共找到 3986 条与 电工绝缘材料及其制品 相关的标准,共 266 页
Pressure wave test method for space charge distribution in solid insulating materials
Flexible polyolefin heat shrinkable tube
Flame retardant polyolefin heat shrink tubing
Multi-factor aging test method and evaluation method for marine variable frequency motor stator winding
Semi-rigid polyolefin heat shrink tubing
Polyolefin heat shrinkable tube for busbar insulation
Test method for insulation properties of flexible insulating lining materials for laminated busbars
Non-flame retardant double wall polyolefin heat shrink tubing
Electroacoustic pulse test method for space charge distribution in solid insulating materials
Solid electrical insulating materials -- Test methods for electric strength -- Part 1: Tests at power frequencies
Solid electrical insulating materials -- Standard conditions for use prior to and during the testing
Solid electrical insulating materials -- Test methods for electric strength -- Part 2: Tests using direct voltage
Solid electrical insulating materials -- Test methods for electric strength -- Part 3: Tests using impulse voltage
Electrical insulating materials and systems - A.C. voltage endurance evaluation (IEC 61251:2015); German version EN 61251:2016
Travaux sous tension - Dispositifs de protection isolants et accessoires pour les installations électriques en basse tension
The purpose of this part of IEC 60216, which is a Technical Report, is to validate the procedures of IEC TS 60216-7-1 in providing a similar temperature index to conventional methods used in other parts of the IEC 60216 series. These round robin test results do not provide statistical analysis for precisions. The round robin test focuses on preliminary studies to understand the evaluation and calculation procedures, influence on apparatus, and data variance among laboratories before determination of precisions.
Electrical insulating materials - Thermal endurance properties - Part 7-2: Results of the round robin tests to validate procedures of IEC TS 60216-7-1 by non-isothermal kinetic analysis of thermogravimetric data
IEC TS 61463, which is a Technical Specification, is applicable to alternating current and direct current bushings for highest voltages above 52 kV (or with resonance frequencies placed inside the seismic response spectrum), mounted on transformers, other apparatus or buildings. For bushings with highest voltages less than or equal to 52 kV (or with resonance frequencies placed outside from the seismic response spectrum), due to their characteristics, seismic qualification is not used as far as construction practice and seismic construction practice comply with the state of the art. This document presents acceptable seismic qualification methods and requirements to demonstrate that a bushing can maintain its mechanical properties, insulate and carry current during and after an earthquake. The seismic qualification of a bushing is only performed upon request.
Bushings - Seismic qualification
Resin based reactive compounds used for electrical insulation - Part 2: Methods of test (IEC 60455-2:2015); German version EN 60455-2:2015
OGS显示屏化学强化制程中具有抗静电和耐酸保护功能的薄膜
Antistatic acid-resistant protective film
Glands for electrical cables - Cables screw bushings
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号