共找到 292 条与 建筑材料 相关的标准,共 20 页
本规程适用于结构工程中的混凝土抗压强度的检测。
TECHNICAL SPECIFICATION FOR INSPECTION OF CONCRETE STRENGTH BY PULL-OUT POST-INSERT METHOD
N/A
mineral aggregates and sands- determination of soundness.
This Gulf standard is concerned with a method for determination of density of compacted fresh concrete. The method applies to plain and air-entrained concrete made with light, normal or heavy weight aggregates having a normal maximum size of 400 mm or less, but not to aerated concrete or very stiff concrete which cannot be compacted by vibration alone. The formula are given in this Gulf standard for calculating the volume of concrete per batch and the cement content per cubic meter.
Testing concrete: method for determinantion of density of compacted fresh concrete.
This Gulf standard specifies methods for the determination of chloride and sulphate contents of mineral aggregates and sands.
mineral aggregates and sands-determination of chloride and sulphate contents.
This Gulf standard describes a method for determination of compacting factor of concrete of low, medium and high workability. The method applies to plain and air-entrained concrete, made with lightweight or normal weight or heavy aggregates, but not to aerated concrete, no-fines concrete and concrete which cannot be compacted by vibration.
Testing concrete:method for determination of Compacting factor.
This Gulf standard describes a method for determination of vebe time of concrete of very low to low workability and applies to plain and air-entrained concrete made with light, normal or heavy weight aggregates having a nominal maximum size of 40 mm or less but not to aerated concrete, non-fines concrete which cannot be compacted by vibration alone. This test is not suitable for concrete having a measured vebe time of less than 3 s or more than 30 s. This means if the vebe time is found to be out of this given range (less than 3 s and more than 30 s) by using this test method, the workability for this concrete mix shall be found by using another method.
Testing concrete: method for determination of vebe time.
Corrosion-resistant and lubricating grease specialized for unbonded tendons
Cast stone products. Cast stone plates
Performance test method for cast stone products. Bending strength test
Performance test method for cast stone products. Impact toughness test
Performance test method for cast stone products. Acid and alkali resistance test
Chemical analysis method of cast stone
Performance test method for cast stone products. Thermal shock resistance test
Performance test method for cast stone products. Compression strength test
Cast stone products. Cast stone straight tubes
This table, a nomogram, determines the distribution pipe or manifold length, hole or distribution pipe spacing, number of boles, dis?ibution discharge rate and hole diameter of pressure distribution systems by the placement of a straightedge between two
Referenced Standards
A person shall not willfully fail or refuse to comply with any lawful order or direction of the fire prevention code officiai or to interfere with the compliance attempts of another individual.
Masonry
The following is a listing of the standards referenced in this code, the effective date of the standard, the promulgating agency of the standard and the section(s) of this code that refer to the standard.
Masonry
A person shall not willfully fail or refuse to comply with any lawful order or direction of the fire prevention code officiai or to interfere with the compliance attempts of another individual.
Referenced Standards
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号