G40 橡胶制品综合 标准查询与下载

KS M 6901-2013 皮革中铅成分的测定试验方法

1.1 이 시험방법은 가죽에 존재하는 납염에 대한 정성 분석법이다.1.2 SI 단위로 지정되어 있는 값들은 표준으로 간주된다. 다른 측정 단위는 이 표준에 포함되지 않는다.1.3 이 표준은 사용 용도와 관련하여 모든 안전에 관한 사항에 대해 언급한 것은 아니다. 안전과건강에 관한 사항을 적용하고 강제적인 한계를 적용 및 결정하는 것은 이 표준 사용자의 책임이다.

Standard test method for determining the presence of lead salts in leather

KS M 6903-2013 皮革的氧铬测试方法.氧化高氯化酸

1.1 이 표준은 전체 또는 부분적으로 크롬 화합물로 처리한 가죽 중 삼산화이크롬의 분석방법에 대하여 규정한다. 일반적으로 이 방법은 산화크롬으로 계산했을 때 크롬이 1 %∼5 %를 포함하는 시료에 적용한다.1.2 SI 단위로 지정되어 있는 값들은 표준으로 간주된다.1.3 이 표준은 사용 용도와 관련하여 모든 안전에 관한 사항에 대해 언급한 것은 아니다. 안전과건강에 관한 사항을 적용하고 강제적인 한계를 적용 및 결정하는 것은 이 표준 사용자의 책임이다.

Standard Test method for chromic oxide in leather ㅡ Perchloric acid oxidation

ISO 17257:2013 橡胶.聚合物的鉴定.使用质谱探测的热解气相色谱法

This International Standard provides a qualitative method for the identification of rubbers by their pyrolysis products using tandem the gas-chromatography /mass spectrometry. The method applies to rubbers in the raw state and to unvulcanized and vulcanized compounds. Compounds can be based on a single rubber or a blend of two or more rubbers. Where the level of a particular rubber in a blend is < 10 % detection and identification can be difficult. A non-restrictive list of rubbers is given in Clause 3.

Rubber.Identification of polymers.Pyrolytic gas-chromatographic method using mass-spectrometric detection

NF T46-050:2013 橡胶. 差示扫描量热法(DSC). 一般原则

Rubber - Differential scanning calorimetry (DSC) - General principles

ISO 6914:2013 硫化橡胶或热塑性橡胶. 老化性能的测定 (拉伸应力松弛试验)

This International Standard describes three methods for the measurement of the change of stress in a test piece at a given elongation for the purpose of determining the ageing characteristics of a rubber.

Rubber, vulcanized or thermoplastic.Determination of ageing characteristics by measurement of stress relaxation in tension

DIN ISO 2285:2013 硫化橡胶或热塑性橡胶.在恒定延伸率条件下测定拉伸永久变形、及在恒定拉伸载荷下测定拉伸永久变形、伸长率和蠕变(ISO 2285-2013)

Rubber, vulcanized or thermoplastic - Determination of tension set under constant elongation, and of tension set, elongation and creep under constant tensile load (ISO 2285:2013)

KS M ISO 4671:2013 橡胶和塑料软管和软管组件.尺寸测量方法

이 표준은 호스 및 호스 어셈블리의 안지름, 바깥지름(유압 호스의 보강층 바깥지름 포함), 벽 두께,동심도, 호스 내면층과 외면층의 두께, 호스 및 호스 어셈블리의 길이 측정 및 확인 방법, 유압 호스어셈블리의 관통 구멍(through-bore)을 확인하는 방법을 규정한다.

Rubber and plastics hoses and hose assemblies－Methods of measurement of the dimensions of hoses and the lengths of hose assemblies

ISO/TS 16097:2013 硫化碎橡胶. 评估规程

This Technical Specification specifies physical and chemical tests,standard test formulations,equipment and processing methods for the vulcanization-characteristics evaluation and the mechanical properties of vulcanized crumb rubber.

Vulcanized crumb rubber.Evaluation procedures

JIS K 6300-1:2013 未硫化橡胶.物理特性.第1部分:用穆尼粘度计测定穆尼粘度和预硫化特性

Rubber, unvulcanized.Physical property.Part 1: Determination of Mooney viscosity and pre-vulcanization characteristics with Mooney viscometer

JIS K 6256-1:2013 硫化或热塑橡胶.粘附强度的测定.第1部分:与织物的粘附强度

Rubber, vulcanized or thermoplastic.Determination of adhesion strength .Part 1: Adhesion to textile fabric

JIS K 6262:2013 硫化或热塑橡胶.在常温、高温或低温下的压缩永久变形的测定

This Standard specifies methods for the determination of compression set of vulcanized and thermoplastic rubbers at ambient,elevated or low temperatures.

Rubber, vulcanized or thermoplastic.Determination of compression set at ambient, elevated or low temperatures

JIS K 6255:2013 硫化或热塑橡胶.回弹性的测定

Rubber, vulcanized or thermoplastic.Determination of rebound resilience

JIS K 6256-2:2013 硫化或热塑橡胶.粘附强度的测定.第2部分:与刚性底的粘附.90度剥离法

Rubber, vulcanized or thermoplastic -- Determination of adhesion strength -- Part 2: Adhesion to a rigid substrate -- 90 degree peel method

BS ISO 1629:2013 橡胶和胶乳. 术语

Rubber and latices. Nomenclature

NF T46-054*NF ISO 4650:2013 橡胶 - 红外分光光谱法

Rubber - Identification - Infrared spectrometric methods

SAE J2332-2013 橡胶件的标记

This SAE Recommended Practice provides a system for marking thermoset rubber parts to designate the general type of material from which the part was fabricated. The purpose of this document is to provide information to facilitate the: a. selection of materials and procedures for rubber parts; and b. collection and handling of parts for subsequent recycling.

Marking of Rubber Parts

ISO 1629:2013 橡胶和胶乳.命名法

This International Standard establishes a system of symbols for the basic rubbers in both dry and latex forms, based on the chemical composition of the polymer chain. The purpose of this International Standard is to standardize the abbreviated terms used in industry, commerce, and government, and it is not intended to conflict with, but rather to act as a supplement to, existing trade names and trademarks. NOTE 1 It is intended that in technical papers or presentations, the name of the rubber be used, if possible. It is intended that the symbols follow the chemical name for use in later references. NOTE 2 The nomenclature of thermoplastic elastomers is described in ISO 18064.

Rubber and latices - Nomenclature

NF T46-043-1/A1:2013 硫化橡胶或热塑性橡胶 - 压缩应力松弛的测定 - 第1部分: 恒温下的试验 - 修正本1: 修正的校准计划

Rubber, vulcanized or thermoplastic - Determination of stress relaxation in compression - Part 1: testing at constant temperature - Amendment 1 : revised calibration schedule

NF T46-025:2013 硫化或热塑橡胶. 低温硬化的测定(吉曼试验)

Rubber, vulcanized or thermoplastic - Determination of low temperature stiffening (Gehman test)

SN/T 3520-2013 橡胶及其制品中汞含量的测定.原子荧光光谱法

本标准规定了原子荧光光谱法测定天然胶乳、生胶、混炼胶及硫化橡胶及其制品中汞含量的方法。本标准适用于天然胶乳、生胶、混炼胶及硫化橡胶及其制品中汞含量的测定方法，测定范围为0.1 mg/kg~1 000 mg/kg。

Determination of mercury in rubber and rubber products.Atomic fluorescence spectrometric method