93.160 水利建筑 标准查询与下载

DB15/T 856-2015 模袋混凝土衬砌渠道工程技术规程

Technical specification for mold bag concrete lining channel engineering

SL 49-2015 混凝土面板堆石坝施工规范

本标准适用于1级、2级、3级混凝土面板堆石坝及4级、5级中的高混凝土面板堆石坝的施工，其他混凝土面板堆石坝可参照使用。对于200m级以上高坝及特别重要和复杂的工程，应进行专题研究。

Specification of construction for concrete face rockfill dams

SL/T 49-2015 混凝土面板堆石坝施工规范

Construction Specifications for Concrete Face Rockfill Dams

SL/T 718-2015 水土流失危险程度分级标准

Soil erosion risk classification standards

SL 718-2015 水土流失危险程度分级标准

本标准适用于全国水力侵蚀、风力侵蚀危险程度等级划分；对重力侵蚀中的滑坡单体和混合侵蚀中的泥石流单沟提出了危险程度等级划分的参考方法。

Classification standards for potential hazard of soil erosion

ASTM D4106-15 通过非平衡法确定非渗透含水层的透射率和储存系数的（分析程序）的标准测试方法

5.1 Assumptions:  5.1.1 Well discharges at a constant rate, Q. 5.1.2 Well is of infinitesimal diameter and fully penetrates the aquifer. 5.1.3 The nonleaky aquifer is homogeneous, isotropic, and aerially extensive. A nonleaky aquifer receives insignificant contribution of water from confining beds. 5.1.4 Discharge from the well is derived exclusively from storage in the aquifer. 5.1.5 The geometry of the assumed aquifer and well conditions are shown in Fig. 1. Sy   =   the specific yield. For fully penetrating observation wells, the effects of delayed yield are negligible at the distance, r, in Eq 8 after one tenth of the time given in the Eq 9. Note 1: The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D3740 are generally considered capable of competent and objective testing/sampling/inspection/etc. Users of this standard are cautioned that compliance with Practice D3740 does not in itself ensure reliable results. Reliable results depend on many factors; Practice D3740 provides a means of evaluating some of those factors. 1.1 This test method covers an analytical procedure for determining the transmissivity and storage coefficient of a nonleaky confined aquifer. It is used to analyze data on water-level response collected during radial flow to or from a well of constant discharge or injection. 1.2 This analytical procedure, along with others, is used in conjunction with the field procedure given in Test Method D4050. 1.3 Limitations—The limitations of this test method for determination of hydraulic properties of aquifers are primarily related to the correspondence between the field situation and the simplifying assumptions of this test method (see 5.1). 1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

Standard Test Method for (Analytical Procedure) for Determining Transmissivity and Storage Coefficient of Nonleaky Confined Aquifers by the Theis Nonequilibrium Method

SL 706-2015 水库调度规程编制导则

本标准适用于已建大、中型水库调度规程的编制，具备调度条件的小型水库可参照执行。

Guidelines for formulation of reservoir regulation rules

SL/T 706-2015 水库调度规程编制导则

Guidelines for Preparing Reservoir Operation Procedures

SL/T 205-2015 水电站引水渠道及前池设计规范

Design specifications for water diversion channels and forebays of hydropower stations

SL 205-2015 水电站引水渠道及前池 设计规范

本标准适用于中小型引水式水电站工程引水渠道和前池的设计。

Design specifications for hydropower headrace and forebay

SL/Z 699-2015 灌溉水利用率测定技术导则

本标准适用于灌区和区域灌溉水利用率的测定。

Technical guide for measurement and calculation of irrigation efficiency

SL 109-2015 农田排水试验规范

本标准适用于农田排水工程设计、施工和管理中为确定设计标准、设计参数、田间排水系统规格布局、水管理等而开展的试验。

Specifications for farmland drainage experiment

SL/T 703-2015 灌溉与排水工程施工质量评定规程

Construction quality assessment procedures for irrigation and drainage projects

SL 703-2015 灌溉与排水工程施工 质量评定规程

本标准适用于灌溉与排水工程及符合下列条件的小型水源工程施工质量评定。 1　引水流量不大于10m/s的引水枢纽。 2　小型泵站工程。 3　机井。 4　雨水集蓄工程。

Assessment code for construction quality of irrigation and drainage engineering

SL/T 109-2015 农田排水试验规范

Farmland Drainage Test Specifications

SL/T 230-2015 混凝土坝养护修理规程

Concrete dam maintenance and repair procedures

SL/T 210-2015 土石坝养护修理规程

Earth-rock dam maintenance and repair procedures

SL 230-2015 混凝土坝养护修理规程

本标准适用于水利水电工程中1级、2级、3级、4级混凝土坝及其枢纽所包含其他水工建筑物、地下洞室、边坡和设施的养护修理，5级混凝土坝可参照执行。

Code of maintenance and repair for concrete dam

SL 210-2015 土石坝养护修理规程

本标准适用于水利水电工程中1级、2级、3级、4级土石坝及其枢纽所包含的其他水工建筑物、地下洞室、边坡和设施的养护修理，5级土石坝可参照执行。

Code of maintenance and repair for earth rockfill dam

ASTM D4105/D4105M-15e1 使用改进的非平衡法测定非越流性有侧限的蓄水层过滤系数及储存系数的标准试验方法 (分析程序)

5.1 Assumptions:  5.1.1 Well discharges at a constant rate, Q. 5.1.2 Well is of infinitesimal diameter and fully penetrates the aquifer, that is, the well is open to the full thickness of the aquifer. 5.1.3 The nonleaky aquifer is homogeneous, isotropic, and areally extensive. A nonleaky aquifer receives insignificant contribution of water from confining beds. 5.1.4 Discharge from the well is derived exclusively from storage in the aquifer. 5.1.5 The geometry of the assumed aquifer and well conditions are shown in Fig. 1. Sy   =   the specific yield. For fully penetrating observation wells, the effects of delayed yield are negligible at the distance, r, in Eq 11 after one tenth of the time given in the Eq 12. Note 2: The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D3740 are generally considered capable of competent and objective testing/sampling/inspection/etc. Users of this standard are cautioned that compliance with Practice D3740 does not in itself assure reliable results. Reliable results depend on many factors; Practice D3740 provides a means of evaluating some of those factors. Note 3: The injection of water into an aquifer may be regulated or require regulatory approvals. Withdrawal of contaminated waters may require that the removed water be properly treated prior to discharge. 1.1 This test method covers an analytical procedure for determining transmissivity and storage coefficient of a nonleaky confined aquifer under conditions of radial flow to a fully penetrating well of constant flux. This test method is a shortcut procedure used to apply the Theis nonequilibrium method. The Theis method is described in Test Method D4106. 1.2 This test method, along with others, is used in conjunction with the field procedure given in Test Method D4050. 1.3 Limitationsx2......

Standard Test Method for (Analytical Procedure) for Determining Transmissivity and Storage Coefficient of Nonleaky Confined Aquifers by the Modified Theis Nonequilibrium Method