions are not taken. This International Standard refers only to its technical suitability and does not absolve the user from statutory obligations relating to health and safety. Attention is particularly drawn to the health hazards of heavy metals which may be a constituent of driers (e.g. cobalt, lead, cerium, zirconium, vanadium; see clauses 3,4 and 8).

Driers for paints and varnishes

BS EN ISO 4619:2010 涂料和清漆用干燥剂

Driers for paints and varnishes

ISO 4619:1998 色漆和清漆用干燥剂

This International Standard specifies the requirements and the corresponding test methods for driers for paints, varnishes and related products. The requirements relate to driers in the solid or liquid form. CAUTION — The procedures described in this International Standard are intended to be carried out by qualified chemist or by other suitably trained and/or supervised personnel. The substances and procedures used in this method may be injurious to health if adequate precautions are not taken. This International Standard refers only to its technical suitability and does not absolve the user from statutory obligations relating to health and safety. Attention is particularly drawn to the health hazards of heavy metals which may be a constituent of driers (e.g. cobalt, lead, cerium, zirconium, vanadium; see clauses 3, 4 and 8).

Driers for paints and varnishes

ASTM D267-82(2008)e1 黄铜粉的标准规范

1.1 This specification covers the materials commercially known as gold bronze, pale gold bronze, and rich gold bronze powders. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Standard Specification for Gold Bronze Powder

ASTM D267-82(2014) 金青铜粉末的标准规格

1.1 This specification covers the materials commercially known as gold bronze, pale gold bronze, and rich gold bronze powders. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Standard Specification for Gold Bronze Powder