J56 齿轮与螺纹加工机床 标准查询与下载
共找到 247 条与 齿轮与螺纹加工机床 相关的标准，共 17 页
本标准规定了螺纹铣床的几何精度和荼精度的要求及检验方法。 本标准适用于最大铣削直径小于或等于320mm的螺纹铣床。
Thread milling machine accuracy
- ICS
- CCS
- J56
- 发布
- 1991-07-09
- 实施
- 1992-07-01
Accuracy requirements and geometrical tests with reference to BS 3800.
Accuracy of machine tools and methods of test - Gear shaping machines
- ICS
- 25.080.99
- CCS
- J56
- 发布
- 1980-06-30
- 实施
- 1980-06-30
Accuracy requirements and geometrical tests with reference to BS 3800.
Accuracy of machine tools and methods of test - Gear planing machines
- ICS
- 25.080.25
- CCS
- J56
- 发布
- 1980-04-30
- 实施
- 1980-04-30
Boiler and Pressure Vessel.Ball screws; Errata
Ball screws; Errata
- ICS
- 25.060.10
- CCS
- J56
- 发布
- 1979-01-01
- 实施
1.1 This standard covers definitions, classes of ballscrews, recommended combinations of screw diametersand leads, recommended drawing format, and performancecharacteristics of ball screw and nut assembliesas applied to machine tools.1.2 The values stated in U.S. customary units are tobe regarded as the standard. Metric values are convertedfrom the customary values per recommendationsof 'ASME Guide SI-I, ASME Orientation andGuide for Use of SI (Metric) Units'.
Ball Screws Errata
- ICS
- 25.060.10
- CCS
- J56
- 发布
- 1977-03
- 实施
本标准规定了齿轮加工机床的完好要求和检查、评定方法。 本标准适用于滚齿机、插齿机、直齿锥齿刨齿机、剃齿机、珩齿机。其它类型的齿轮加工机床亦可参照执行。
Requirements of readiness and methods of inspection and assessment for gear cutting machines
- ICS
- 25.080.99
- CCS
- J56
- 发布
- 实施
本标准规定了齿轮倒角机的完好要求和检查、评定方法。 本标准适用于各种机型的齿轮倒角机。
Requirements of readiness and methods of inspection and assessment for gear tooth chamfering machines
- ICS
- 25.080.99
- CCS
- J56
- 发布
- 实施
