K15 电工绝缘材料及其制品 标准查询与下载

IEC 60243-1:2013 绝缘材料电气强度.试验方法.第1部分:工业频率试验

This part of IEC 60243 provides test methods for the determination of short-time electric strength of solid insulating materials at power frequencies between 48 Hz and 62 Hz. This standard does not cover the testing of liquids and gases@ although these are specified and used as impregnates or surrounding media for the solid insulating materials being tested. NOTE Methods for the determination of breakdown voltages along the surfaces of solid insulating materials are included.

Electric strength of insulating materials - Test methods - Part 1: Tests at power frequencies

IEC 62068:2013 电绝缘材料和系统.反复电压脉冲下电气耐久性评价的通用方法

This International Standard applies to electrical equipment@ regardless of voltage@ containing an insulation system@ which is ?C connected to an electronic power supply@ and ?C requires an evaluation of insulation endurance under repetitive voltage impulses. This standard proposes a general test procedure to facilitate screening of electrical insulating materials (EIM) and systems (EIS) and to achieve a relative evaluation of insulation endurance under conditions of repetitive impulses.

Electrical insulating materials and systems - General method of evaluation of electrical endurance under repetitive voltage impulses

JIS C 2143-3:2013 电气绝缘材料.耐热性.第3部分:耐热性的计算说明

Electrical insulating materials -- Properties of thermal endurance -- Part 3: Instructions for calculating thermal endurance characteristics

JIS C 2143-5:2013 电气绝缘材料.耐热性.第5部分:相关耐热指数(RTE)的测定

Electrical insulating materials -- Properties of thermal endurance -- Part 5: Determination of relative thermal endurance index (RTE)

JIS C 2336 ERRATUM 1:2013 勘误表

ERRATUM

ANSI/ASTM D2671:2013 电气用热收缩管道系统的试验方法

Test Methods for Heat-Shrinkable Tubing for Electrical Use

ANSI/ASTM D4325:2013 非金属半导体和电绝缘胶带用试验方法

Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes

ANSI/ASTM D348:2013 电气绝缘用刚性管的试验方法

Test Methods for Rigid Tubes Used for Electrical Insulation

ANSI/ASTM D349:2013 电气绝缘用层压圆杆材的试验方法

Test Methods for Laminated Round Rods Used for Electrical Insulation

ANSI/ASTM D876:2013 电气绝缘用非刚性氯乙烯高聚物管材的试验方法

Test Methods for Nonrigid Vinyl Chloride Polymer Tubing Used for Electrical Insulation

ANSI/ASTM D2148:2013 电绝缘用硅胶带试验方法

Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation

ANSI/ASTM D4388:2013 非金属半导体和电绝缘胶带用规范

Specification for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes

ANSI/ASTM D2656:2013 额定电压2001至35000 V的电线和电缆用交联聚乙烯绝缘材料的规格

Specification for Crosslinked Polyethylene Insulation for Wire and Cable Rated 2001 to 35 000 V

ANSI/ASTM D374M:2013 固体电绝缘材料厚度的试验方法(米制)

Test Methods for Thickness of Solid Electrical Insulation (Metric)

ANSI/ASTM D710:2013 电气绝缘用硫化纤维板,棒和管材规范

Specification for Vulcanized Fibre Sheets, Rods, and Tubes Used for Electrical Insulation

ANSI/ASTM D3145:2013 用螺旋线圈法对电绝缘清漆耐热性的试验方法

Test Method for Thermal Endurance of Electrical Insulating Varnishes by the Helical Coil Method

ANSI/ASTM D229:2013 电气装置用硬板和厚板材的试验方法

Test Methods for Rigid Sheet and Plate Materials Used for Electrical Insulation

ANSI/ASTM D1458:2013 电绝缘用完全硫化硅橡胶涂层玻璃布与玻璃带的试验方法

Test Methods for Fully Cured Silicone Rubber-Coated Glass Fabric and Tapes for Electrical Insulation

ANSI/NEMA HP5-2013 改良聚乙烯(XLPE)绝缘,125 C连接线缆,L(600 V)型, LL (1000 V),以及LX (3000 V)电子电气交联

Electrical and Electronic Crosslinked, Modified Polyethylene (XLPE) Insulated, 125 C Hook-UP Wire, Types L (600 V), LL (1000 V), and LX (3000 V)

ANSI/ASTM D350:2013 电绝缘用经处理软套管的试验方法

Test Methods for Flexible Treated Sleeving Used for Electrical Insulation