K48 绝缘子 标准查询与下载

IEC 61462:2007 复合空心绝缘子.使用在额定电压大于1000伏的电气设备用受压和未受压绝缘子.定义、试验方法、验收标准和设计建议

This International Standard applies to composite hollow insulators consisting of a load-bearing insulating tube made of resin impregnated fibres, a housing (outside the insulating tube) made of elastomeric material (for example silicone or ethylene-propylene) and metal fixing devices at the ends of the insulating tube. Composite hollow insulators as defined in this standard are intended for general use (unpressurized) or for use with a permanent gas pressure (pressurized). They are intended for use in both outdoor and indoor electrical equipment operating on alternating current with a rated voltage greater than 1 000 V and a frequency not greater than 100 Hz or for use in direct current equipment with a rated voltage greater than 1 500 V.

Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1000 V - Definitions, test methods, acceptance criteria and design recommendations

DIN CLC/TS 50458:2006 浸油变压器用52 kV～420 kV电容式穿墙套管

This Technical Specification is applicable to capacitance graded outdoor bushings with values of highest voltage for equipment (U) from 52 kV up to 420 kV and with values of rated current (I) up to 3150 A and frequencies from 15 Hz up to 60 Hz for oil immersed transformers. The major insulation of these bushings consists either of oil-impregnated or resin-impregnated paper or other suitable insulating systems. This Technical Specification establishes essential details and dimensions to ensure interchangeability and adequate mounting of the bushings.

Capacitance graded outdoor bushing 52 kV up to 420 kV for oil immersed transformers; German version CLC/TS 50458:2006

KS C 3834-2006 供电线用悬式绝缘子

이 규격은 전기 철도용 급전선로에 사용하는 자기제의 핀 애자(이하 애자라고 한다.)에 대하

Pin type insulators for feeder

SANS 62217:2006 标称电压大于1000伏的室内及室外用复合绝缘子.一般定义、试验方法及验收标准

Applies to polymeric insulators whose insulating body consists of one or various organic materials. Polymeric insulators covered by this standard include both solid core and hollow insulators. They are intended for use on overhead lines and in indoor and outdoor equipment with a rated voltage greater than 1 000 V.

Polymeric insulators for indoor and outdoor use with a nominal voltage >1000 V - General definitions, test methods and acceptance criteria

CSA C62155-06-CAN/CSA-2006 额定电压大于1000伏电气设备用空心增压和未增压陶瓷和玻璃绝缘子

Hollow pressurized and unpressurized ceramic and glass insulators for use in electrical equipment with rated voltages greater than 1 000 V

Hollow pressurized and unpressurized ceramic and glass insulators for use in electrical equipment with rated voltages greater than 1 000 V

SANS 62231:2006 交流电压大于1000V小于等于245 KV的复合电站支柱绝缘子．定义、测试方法和验收标准

Defines the terms used, prescribes test methods and acceptance criteria for composite station post insulators of a load bearing cylindrical insulating solid core type intended for use in substations with a.c. voltages greater than 1 000 V up to 245 kV.

Composite station post insulators for substations with a.c. voltages greater than 1000 V up to 245 kV - Definitions, test methods and acceptance criteria

JB/T 10586-2006 高压线路蝶式瓷绝缘子

本标准规定了高压线路蝶式瓷绝缘子（以下简称绝缘子）的形状与尺寸、技术要求、试验方法、试验项目以及包装与标志。 本标准适用于标称电压高于1000V的架空线路用高压线路蝶式瓷绝缘子。 本标准不适用于在能破坏瓷和釉的介质中使用的高压线路蝶式瓷绝缘子。

Shackle insulators of ceramic material for high voltage overhead lines

JB/T 10587-2006 电工术语.电瓷专用设备

本标准规定了电瓷专用制造设备及其零部件与特性以及电瓷专用检测设备的术语和定义。 本标准适用于电瓷专用设备。

Electrotechnical terminology.Special equipments for porcelain insulators

JB/T 10585.1-2006 低压电力线路绝缘子.第1部分:低压架空电力线路绝缘子

JB/T 10585的本部分规定了低压架空电力线路绝缘子的产品型式和尺寸、技术要求、试验方法、检验规则以及包装与标志。 本部分适用于直流或工频交流额定电压低于1000V的架空电力线路中作绝缘和固定导线用的绝缘子（以下简称绝缘子），包括低压线路针式绝缘子（简称针式绝缘子）、低压线路蝶式绝缘子（简称蝶式绝缘子）、低压线路线轴式绝缘子（简称线轴式绝缘子）。 本部分不适用于有破坏瓷和釉的介质中使用的绝缘子。

Insulators for low voltage power lines.Part 1: Insulators for low voltage overhead power lines

JB/T 10585.2-2006 低压电力线路绝缘子.第2部分:架空电力线路用拉紧绝缘子

JB/T 10585的本部分规定了架空电力线路用拉紧绝缘子的产品型式和尺寸、技术要求、试验方法、检验规则以及包装与标志。 本部分适用于工频交流或直流架空电力线路中电杆拉线或张紧导线和作绝缘用的拉紧瓷绝缘子（以下简称绝缘子）。 本部分不适用于有破坏瓷和釉的介质中使用的绝缘子。

Insulators for low voltage power lines.Part 2: Strain insulators for overhead power lines

JB/T 10585.3-2006 低压电力线路绝缘子.第3部分:低压布线用绝缘子

JB/T 10585的本部分规定了低压布线用绝缘子的产品型式和尺寸、技术要求、试验方法、检验规则以及包装与标志。 本部分适用于工频交流或直流额定电压低于1000V的户内配电线路中作绝缘和固定导线用的瓷绝缘子（以下简称绝缘子）。 本部分不适用于有破坏瓷和釉的介质中使用的绝缘子。

Insulators for low voltage power lines.Part 3: Insulators for low voltage wiring

JB/T 10585.4-2006 低压电力线路绝缘子.第4部分:电车线路用绝缘子

JB/T 10585的本部分规定了电车线路用绝缘子的产品型式和尺寸、技术要求、试验方法、检验规则以及包装与标志。 本部分适时电车线路和起重设备滑触线上作绝缘及固定导电部分用的瓷绝缘子（以下简称绝缘子）。 本部分不适用于有破坏瓷和釉的介质中使用的绝缘子。

Insulators for low voltage power lines.Part 4: Insulators for trolley overhead lines

JB/T 10584-2006 架空通信线路针式瓷绝缘子

本标准规定了架空通信线路针式瓷绝缘子（以下简称绝缘子）的类型、形状和尺寸、技术要求、试验以及包装与标志。 本标准适用于架空通信线路中作绝缘和支持导线用的针式瓷绝缘子。 本标准不适用于对瓷件、金属附件有严重腐蚀或降低绝缘子性能的环境中使用的绝缘子。

Pin-type insulators of ceramic material for overhead telegraph lines

SANS 60832:2006 带电操作时的绝缘杆(绝缘棒)及通用工具附件(配件)

Covers insulating poles (insulating sticks) and tool attachments (fittings) for live working.

Insulating poles (insulating sticks) and universal tool attachments (fittings) for live working

KS C 3815-2006 特殊杯型绝缘子

SPECIAL CUP TYPE INSULATER

NF C66-217:2006 大于1000V标称电压的室内外用聚合物绝缘子.一般定义、试验方法和验收标准

Polymeric insulators for indoor and outdoor use with a nominal voltage greater than 1 000 V - General definitions, test methods and acceptance criteria

BS EN 62217:2006 标称电压大于1000V的室内外用聚合绝缘子.一般定义、试验方法和验收准则

This International Standard is applicable to polymeric insulators whose insulating body consists of one or various organic materials. Polymeric insulators covered by this standard include both solid core and hollow insulators. They are intended for use on overhead lines and in indoor and outdoor equipment with a rated voltage greater than 1 000 V. The object of this standard is – to define the common terms used for polymeric insulators, – to prescribe common test methods for design tests on polymeric insulators, – to prescribe acceptance or failure criteria, if applicable, – to give recommendations for polymeric insulator test standards or product standards, complemented by specific requirements as needed. These tests, criteria and recommendations are intended to ensure a satisfactory life-time under normal operating and environmental conditions (see Clause 5).

Polymeric insulators for indoor and outdoor use with a nominal voltage greater than 1000 V. General definitions, test methods and acceptance criteria

CSA C22.2 No.198.1-06-2006 压制成型绝缘管.第3版.UL 224

This Standard specifies the requirements for insulating tubing that is usually round in cross-section and that consists entirely of extruded compounds whose characteristic constituents are thermosetting, elastomeric, or thermoplastic polymers (see Table

Tubes isolants extrud閟 Troisieme Edition

SANS 62073:2006 绝缘子表面可湿润性的测量规则

Describes three methods that can be used for the measurement of the wettability of the shed and housing material of composite insulators for overhead lines, substations and equipment or ceramic insulators covered or not covered by a coating. The obtained

Guidance on the measurement of wettability of insulator surfaces

ASHRAE QC-06-022-2006 阿拉伯海湾男子的衣物的热绝缘性:用热暖体假人测量

Thermal Insulation of Arabian Gulf Men's Clothing: Measurements Using a Thermal Manikin

Thermal Insulation of Arabian Gulf Men's Clothing: Measurements Using a Thermal Manikin