K42 电力电容器 标准查询与下载

JB/T 8957-1999 校验电容器损耗角正切测量准确度的方法

本校验损耗角正切的方法适用于额定频率为15Hz到60Hz的并联电容器和串联电容器，并可穿插在相应标准规定的热稳定试验的过程之中。

Method for verifying accuracy of tan delta measurements applicable to capacitors

JB/T 8168-1999 脉冲电容器及直流电容器

本标准规定了脉冲电容器及直流电容器的产品分类、技术要求、试验方法、检验规则以及标志等。 本标准适用于脉冲电容器及直流电容器。这些电容器主要用于： a)冲击电压发生器、冲击电流发生器、冲击分压器及其他非连续脉冲装置； b)振荡回路、连续脉冲装置； c)直流高压设备及整流滤波装置。

Pulse capacitors and direct current capacitors

JB/T 8958-1999 自愈式高电压并联电容器

本标准规定了自愈式高电压并联电容器的技术要求、试验方法、检验规则以及标志等。 本标准适用于并联连接于额定电压为1000 V以上，频率为50Hz的交流电力系统中，用来改善功率因数的自愈式高电压并联电容器。

High voltage shunt capacitor of the self-healing type

JB/T 9693-1999 电力电容器.产品系列型谱

本型谱规定了电力电容器产品系列的划分及有关参数值。 本型谱适用于电力电容器单台产品和装置。

Series of power capacitor products

JB/T 8169-1999 耦合电容器及电容分压器

本标准规定了耦合电容器及电容分压器的产品分类、技术要求、试验方法、检验规则以及标志等。 本标准适用于下列电容器： a)工频为50Hz或60Hz、载波频率范围为30～500 kHz的电力线载波系统用的耦合电容器； b)电容式电压互感器的电容分压器； c)有一个端子永久接地或处于低电位的过电压保护和其他类似用途的电容器。

Coupling capacitors and capacitor dividers

JB/T 8970-1999 高压并联电容器用放电线圈

　　本标准规定了高压并联电容器用放电线圈的技术要求、性能参数、试验方法、检验规则及标志、包装、运输和贮存。 　　本标准适用于额定频率为50Hz、电压等级为6~66kV级电力系统中与高压并联电容器组相并联的、用以在短时间内释放电容器组上的剩余电荷的高压并联电容器用单相放电线圈。当放电线圈有二次绕组时，可供给电气保护装置用。

Discharge coils for high voltage shunt capacitors

DIN EN 60143-3:1999 电力系统的串联电容器.第3部分:内部熔断器

Series capacitors for power systems - Part 3: Internal fuses (IEC 60143-3:1998); German version EN 60143-3:1998

KS C 4617-1998 地下线路的故障断电器(22.9kV-y)

이 규격은 22.9kV-Y 지중 배전 선로에서 지상 옥내 외에 설치되어 선로의 고장 구간

Fault interrupter for underground line

BS EN 60110-1:1998 用于感应加热装置的电力电容器 一般的

Applicable to indoor capacitor units and banks used particularly for power factor correction with controlled a.c. voltage systems up to 50 Hz, 3.6k V.

Power capacitors for induction heating installations. General

BS EN 60931-1:1998

This part of IEC 931 is applicable to both capacitor units and capacitor banks intended to be used, particularly, for power-factor correction of a.c. power systems having a rated voltage up to and including 1000 V and frequencies 15 Hz to 60 Hz. This part of IEC 931 also applies to capacitors intended for use in power filter circuits. Additional definitions, requirements, and tests for filter capacitors are given in annex A. Additional requirements for capacitors protected by internal element fuses, as well as requirements for the same, are given in IEC 931-3. The following capacitors are excluded from this part of IEC 931: - Shunt power capacitors of the self-healing type for a.c. systems having a rated volt-age up to and including 1000 V (IEC 831). - Shunt capacitors for a.c. power systems having a rated voltage above 1000 V (IEC 871). - Capacitors for inductive heat-generating plants operating at frequencies between 40 Hz and 24 000 Hz (IEC 110). - Series capacitors (IEC 143). - Capacitors for motor applications and the like (IEC 252). - Coupling capacitors and capacitor dividers (IEC 358). - Capacitors to be used in power electronic circuits (IEC 1071). - Small a.c. capacitors to be used for fluorescent and discharge lamps (IEC 1048 and IEC 1049). - Capacitors for suppression of radio interference (under consideration). - Capacitors intended to be used in various types of electrical equipment and thus considered as components. - Capacitors intended for use with d.c. voltage superimposed on the a.c. voltage. Accessories such as insulators, switches, instrument transformers, fuses, etc., are to be in accordance with the relevant IEC standards. a) to formulate uniform rules regarding performances, testing and rating; b) to formulate specific safety rules; c) to provide a guide for installation and operation.

NF C54-146:1998 电力系统用串联电容器.第3部分:内熔断器

Series capacitors for power systems. Part 3 : internal fuses.

IEC 60110-1:1998 感应加热装置用电力电容器 第1部分:总则

This part of IEC 60110 is applicable both to indoor capacitor units and indoor capacitor banks intended to be used, particularly, for power factor correction in induction heating, melting, stirring or casting installations, and similar applications with controlled or adjustable a.c. voltage systems in a frequency range up to 50 kHz, and with a rated voltage not exceeding 3,6 kV. Additional requirements for capacitors protected by internal element fuses are given in IEC 60110-2. The following capacitors are excluded from this standard: - series capacitors for power systems (see IEC 60143); - capacitors for motor applications and the like (see IEC 60252); - coupling capacitors and capacitor dividers (see IEC 60358); - shunt power capacitors of the self-healing type for a.c. systems having a rated voltage up to and including 1000 V (see IEC 60831); - shunt capacitors for a.c. power systems having a rated voltage above 1000 V (see IEC 60871); - shunt capacitors of the non-self-healing type for a.c. systems having a rated voltage up to and including 1000 V (see IEC 60931); - small a.c. capacitors to be used for fluorescent and discharge lamps (see IEC 61048 and IEC 61049); - capacitors to be used in power electronic circuits (see IEC 61071); - capacitors for microwave ovens (see IEC 61270); - capacitors for suppression of radio interference (under consideration); - capacitors intended for use with d.c. voltage superimposed on the a.c. voltage. Accessories such as insulators, switches, instrument transformers, fuses, etc., shall be in accordance with the relevant IEC standards. The object of this standard is: a) to formulate uniform rules regarding performance, testing and rating; b) to formulate specific safety rules; c) to provide a guide for installation and operation.

Power capacitors for induction heating installations - Part 1: General

BS EN 60831-1:1998 额定电压小于等于1 kV的交流电系统用自动恢复功能型分流电力电容器.总则.性能,测试及评定.安全性要求.安装及操作指南

This part of IEC 831 is applicable to both capacitor units and capacitor banks intended to be used, particularly, for power-factor correction of a.c. power systems having a rated voltage up to and including 1000 V and frequencies 15 Hz to 60 Hz. This part of IEC 831 also applies to capacitors intended for use in power filter circuits. Additional definitions, requirements, and tests for filter capacitors are given in annex A. The following capacitors are excluded from this part of IEC 831: - Shunt power capacitors of the non-self-healing type for a.c. systems having a rated voltage up to and including 1000 V (IEC 931). - Shunt capacitors for a.c. power systems having a rated voltage above 1000 V (IEC 871). - Capacitors for inductive heat-generating plants operating at frequencies between 40 Hz and 24 000 Hz (IEC 110). - Series capacitors (IEC 143). - Capacitors for motor applications and the like (IEC 252). - Coupling capacitors and capacitor dividers (IEC 358). - Capacitors to be used in power electronic circuits (IEC 1071). - Small a.c. capacitors to be used for fluorescent and discharge lamps (IEC 1048 and IEC 1049). - Capacitors for suppression of radio interference (under consideration). - Capacitors intended to be used in various types of electrical equipment, and thus considered as components. - Capacitors intended for use with d.c. voltage superimposed on the a.c. voltage. Accessories such as insulators, switches, instrument transformers, fuses, etc., should be in accordance with the relevant IEC standards. The object of this part of IEC 831 is to: a) formulate uniform rules regarding performances, testing and rating; b) formulate specific safety rules; c) provide a guide for installation and operation.

Shunt power capacitors of the self-healing type for a.c. systems having a rated voltage up to and including 1kV - General - Performance, testing and rating - Safety requirements - Guide for installation and operation

DL/T 653-1998 高压并联电容器用放电线圈订货.技术条件

Specification of discharge coils for high voltage shunt capacitor for order

NF C54-102:1998 额定电压大于 1 kV 的交流电力系统用分流电容器.第1部分:总则.性能、试验和额定值.安全要求.安装和操作指南

Shunt capacitors for a.c. power systems having a rated voltage above 1 kV. Part 1 : general. Performance, testing and rating. Safety requirements. Guide for installation and operation.

IEC 60143-3:1998 电力系统用串联电容器 第3部分:内部熔丝

This part of IEC 60143 concerns internal fuses designed to isolate faulty capacitor elements, to allow operation of the remaining parts of that capacitor unit and the bank in which the capacitor unit is connected. Such fuses are not a substitute for a switching device such as a circuit-breaker, or for external protection of the capacitor bank, or any part thereof. The object of this standard is - to formulate requirements regarding performance and testing; - to provide a guide for coordination of fuse and bank protection. NOTE - External fuses for series capacitors are treated in IEC 60143-1, annex A: "Test requirements and application guide for external fuses and units to be externally fused".

Series capacitors for power systems - Part 3: Internal fuses

IEC 60871-1/COR1:1998 额定电压1000V以上交流电力系统用并联电容器.第1部分:总则.性能、试验和定额.安全要求.安装和运行导则

Shunt capacitors for a.c. power systems having a rated voltage above 1000 V - Part 1: General - Performance, testing and rating - Safety requirements - Guide for installation and operation

IPC TM-650 5.5.4.10-1998 试件H -电容和电流密度

To determine the e..-ct on the connector of prolonged exposure to conditions of high humindity at various temperatures. Two conditions of test are provided as follows

Test Coupon H - Capacitance and Current Density

KS C 4802-1997 高压电力电容器

이 규격은 역률개선, 전압 조정 등을 목적으로 송배전 계통의 교류 3300V 이상의 회로에

High voltage power condenser

DL/T 628-1997 集合式高压并联电容器订货技术条件

Specification of collective high-voltage shunt capacitor for order