J73 制冷设备 标准查询与下载

BS EN 13771-1:2003 制冷用压缩机和冷凝装置.性能检验和试验方法.制冷压缩机

This part of this European Standard applies only to refrigerant compressors and describes a number of selected performance test methods. These methods provide sufficiently accurate results for the determination of the refrigerating capacity, power absorbed, refrigerant mass flow, isentropic efficiency and the coefficient of performance. This standard applies only to performance tests conducted at the manufacturer's works or wherever the equipment for testing to the accuracy required is available. The type of measuring instrument and the allowable uncertainty within which measurements shall be made are listed in normative annex A.

Compressor and condensing units for refrigeration - Performance testing and test methods - Part 1:Refrigerant compressors

BS PAS 57:2003 地下室冷却设备.测定性能和计算能效的规程

Cellar cooling equipment - Procedure for determining performance and calculating energy efficiency

ARI 490-2003 远程机械通风蒸汽冷却冷凝器

This standard applies to Remote Type Refìigerant-Cooled Liquid Coolers of the Sheil-and-Tube, Sheil-and-U-Tube, Sheil-and-Coil, and Tube-in-Tube types using single component and azeotropic reûigeranîs only.

Remote Mechanical-Draft Evaporatively-Cooled Refrigerant Condensers

ARI 550/590-2003 使用蒸汽压缩循环的水冷却

This standard applies to factory-made vapor compression refrigeration Water-Chilling Packages including one or more hermetic or open drive compressors. These Water-Chilling Packages include

Water Chilling Packages Using the Vapor Compression Cycle

ANSI/ASHRAE 147-2003 降低制冷,空调设备和系统中卤化物制冷剂的排放

Reducing the Release of Halogenated Refrigerants from Refrigerating and Air-Conditioning Equipment and Systems

ARI 810-2003 自动商业制冰机作业评定

This standard applies to factory-made Automatic Commercial Ice-Makers as defined in Section 3.

PERFORMANCE RATING OF AUTOMATIC COMMERCIAL ICE-MAKERS

DIN EN 13648-3:2003 低温容器.超压安全装置.第3部分:规定的排放量、容量和尺寸测定

This standard provides a separate calculation method for determing the contributing mass flow to be relieved resulting from each of the in the standard specified conditions.

Cryogenic vessels - Safety devices for protection against excessive pressure - Part 3: Determination of required discharge; Capacity and sizing; German version EN 13648-3:2002

DIN 2405:2003 制冷系统和冷却设备中的管道.标志

The document applies to pipilines for refrigerants, coolants and heat transfer media in refrigerating systems and cooling equipment which are not intergrated within a sealed unit system.#,,#

Pipelines in refrigerating systems and cooling equipment - Marking

ANSI/AHRI 810-2003 自动商业制冰机的性能评估

This standard applies to factory-made Automatic Commercial Ice-Makers.

Performance Rating of Automatic Commercial Ice-Makers (formerly ANSI/ARI 810-2003)

ANSI/ARI 810-2003 机械造冰器的性能评定

This standard applies to factory-made Automatic Commercial Ice-Makers.

Performance Rating of Automatic Commercial Ice-Makers

SB/T 10355-2002 制冷系统和热泵-软管件、隔振器和膨胀接头-要求、设计与安装

本标准阐述了制冷系统和热泵的制冷剂回路中采用软管件的要求、设计及其安装，(这些软管件包括金属软管，金属挠管，非金属软管，隔振器，膨胀接头)。 对于只偶然超出弹性极限的受力情况，如在修理过程中，或与自由转动或铰接的接头相连时，软管不适用。

Refrigerating systems and heat pumps-Flexible pipe elements,vibration isolators and expansion joints-Requirements,design and installation

DIN 8901:2002 制冷系统和加热泵.土壤、土地和地表水的保护.安全性和环境要求与试验

Refrigerating systems and heat pumps - Protection of soil, ground and surface water - Safety and environmental requirements and testing

ANSI/NSF 6-2002 配量冷藏设备

Updates microbial sampling techniques for in-place cleaning evaluation with more current and accurate methodologies. This standard was listed for public review in the 3/9/2001 issue of Standards Action. It is being resubmitted due to substantive changes to the text. (Issue 2)

Dispensing Freezers

IEEE 841/INT 1-2-2002 IEEE Std 841™-1994用IEEE标准解释文件.石油和化学工业强重型完全闭合式风扇冷却(TEFC)的小于等于500 hp贮藏笼感应电动机用IEEE标准

IEEE Standards Interpretation for IEEE Std 841™-1994 IEEE Standard for the Petroleum and Chemical Industry-Severe Duty Totally Enclosed Fan-Cooled (TEFC) Squirrel Cage Induction Motors-Up to and Including 500 hp

IEEE Standards Interpretation for IEEE Std 841™-1994 IEEE Standard for the Petroleum and Chemical Industry-Severe Duty Totally Enclosed Fan-Cooled (TEFC) Squirrel Cage Induction Motors-Up to and Including 500 hp

JIS B 8625:2002 空调用冰蓄热元件.试验方法

この規格は,空気調和用熱源及び蓄熱に用いるアイス・オン・コイル製氷方式の空冷式及び水冷式氷蓄熱ユニット(以下,氷蓄熱ユニットという。)の試験方法について規定する。

Ice thermal storage units for air conditioning purpose -- Test methods

JIS B 8624:2002 冰蓄热系统.词汇

この規格は，空気調和用の氷蓄熱システムに関すろ用語及びそめ定義についで規定する。

Ice thermal storage systems -- Vocabulary

DIN EN 13648-2:2002 冷冻容器.防超压保护安全设施.第2部分:冷冻设备用防爆板安全设施; 德文版本 EN 13648-2:2002

This European Standard specifies the requirements for the design, manufacture and testing of bursting disc safety devices for cryogenic service, i.e. for operation with cryogenic fluids below -10 ?in addition to operation at ambient temperature. It is a requirement of this standard that the bursting disc safety device(s) comply with prEN ISO 4126-2. In the event of different requirements, this standard takes precedence over that standard. This standard is restricted to bursting disc safety devices not exceeding a size of DN 100 designed to relieve single phase vapours or gases. A bursting disc assembly can be specified, constructed and tested such that it is suitable for use with more than one gas or with mictures of gases. Note: This standard does not provide methods for determining the capacity of bursting disc safety devices for a particular cryogenic vessel. Such methods are provided in prEN 12648-3.

Cryogenic vessels - Safety devices for protection against excessive pressure - Part 2: Bursting disc safety devices for cryogenic service; German version EN 13648-2:2002

JIS B 8620:2002 小型冷冻设备的安全性规则

この規格は，圧縮機を使用する小形冷凍装置の冷媒圧力に対する安全を確保するため,冷媒圧力を受ける部分の構造について規定する。小形冷凍装置とは,一つの冷媒循環系統の呼び冷凍能力が767 W以上， 19.3 kW未満の冷凍装置で，温度35℃において飽和蒸気圧力が0.2 MPaを超え，3 MPa以下の実用的な不燃性かつ非毒性の冷媒を使用する冷凍装置をいう。ただし，次に示すものを除く。

Safety code for small refrigerating equipment

JIS B 8622:2002 吸收式冷冻机

この規格は，冷媒に水，吸収液として臭化リチウム水溶液を使用し，再生器又は高温再生器に加熱源を供給することによって(再生器，高温再生器，低温再生器を含む。)，凝縮器。吸収器，蒸発器などによる吸収冷凍サイクルを構成し，水の冷却又は加熱を行う吸収式冷凍機(以下，冷凍機という。)のうち，冷凍能力が単体で25 kW以上のものについて規定する。

Absorption refrigerating machines

CSA C743-02-2002 水冷凝机组评级的性能标准.第2版

Performance Standard for Rating Packaged Water Chillers Second Edition

Performance Standard for Rating Packaged Water Chillers Second Edition