共找到 597 条与 胶粘剂 相关的标准,共 40 页
Adhesives; determination of shear behaviour of structural bonds; part 1: torsion test method using butt-bonded hollow cylinders
Adhesives; determination of dynamic resistance to cleavage of high strength adhesive bonds under impact conditions; wedge impact method
Adhesives; 180° peel test for flexible-to-flexible bonded assemblies (T-peel test)
The test method described is used to make comparative assessments of the securing or locking effect of anaerobic adhesives. It may be used for other types of adhesives. Its principle is determining the torque required to unscrew a bonded nut and bolt assembly, including the initial torque required to break the bond, and the torque measured after turning the nut 180?
Adhesives; determination of torque strength of anaerobic adhesives on threaded fasteners
本标准规定了a-氰基丙烯酸乙酯瞬间胶粘剂(502胶)的技术要求、试验方法、检验规则、包装、标志、运输和贮存。 本标准适用于通用I型a-氰基丙烯酸乙酯瞬间固化的胶粘剂。
a-Ethyl cyanoacrylate instant adhesive
本标准规定了鞋用氯丁橡胶胶粘剂的分类、分型、用途、技术要求、试验方法、验收规则及包装、标志、运输和贮存。 本标准适用于溶剂型鞋用氯丁橡胶胶粘剂。 本标准不适用于乳液型氯丁胶粘剂。
Neoprene Adhesive for Shoes
Is intended to determine whether the working life conforms to the minimum specified working life required of an adhesive by viscosity tests or by bond strength tests or by both. The working life is determined by measuring the viscosity and/or bond strength at specified intervals. The time at which the bond strength drops to a specified level and/or a specified change in viscosity is obtained is considered the working life of the adhesive.
Adhesives; determination of working life (pot life) of multi-component adhesives
Lithographic Blanket and Roller Wash Solvent
Lithographic Blanket and Roller Wash Solvent
Rubber Offset Lithographic Blankets
Rubber Offset Lithographic Blankets
Offset Lithographic Printing Ink
Offset Lithographic Printing Ink
The principle of the method specified is cyclically stressing the specimen in a way that may be regarded as the superposition of an alternating stress on a static stress which is the mean stress. The number of cycles at failure of the specimen for a given mean stress and stress amplitude is determined. These values are used to establish SN curves which then permit the estimation of the confidence zone concerning the fatigue resistance of a joint. The fatigue properties are a function of the specimen geometry. The results do not correspond to intrinsic properties of the adhesive and cannot be used for design purposes.
Adhesives; test methods for fatigue properties of structural adhesives in tensile shear
Adhesives; animal glues; methods for sampling and testing
Adhesives; wettability; determination by measurement of contact angle and critical surface tension of solid surface
本标准规定了乙酸乙烯酯-乙烯共聚乳液胶粘剂的技术要求、试验方法、检验规则及标志、包装、运输贮存等。 本标准适用于乙酸乙烯酯-乙烯共聚乳液胶粘剂。
Vinyl acetate-ethylene copolymer emulsion adhesive
Adhesives; solvent-borne and solvent-free adhesives; determination of flashpoint
MMM-A-185B ( I N T AM-21, dated 04 November 1974, has been reviewed and determined to be valId for use In acquisition.
ADHESIVE, RUBBER (FOR PAPER BONDING)
本标准规定了膏状强化松香施胶剂的技术要求、试验方法、检验规则、标志、包装、贮存等。 本标准适用于由脂松香与马来酸配起加成反应后,经皂化所得的膏状强化施胶剂,主要用作造纸施胶剂。
Paste reinforced rosin sizing agent
本标准规定了粉状强化施胶剂的技术要求、检验方法、检验规则、标志、包装、贮存、运输等。 本标准适用于由脂松香和马来酸酐起加成反应后,用碱皂化,经喷雾干燥所得的产品。该产品主要用作造纸施胶剂。
Powdered reinforced rosin sizing agent
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号