共找到 1277 条与 橡胶制品综合 相关的标准,共 86 页
이 표준은 전단 굽힘과 마찰의 결합에 대한 고무 코팅 또는 플라스틱 코팅 직물의 저항성을
Rubber- or plastics-coated fabrics-Determination of resistance to combined shear flexing and rubbing
오일 흡수 수(oil absorption number:OAN)는 카본 블랙이 액체를 흡수하
Rubber compounding ingredients-Carbon black-Determination of oil absorption number (OAN) and oil absorption number of compressed sample (COAN)
Rubber, vulcanized or thermoplastic - Determination of permeability to gases - Part 1 : differential-pressure methods.
Rubber, vulcanized or thermoplastic - Determination of permeability to gases - Part 2 : equal-pressure method.
Rubber - Calibration and verification of hardness testers.
Rubber, vulcanized or thermoplastic. Determination of permeability to gases. Equal-pressure method
This International Standard specifies the characteristics of rubber sheet floor coverings with backing. This International Standard includes a classification system based on intensity of use, which shows where resilient floor coverings should provide satisfactory service.
Resilient floor coverings - Specification for rubber sheet floor coverings with backing
Rubber. Calibration and verification of hardness testers
이 표준은 습윤 및 건조 마모에 대한 재료의 저항성을 측정하기 위한 두 가지 개별적인 방법
Rubber- or plastics-coated fabrics-Determination of abrasion resistance-Part 2:Martindale abrader
이 표준은 SBR 혼합물 내의 침전 함수 실리카의 물성 측정을 위한 시험 조성, 장치, 절
Rubber compounding ingredients-Silica, precipitated, hydrated-Part 2:Evaluation procedures in styrene-butadiene rubber
1.1 이 표준은 고무 업계에서 사용하기 위해 건조 분말로 분쇄된 천연 탄산 칼슘[백악(c
Rubber compounding ingredients-Natural calcium carbonate-Test methods
이 표준은 고무 배합 성분으로 사용되는 침전 함수 실리카의 특성을 규정하기 위한 시험방법을
Rubber compounding ingredients-Silica, precipitated, hydrated-Part 1:Non-rubber tests
Rubber compounding ingredients - Carbon black - Determination of sulfur content - Amendement 1 : clarification of digestion temperature in Subclause 3.4.5.
Rubber and rubber products - Determination of the composition of vulcanizates and uncured compounds by thermogravimetry - Part 2: Acrylonitrile-butadiene and halobutyl rubbers; Amendment 1
이 표준은 일정 속도의 인열 방법을 사용하여 코팅된 직물의 인열이 일어날 때부터 전파되는
Rubber- or plastics-coated fabrics-Determination of tear resistance-Part 1:Constant rate of tear methods
이 표준은 한정된 노출 기간이 지난 후에 규정된 저온에서 굽힘 시험을 받을 때 저온의 영향
Rubber- or plastics-coated fabrics-Low-temperature bend test
This International Standard specifies a method for the determination of the insulation resistance of vulcanized and thermoplastic rubbers without discrimination between the volume and surface resistances involved. This method should only be used for test pieces with a resistance greater than 108 Ω. NOTE Methods of test for test pieces with a lower resistance are described in ISO 1853 and ISO 2878. Because the test pieces are simply and easily prepared, this method is particularly useful for rapidly determining values which will give a general indication of quality when great accuracy is not required.
Rubber, vulcanized or thermoplastic - Determination of insulation resistance
警告——使用本标准的人员应有正规实验室工作的实践经验。本标准无意涉及因使用本标准可能出现的安全问题,使用者有责任采取适当的安全和健康措施,并保证符合国家有关法规规定的条件。 注意事项——本标准涉及的一些操作可能使用、生成一些物质或产生废物而对当地的环境有污染影响,应制订使用后处置这些物质的适当的文件。 本标准规定了测定硫化橡胶与薄片静摩擦系数和动摩擦系数的两种方法。 本标准方法A适用于硫化橡胶试样表面摩擦系数的测定,方法B适用于复印机、传真机等输送轮用的硫化橡胶试样反复摩擦过程中摩擦系数的测定。
Vulcanized rubber and slip.Determination of friction coefficient.Slipping method
警告——使用本标准的人员应有正规实验室工作的实践经验,本标准并未指出所有可能的安全问题,使用者有责任采用适当的安全和健康措施,并保证符合国家有关法规规定的条件。 本标准规定了用弹性模量测定器测定硫化橡胶弹性模量的方法。 本标准适用于硫化橡胶。
Vulcanized rubber.Determination of elastic modulus
警告——使用本标准的人员应有正规实验室工作的实践经验,本标准并未指出所有可能的安全问题,使用者有责任采用适当的安全和健康措施,并保证符合国家有关法规规定的条件。 本标准规定了用模量测定器测定硫化橡胶定伸永久变形的方法。 本标准适用于硫化橡胶。
Vulcanized rubber.Determination of rension set at a given elongation(Modulus tester method)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号