G73 表面活性剂 标准查询与下载

DLA A-A-97 REINST NOTICE 2-1999 (浓缩灯芯瓶)通用除臭剂

Commercial Item Description A-A-97, dated January 10, 1980, is hereby reinstated and may be used for acquisition.

DEODORANT, GENERAL PURPOSE (CONCENTRATED, WICK BOTTLE)

AIR FORCE MIL-PRF-83756 D-1998 爆破清洗机

Scope. This specification covers 2 types of dry blast cleaning machines for surface cleaning, surface conditioning and peening of ferrous and nonferrous metais using a blasting media.

BLAST CLEANING MACHINES

ISO 304:1985/cor 1:1998 表面活性剂 用拉起液膜法测定表面张力 技术勘误1

This is Technical Corrigendum 1 to ISO 304-1985 (Surface active agents — Determination of surface tension by drawing up liquid films )

Surface active agents - Determination of surface tension by drawing up liquid films; Technical Corrigendum 1

ASTM G121-98 评定清洗剂用的杂质试样制备的标准操作规程

1.1 This practice describes the procedure for the preparation of single and double-sided contaminated metallic test coupons for the evaluation of cleaning agents. It is applicable for the evaluation of cleaning agents proposed for the cleaning of oxygen-enriched systems and components. It also is applicable to other systems where contamination is a concern. 1.2 Several classes of contaminants most likely to be found in oxygen-enriched systems and components are identified. However, if the user of this practice has identified contaminants not included in these classes, such identified contaminants may be substituted for the preparation of the test coupons. 1.3 Preparation of nonmetallic substrates is not addressed, although similar methodology may be used. Solvent and cleaning agent compatibility with the nonmetallic substrate should be verified prior to the preparation of the test coupons. Typical nonmetallic materials utilized in oxygen systems are contained in Guide G63. 1.4 This practice may involve hazardous materials, operations, and equipment. This practice does not purport to address all of the safety problems associated with its use. It is the responsibility of whomever uses this practice to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents

ASTM G121-98(2010)e1 评定清洗剂用的杂质试样制备的标准实施规程

This practice will be suitable to direct the preparation of test coupons with a known amount of contaminant on the surface. A standard test coupon is described and a list of contaminants that have typically been found in oxygen-enriched systems and components is provided. These coupons shall be used in the evaluation of cleaning agents for oxygen-enriched systems and components. This will permit direct comparison within and between test facilities. Materials used in other fluid handling systems such as nitrogen, helium, hydrogen, gasoline, etc. may also be prepared for evaluation by this practice.1.1 This practice describes the procedure for the preparation of single- and double-sided contaminated metallic test coupons for the evaluation of cleaning agents. It is applicable for the evaluation of cleaning agents proposed for the cleaning of oxygen-enriched systems and components. It also is applicable to other systems where contamination is a concern. 1.2 Several classes of contaminants most likely to be found in oxygen-enriched systems and components are identified. However, if the user of this practice has identified contaminants not included in these classes, such identified contaminants may be substituted for the preparation of the test coupons. 1.3 Preparation of nonmetallic substrates is not addressed, although similar methodology may be used. Solvent and cleaning agent compatibility with the nonmetallic substrate should be verified prior to the preparation of the test coupons. Typical nonmetallic materials utilized in oxygen systems are contained in Guide G63. 1.4 This practice may involve hazardous materials, operations, and equipment. This practice does not purport to address all of the safety concerns associated with its use. It is the responsibility of whomever uses this practice to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents

ASTM F1872-98 化学海岸线清洁剂使用的标准指南:环境和操作研究

1.1 This guide covers the use of chemical cleaning agents on oiled shorelines. This guide is not applicable to other chemical agents nor to the use of such products in open waters. 1.2 The purpose of this guide is to provide information that will enable spill responders to decide whether to use chemical shoreline cleaning agents as part of the oil spill cleanup response. 1.3 This is a general guide only. It is assumed that conditions at the spill site have been assessed and that these conditions are suitable for the use of cleaning agents. It is assumed that permission has been obtained to use the chemical agents. Variations in the behavior of different types of oil are not dealt with in this guide and may change some of the parameters noted herein. 1.4 This guide covers two different types of shoreline cleaners: those that disperse oil into the water and those that disperse little oil into the water under low energy levels. The selection criteria for these two types can differ widely. This guide does not cover dispersants. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Guide for Use of Chemical Shoreline Cleaning Agents: Environmental and Operational Considerations

ASTM G121-98(2004) 评定清洗剂用的杂质试样制备的标准操作规程

This practice will be suitable to direct the preparation of test coupons with a known amount of contaminant on the surface. A standard test coupon is described and a list of contaminants that have typically been found in oxygen-enriched systems and components is provided. These coupons shall be used in the evaluation of cleaning agents for oxygen-enriched systems and components. This will permit direct comparison within and between test facilities. Materials used in other fluid handling systems such as nitrogen, helium, hydrogen, gasoline, etc. may also be prepared for evaluation by this practice. 1.1 This practice describes the procedure for the preparation of single- and double-sided contaminated metallic test coupons for the evaluation of cleaning agents. It is applicable for the evaluation of cleaning agents proposed for the cleaning of oxygen-enriched systems and components. It also is applicable to other systems where contamination is a concern. 1.2 Several classes of contaminants most likely to be found in oxygen-enriched systems and components are identified. However, if the user of this practice has identified contaminants not included in these classes, such identified contaminants may be substituted for the preparation of the test coupons. 1.3 Preparation of nonmetallic substrates is not addressed, although similar methodology may be used. Solvent and cleaning agent compatibility with the nonmetallic substrate should be verified prior to the preparation of the test coupons. Typical nonmetallic materials utilized in oxygen systems are contained in Guide G 63. This practice may involve hazardous materials, operations, and equipment. This practice does not purport to address all of the safety concerns associated with its use. It is the responsibility of whomever uses this practice to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents

BS EN 1791:1997 表面活性剂.脂肪烷基乙烷胺氧化物.胺氧化物含量测定

This European Standard specifies a method for the determination of up to approximately 2 milli-equivalents of tertiary amine oxide. Components which lose their basicity in reaction with acetic anhydride by forming an amide (e.g. primary and secondary amines) interfere. If present, these primary and secondary amines should be determined by a different procedure e.g. reaction with carbon sulfide. The method is applicable to solids or to aqueous solutions of the active material. The molecular mass of the amine oxide shall be known if its content is expressed as a percentage of mass.

Surface active agents - Fatty alkyl dimethyl amine oxides - Determination of the amine oxide content

BS EN 1557:1997 表面活性剂.运送过程中光学透明彩色液体(产品)X、Y、Z三色值色度特征

This European Standard specifies a method for the colorimetric characterization of optically clear, slightly tinted liquids (products) by broad-band measurement of pure transmittance with tristimulus value measuring filters as TX, TY and TZ. Since the tristimulus value measuring filters of simple tristimulus colorimeters meet the Luther condition to a limited extent only it is necessary to deliberately restrict the liquids (products) to slightly tinted ones in order to be able to measure them sufficiently exactly with a single calibration against uncoloured distilled water. If the colour of heavily coloured solutions is measured with simple tristimulus colorimeters, it is necessary to calibrate the instrument with a spectrometrically measured standard of very similar colour.

Surface active agents - Colorimetric characterization of optically clear coloured liquids (products) as X, Y, Z tristimulus values in transmission

DIN EN 1791:1997 表面活性剂.脂族烷基二甲胺化氧.氧化胺含量测定

The document specifies a method for the determination of up to approximately 1,5 milli-equivalents of tertiary amine oxide. Components which lose the basicity in reaction with acetic anhydride by forming an amide (e.g. primary and secondary amines) interfere. If present, these primary and secondary amines must be determined by a different procedure e.g. reaction with carbondisulfide. This method is applicable to solids or to aqueous solutions of the active material. The molecular mass of the amine oxide shall be known if its content is expressed as a percentage of mass.

Surface active agents - Fatty alkyl dimethyl amine oxides - Determination of the amine oxide content; German version EN 1791:1997

DIN EN 1557:1997 表面活性剂.X-,Y-和Z-传输三色值光学清晰着色液(产品)的色度特性

The document specifies a method for the colorimetric characterization of optically clear, slightly tinted liquids (products) by broad-band measurement of pure transmittance with tristimulus value measuring filters as T, T, T.#,,#

Surface active agents - Colorimetric characterization of optically clear coloured liquids (products) as X, Y, Z tristimulus values in transmission; German version EN 1557:1996

HY 044-1997 海洋石油勘探开发常用消油剂性能指标及检验方法

The specifications and test methods of dispersants in common use in offshore oil exploration and exploitation

NAVY MIL-PRF-29607 (1)-1997 航空电子组件用非臭氧层消耗型清洗剂

This amendment forms a part of MIL-PRF-29607(AS), dated 19 September 1996, and is approved for use by the Naval Air Systems Command, Department of the Navy and is available for use by ail Departments and Agencies of the Department of Defense.

CLEANING COMPOUND, AVIONICS COMPONENTS, NON-OZONE DEPLETING

DLA A-A-33 A-1997 (液体)除垢化合物

This CID covers a liquid form scale removing compound, hereinafter referred to as “compound,” intended for removing scale deposits from environmental surfaces, commercial dishwashing machines, and boiler coils. This compound can be used in laboratories, food handling and processing areas, veterinary areas, and dairy plants.

SCALE REMOVING COMPOUND (LIQUID)

NAVY MIL-PRF-29607-1996 航空电子组件用非臭氧层消耗型清洗剂

CLEANING COMPOUND, AVIONICS COMPONENTS, NON-OZONE DEPLETING

CLEANING COMPOUND, AVIONICS COMPONENTS, NON-OZONE DEPLETING

NAVY MIL-R-60862 NOTICE 2-1996 飞机座舱盖的修配,改进,转化清洗剂

MIL-R-60862(OS), dated 10 April 1968,is inactive for new design and is no longer used, except for replacement purposes

REMOVER, AIRCRAFT CANOPY, OVERHAUL, MODIFICATION AND CONVERSION OF

NAVY MIL-R-50776 NOTICE 3-1996 M8A2 飞机座舱盖装配件清洗剂

MIL-R-50776(OS), dated 5 April 1972,is inactive for new design and is no longerused, except for replacement purposes.

REMOVER, AIRCRAFT CANOPY, M8A2 ASSEMBLY

NAVY MIL-R-60875 NOTICE 1-1996 M8A2飞机座舱盖金属装配件清洗剂

MIL-R-60875(OS), dated 28 September 1973,is inactive for new design and is no longer used, except for replacement purposes.

REMOVER, AIRCRAFT CANOPY, M8A2 METAL PARTS ASSEMBLY

ASTM G122-96(2002) 评定清洗剂效果的标准试验方法

The purpose of this test method is to define a procedure for evaluating the capability of cleaning agents to clean metallic coupons. Based on the outcome of the testing, suitable cleaning agents may be selected for cleaning in general and for oxygen service in particular. The cleaning parameters can be changed and the test method can be repeated. The usual cleaning parameters include cleaning agent concentration, temperature, and time; type and strength of ultrasonic energy or agitation, if used, and others. Note 18212;Usual cleaning parameters are based on the manufacturerrsquo;recommendations.1.1 This test method covers a procedure for evaluating the capability of cleaning agents and processes to remove contamination to the desired level.1.2 The test coupons provide a relatively rough surface to which contamination can easily adhere.1.3 The capability of a particular cleaning agent depends upon the method by which it is used and the characteristics of the article being cleaned, such as size, shape, and material. Final evaluation of the cleaning agent should include testing of actual products and production process.1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 2.

Standard Test Method for Evaluating the Effectiveness of Cleaning Agents

ASTM G122-96 评定清洗剂效果的标准试验方法

1.1 This test method covers a procedure for evaluating the capability of cleaning agents and processes to remove contamination to the desired level. 1.2 The test coupons provide a relatively rough surface to which contamination can easily adhere. 1.3 The capability of a particular cleaning agent depends upon the method by which it is used and the characteristics of the article being cleaned, such as size, shape, and material. Final evaluation of the cleaning agent should include testing of actual products and production process. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 2.

Standard Test Method for Evaluating the Effectiveness of Cleaning Agents