91.080.20 木结构 标准查询与下载

BS EN 596:1995 木结构.试验方法.木框架墙的软体冲击试验

This standard specifies a test method for determining the resistance of a timber frame wall panel to impact from a soft body allowed to strike the sheathing of the panel.

Timber structures - Test methods - Soft body impact test of timber framed walls

P21-205-1995 DTU 31-3.与金属板紧固件或结点板相连接的木构件.第1部分:技术规范.第2部分:特别条款

DTU 31-3 - Timber structures connected with metal plate fasteners or gussets - Part 2 : design rules - Part 3 : particular specifications book.

NF P21-205-3:1995 DTU31.3.与金属板紧固件和联接板相关的木结构框架.第3部分:特别规范手册

DTU 31-3. Timber structures connected with metal plate fasteners or gussets. Part 3 : particular specifications book.

NF P21-205:1995 DTU 31-3.与金属板紧固件或角板相连的木结构.第2部分:设计规则.第3部分:详细规范手册

DTU 31-3 - Timber structures connected with metal plate fasteners or gussets - Part 2 : design rules - Part 3 : particular specifications book.

NF P21-205-2:1995 DTU31.3.与金属板紧固件或联接板相连的木结构.第2部分:设计规则

DTU 31-3. Timber structures connected with metal plate fasteners or gussets - Part 2 : design rules.

NF P21-205-1:1995 DTU31.3.与金属板紧固件和联接板相连的木结构框架.第1部分:结构规则

DTU 31-3 - Timber structures connected with metal plate fasteners or gussets.

EN 595:1995 木材结构的试验方法.强度和变形特性的测定用桁架的试验

This standard specifies the test procedures fordeterminingThe strength and deformationbehaviour of trusses.NOTE.The test methods are based on EN 380.

Timber structures - Test methods - Test of trusses for the determination of strength and deformation behaviour

CSA O86.1-1994 木材工程设计（极限状态设计）

1. Scope 1.1 General This Standard provides criteria for the structural design and appraisal of structures or structural elements made from wood or wood products including graded lumber, glued-laminated timber, unsanded plywood, design rated OSB, composite building components, shearwalls and diaphragms, piling, pole type construction, structural fastenings, prefabricated wood I-joists, and preserved wood foundations employing the limit states design method.

Engineering Design in Wood (Limit States Design)

JIS A 3301:1993 校舍木结构的设计标准

この規格は，2階建て及び平家建ての木造校舎の構造設計標準について規定する。

Design standards for wooden construction of school buildings

NF P21-300*NF EN 380:1993 木材构件.试验方法.静态负荷试验总则

Timber structures. Test methods. General principles for static load testing.

NF P21-384:1993 木材构件.试验方法.暗销形紧固件屈服力矩.钉子

Timber structures. Test methods. Determination of the yield moment of dowel type fasteners. Nails.

NF P21-303:1993 木材构件.试验方法.暗销形紧固件基座值和嵌入强度测定

Timber structures. Test methods. Determination of embedding strength and foundation values for dowel type fasteners.

BS EN 380:1993 木结构.试验方法.静荷载试验的一般原则

This standard specifies the general principles to be adopted for static load testing of timber structures. It is intended for use where it is necessary to verify by test that a structure complies with stated criteria. Relevant parts may be used for proof loading or for the testing of structures in service. This standard is not intended to be used for testing of individual pieces of timber, individual joints or structural scaled models.

Timber structures - Test methods - General principles for static load testing

DS/EN 380:1993 木结构．试验方法．静负荷试验的一般原则

This standard specifies the general principles to be adopted for static load testing of timber struc-tures. It is intended for use where it is necessary to verify by test that a structure complies with stated criteria. Relevant parts may be used for proof loading or for the testing of structures in service. This standard is not intended to be used for testing of individual pieces of timber, individual joints or structural scaled models.

Timber structures. Test methods. General principles for static load testing

DIN EN 380:1993 木结构.试验方法.静负荷试验一般原理

The document specifies the general principles to be adopted for static load testing of timber structures. Where necessary, it should be verified by test that a structure complies with stated criteria. Relevant parts may be used for proof loading or for the testing of structures in service. It is not intended to be used for testing of individuaal pieces of timber, individual joints or structural scaled models.

Timber structures; test methods; general principles for static load testing; German version EN 380:1993

DS/ISO 6891:1993 木结构 用机械紧固件制成的接头 强度和变形特性测定的一般原则

The standard lays down general principles for the determination of the strength and deformation (slip) characteristics of joints made with mechanical fasteners. It is applicable to joints made with mechanical fasteners used in statistically loaded timber structures. Detailed procedures appropriate to the joints made with specific fasteners will be given in separate International Standards. The principles can also be used for the testing of other joints. It is recognized that for some special types of joints not covered by...

Timber structures - Joints made with mechanical fasteners - General principles for the determination of strength and deformation characteristics

DS/EN 26891:1993 木结构 用机械紧固件制成的接头 确定强度和变形特性的一般原则

The standard lays down general principles for the determination of the strength and deformation (slip) characteristics of joints made with mechanical fasteners. It is applicable to joints made with mechanical fasteners used in statically loaded timber structures. Detailed procedures appropriate to joints made with specific fasteners will be given in separate International Standards. The principles can also be used for the testing of other joints. It is recognized that...

Timber structures. Joints made with mechanical fasteners. General principles for the determination of strength and deformation characteristics

EN 380:1993 木结构的试验方法.静荷载试验的一般原则

This standard specifies the general principles to beadopted for static load testing of timber structures.It is intended for use where it is necessary to verifyby test that a structure complies with statedcriteria. Relevant parts may be used for proofloading or forThe testing of structures in service.This standard is not intended to be used for testingof individual pieces of timber, individual joints orstructural scaled models.

Timber structures; test methods; general principles for static load testing

CSN 73 2810-1993 木材结构．建筑物

Zpracovatel: Vysoká ?kola zemědělská Brno, lesnická fakulta, I?O 216348, D?eva?ské v?zkumné pracovi?tě Zlín, Ing. Bohumil Ko?elouh, CSc. Technická normaliza?ní komise: TNK 34 D?evěné konstrukce Pracovník Federálního ú?adu pro normalizaci a mě?ení: Ing. Irena Pavlí?ková

Timber structures; construction

CSA O86.1.1-1992 CSA 标准 CAN/CSA-O86.1-M89 的评论 木材工程设计（极限状态设计）

Commentary on CSA Standard CAN/CSA-O86.1-M89, Engineering Design in Wood (Limit States Design)