91.060.30 天花板、地板、楼梯 标准查询与下载

ASTM C1858-17a(2021) 在受地震地面运动影响的区域用于安装石膏板产品的直接悬挂T形杆型天花板系统的设计、施工和材料要求的标准实施规程

1.1 This practice covers the installation requirements of direct hung suspended t-bar type ceiling systems intended to receive gypsum panel products constructed as flat, single level, surrounded on all sides by a wall, bulk head, or soffit braced to the building structure to resist the effects of earthquake ground motions. 1.2 Ceiling assembly shall not be intended to support live loads. 1.3 This standard addresses ceiling systems with dead loads up to 10 lbs/ft2 (48.8 kg/m2 ). 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for Design, Construction, and Material Requirements for Direct Hung Suspended T-bar Type Ceiling Systems Intended to Receive Gypsum Panel Products in Areas Subject to Earthquake Grou

T/ZZXJX 043-2021 全轻混凝土建筑地面保温工程技术规程

前  言　 1 范围　 2 规范性引用文件　 3 术语和定义　 4 全轻混凝土材料　     4.1 原材料　     4.2 全轻混凝土性能　 5 全轻混凝土设计　     5.1 一般规定　     5.2 节能设计　     5.3 构造设计　 6 全轻混凝土制备　     6.1 一般规定　     6.2 全轻混凝土配合比　     6.3 拌合物拌制　     6.4 拌合物运输　 7 施工　     7.1 一般规定　     7.2 拌合物泵送　     7.3 浇筑和成型　     7.4 养护　 8 验收　     8.1 一般规定　     8.2 原材料　     8.3 全轻混凝土拌合物　     8.4 施工　

Technical specification for ground insulation engineering of all-light concrete buildings

T/ZZB 2185-2021 预制混凝土楼梯

本文件规定了预制混凝土楼梯的基本要求、技术要求、试验方法、检验规则、标志、包装、运输和贮存以及质量承诺。 本文件适用于一般工业与民用建筑中的预制混凝土楼梯。

Precast concrete stair

ASTM E935-21 建筑物用永久性金属栏杆系统和栏杆性能的标准试验方法

1.1?These test methods cover procedures to be followed in testing the performance of permanent metal railing systems (guard, stair, and ramp-rail systems), including components such as rails (hand, wall, grab, and transfer rails) and swing gates or other forms of required guardr

Standard Test Methods for Performance of Permanent Metal Railing Systems and Rails for Buildings

NF P19-203-1-2:2021 建筑工程 地板用混凝土工业楼板 第 1-2 部分：材料选择的一般标准

Building works - Industrial floor plates in concrete for floors - Part 1-2 : general criteria for choice of materials

NF P19-203-2:2021 建筑工程 地板用混凝土工业楼板 第2部分：特殊管理示范条款的合同清单

Building works - Industrial floor plates in concrete for floors - Part 2 : contract bill of special administrative model clauses

T/ESD 2002-2021 防静电地面现场检测抽样规则

4、环境及现场要求 5、抽样程序

Sampling Rules for Field Testing of Antistatic Floor

T/ESD 3008-2021 热固性防静电粉末涂料通用规范

本规范规定了热固性防静电粉末涂料的术语和定义、分类及等级、技术要求、试验方法、检验规则等要求。

General Specification for Thermosetting Electrostatic Powder Coatings

T/SBMIA 019-2021 建筑全装修 木质地板铺装、验收和使用规范

范围、规范性引用文件、术语和定义、分类、铺装施工前的准备、铺装施工、安装进度跟踪、现场保护、竣工验收、使用规范

Complete architectural decoration Installation, inspection and usage guidelines for wooden flooring

DIN 18560-1 Berichtigung 1:2021 建筑施工中的地坪砂浆 第1部分：一般要求、测试和施工；勘误表 1

This standard applies to construction site screeds and screeds made of screed mortars and screed masses in accordance with DIN EN 13813, which are manufactured using calcium sulphate, mastic asphalt, synthetic resin, caustic magnesia or cement. This standard applies to both indoo

Floor screeds in building construction - Part 1: General requirements, testing and construction; Corrigendum 1

ASTM C1731-21 混凝土地板标准规范

1.1 This specification covers concrete floor tile (CFT) for application as interior and exterior flooring. The units described by this specification are manufactured from cementitious materials, mineral aggregates (normal weight, lightweight, or both), water, and additives that are cast into various textures and shapes, often simulating natural stone, brick, terracotta, saltillo, and others. 1.2 This specification is limited to requirements for the physical attributes for the CFT units. 1.3 The use of results from testing installed CFT units that have been removed from use for determining conformance or nonconformance to the requirements of this specification is beyond the scope of this specification. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Concrete Floor Tile

T/CSTM 00324-2021 被动式低能耗建筑用弹性体改性沥青防水卷材

本文件规定了被动式低能耗建筑用的弹性体改性沥青防水卷材的术语和定义、分类、要求、试验方法、检验规则、标志、包装、贮存与运输。 本文件适用于以苯乙烯-丁二烯-苯乙烯（SBS）热塑性弹性体作石油沥青改性剂所制成的弹性体改性沥青防水卷材。

Styrene Butadiene Styrene(SBS) modified bituminous sheet materials for the energy efficient passive building

KS F 8012-2021 工作平台

Working platform

DIN 18560-1:2021 房屋建筑中的地板找平层. 第1部分: 一般要求, 测试和结构

This standard applies to construction site screeds and screeds made of screed mortars and screed masses in accordance with DIN EN 13813, which are manufactured using calcium sulphate, mastic asphalt, synthetic resin, caustic magnesia or cement. This standard applies to both indoo

Floor screeds in building construction - Part 1: General requirements, testing and construction

GOST R 59690-2021 拉伸天花板的材料和配件 一般规格

Materials and accessories for stretch ceilings. General specifications

T/CMMA 8-2021 镁质胶凝材料制品 硫氧镁平板

主要对硫氧镁平板力学性能、物理性能、环保性能等技术指标进行规定。

Magnesia cement products—Magnesium sulphide plate

NF P62-207-2:2020 建筑工程. 表面处理和柔性地板覆盖物. 第2部分: 特殊管理标准条款合同单

Le présent document fixe les clauses administratives spéciales types aux marchés de travaux d'exécution de revêtements de sol dans le champ d'application des NF DTU 53.12 P1-1-1 (CCT) et NF DTU 53.12 P1- 1-2 (CCT) et NF DTU 53.12 P1-1-3 (CCT) et NF DTU 53.12 P1-1-4 (CCT) .Dans le

Building works - Surface preparation and flexible floor coverings - Part 2 : contract bill of special administrative model clauses

NF E85-016:2020 工业设施要素. 永久性通道. 固定梯

Le présent document spécifie les prescriptions relatives à la conception, à l'installation et aux essais des échelles fixes métalliques solidaires des installations munies ou non d'une crinoline, utilisées par le personnel de maintenance, d'exécution et d'exploitation. Le présent

Elements of industrial facilities - Permanent means of access - Fixed ladders

LST EN ISO 16283-2:2020 声学 建筑物和建筑构件隔音的现场测量 第2部分：冲击隔音（ISO 16283-2:2020）

Acoustics - Field measurement of sound insulation in buildings and of building elements - Part 2: Impact sound insulation (ISO 16283-2:2020)

OENORM EN ISO 16283-2:2020 声学 建筑物和建筑构件隔音的现场测量 第2部分：冲击隔音（ISO 16283-2:2020）

Acoustics - Field measurement of sound insulation in buildings and of building elements - Part 2: Impact sound insulation (ISO 16283-2:2020)