91.060.01 建筑构件综合 标准查询与下载

BS 6093:1993 建筑结构的接缝及连接设计实用规程

Draws attention to the design processes and mechanisms of a broad range of basic jointing methods, to assist designers in solving problems for specific designs. Recommendations are made on the use of sealants and gaskets.

Code of practice for design of joints and jointing in building construction

JIS A 1436:1991 充分粘结在基质上的涂层和片层的脱落能力的试验方法

この規格は，建築物等の保護・仕上げなどの目的で屋根スラブ，壁，床等に接着して用いるシート状材料又は塗布して用いる液状材料の硬化物の，下地不連続部に生じるムーブメントによる疲労に対する抵抗性を評価するための試験方法について規定する。

Test methods for movement capability of coatings and sheets fully adhered on substrate

CECS 24-1990 钢结构防火涂料应用技术规范

本规范适用于建筑物及构筑物钢结构防火保护涂层的设计、施工和验收。

REGULATION OF APPLICATION TECHNOLOGY OF FIRE RESISTIVE COATING FOR STEEL STRUCTURE

GN 15-1982 梁、板和非承重建筑构件耐火试验方法

Method of fire resistance test for beams, planks and non-load-bearing architectural components

ASTM E754-80(2014)e1 埋入砖石灰缝中的拉杆和锚的拔拉阻力的标准测试方法

5.1 This test method is intended to provide a simple inexpensive means of generating conservative, comparative data on pullout strengths of various ties and anchors used with different types of masonry units and mortars. This test method is recommended for such use until economical, improved methods can be developed to simulate service conditions more inclusively. 1.1 This test method provides procedures for determining the ability of individual masonry ties and anchors to resist extraction from a masonry mortar joint. 1.2 Two laboratory testing procedures are provided for use with test specimens which consist of a masonry tie or anchor embedded in mortar between twin stack-bonded masonry units. 1.2.1 Procedure A—For use with small (brick-size) masonry units. 1.2.2 Procedure B—For use with large (block-size) masonry units. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints

KS F 1521-1978(1996) 栏杆的工厂安装基地

STANDARD SIZE OF PREFABRICATED HAND RAIL

JGJ 61-2003（条文说明） 网壳结构技术规程

Technical specification for latticed shells(explanation)