K14 电工合金零件 标准查询与下载

ASTM B603-90(2001) 电加热元件的拉伸或辊轧铁铬铝合金规范

1.1 This specification covers annealed, drawn, or rolled shapes for electrical heating and resistance purposes of alloys consisting mainly of iron, chromium, and aluminum as detailed in Table 1. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Standard Specification for Drawn or Rolled Iron-Chromium-Aluminum Alloys for Electrical Heating Elements

KS C 2601-1987 电热合金线及带

이 규격은 니켈 및 크롬 또는 철, 크롬 및 알루미늄을 주성분으로 하여,발열체에 사용하는

Wires and Rolled Wires for Electrieal Heating

JIS C 2522:1986 铜锰电阻丝、棒及板

Copper-manganese alloy wires, bars and sheets for electrical resistance

JIS C 2520:1986 用于电加热的线及轧线

Wires and rolled wires for electrical heating

JIS C 2521:1986 铜镍电阻丝、带、条及板

Copper-nickel alloy wires, rolled wires, ribbons and sheets for electrical resistance

DIN 46453-6:1986 绕组线.第6部分:电阻丝直流电阻温度系数的试验方法

Winding wires; resistance wires, test method of the temperature coefficient of the direct current resistance

DIN 46460-1:1986 绕组线.圆形电阻裸线.第1部分:交货技术条件

Winding wires; round resistance wires, bare; technical terms of delivery

JB/T 8146-1995 铸造铝镍钴永磁(硬磁)合金技术条件

Technical requirements for permanent magnetic (magnetically hard) alloy of cast aluminiumnickel-cobalt

DIN 17470:1984 加热导体合金.圆金属丝和扁平金属丝的交付技术状态

Heating conductor alloys; technical delivery conditions for round and flat wire

DIN 1715-1:1983 恒温器用金属.交货技术条件

Thermostatic bimetals, technical conditions of delivery Bimetaux (Bilames thermiques), conditions techniques de livraison

Thermostat metals; technical delivery conditions

DIN 1715-2:1983 恒温器用金属.热曲率比的检验

Thermostatic bimetals; Testing specific thermal curvature Bimetaux; Essais de la courbure thermique specifique

Thermostat metals; testing the specific thermal curvature

DIN 17471:1983 电阻器材料.性能

Electrical resistors material; properties

Resistance alloys

HB 3286-1979 磁铁棒

magnet bar

DIN 46464:1981 绕组线.氧化绝缘圆电阻线.交货技术条件

Winding wires, round resistance-wires oxide-insulated; technical terms of deliveryFür den Geltungsbereich dieser Norm bestehen keine entsprechenden regionalen oder internationalen Normen.

Winding wires; round resistance-wires oxide-insulated; technical terms of delivery

DIN 46463:1981 绕组线.镍电阻合金圆裸线.尺寸、电阻值、重量

Winding wires; bare round Ni-resistance wires; dimensions, resistances, weightsZusammenhang mit der von der International Electrotechnical Commission (IEC) herausgegebenen Publikation 182-4/1971, siehe Erl?uterungen.

Winding wires; bare round Ni-resistance wires; dimensions, resistances, weights

DIN 48200-2:1981-04 绞线用青铜线

Bronze wires for stranded conductorsFür den Geltungsbereich dieser Norm bestehen keine entsprechenden regionalen oder internationalen Normen.

Bronze wires for stranded conductors

HB 3233-1979 保险接头（接增压器部分）

Insurance joint (connected to supercharger part)

ASTM B615-79(2011) 滑动电触头电接触噪声测量的标准操作规程

Resistance or voltage values alone do not provide sufficient detail for an engineering evaluation of contact noise. This practice lists the test conditions that should be reported with noise measurements and indicates some conditions (open circuit voltages, currents, etc.) that have been used for quality control and research studies. The use of these practices should provide sufficient detail for an engineering interpretation of the noise data and allow the tests to be repeated by another laboratory. 1.1 This practice describes the practices and factors considered to be most important in the measurement of electrical contact noise of sliding contacts. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Standard Practice for Measuring Electrical Contact Noise in Sliding Electrical Contacts

DIN 46460-2:1977 绕组线.第2部分:V 型自熔性漆包电阻合金圆线.交货技术条件

Winding wires, round resistance wires; self-fluxing enamelled, type V, technical terms of deliveryEine Publikation (bzw. Entwurf) der IEC für den Geltungsbereich dieser Norm besteht nicht.

Winding Wires; Round Resistance Wires, Enamelled, Self-fluxing, Type V; Technical Conditions of Delivery

DIN 46460-3:1977 绕组线.第3部分:W 180 型温度指数为 180 的耐热漆包电阻合金圆线.交货技术条件

Winding wires, round resistance wires; enamelled, with a temperature index of 180, type W 180, technical terms of deliveryEine Publikation (bzw. Entwurf) der IEC für den Geltungsbereich dieser Norm besteht nicht.

Winding Wires; Round Resistance Wires, Enamelled, Heat-resistant with a Temperature Index of 180, Type W 180; Technical Conditions of Delivery