K48 绝缘子 标准查询与下载

CSA C71-2-98-CAN/CSA-1998 绝缘配合.第2部分:使用导则IEC 71-2:1996.通用指令第1号

Ce document constitue la première édition de la norme CAN/CSA-C71-2, Coordination de l’isolement - Partie 2 .- Guide d‘application. II s‘agit de l’adoption, avec exigences propres au Canada, de la norme internationale de la Commission ?lectrotechnique I

Insulation Co-ordination - Part 2: Application Guide IEC 71-2: 1996; General Instruction No. 1

DIN EN 60437:1998 高电压绝缘子的无线电干扰试验

Radio interference test on high-voltage insulators (IEC 60437:1997); German version EN 60437:1997

JB/T 8737-1998 高压线路用复合绝缘子使用导则

本标准适用于额定电压1～500kV，频率不超过100Hz的输电线路和变电站使用的高压线路用复合绝缘子，安装地点的海拔不超过1000m，环境温度在-40～+40℃之间，安装地点的海拔超过1000m时应按GB 311.1-1997进行修正。 本标准规定了对绝缘子的选择、验收、安装、运行与维护等内容。 高压线路用横担式复合绝缘子及相间复合间隔棒的选用导则见附录A(标准的附录)。

Use guide for compound insulators in high-tension lines

IEEE Std C135.20-1998 架空线建造用镀锌亚铁U型钩绝缘子

This standard covers zinc-coated ferrous clevises for spool-type insulators commonly used for supporting or dead-ending conductors in line construction. The standards for spool-type insulators used with these clevises are covered in ANSI C29.3-1986.

Zinc-coated ferrous insulator clevises for overhead line construction

SANS 61466-1:1997 标称电压超过1000V的架空线用复合绝缘子串组合件．第1部分：标准强度等级和接头配件

Applies to composite string insulator units for a.c. overhead lines with a nominal voltage greater than 1 000 V and a frequency not greater than 100 Hz. Also applies to insulators of similar design used in substations or on electric traction lines.

Composite string insulator units for overhead lines with a nominal voltage greater than 1 000 V Part 1: Standard strength classes and end fittings

BS EN 60437:1998 高压绝缘子无线电干扰试验

In-laboratory radio interference test on clean, dry insulators at frequency of 0.5 MHz or 1 MHz or alternatively at frequencies between 0.5 MHz and 2 MHz.

Radio interference test on high-voltage insulators

CSA C411.4-98-CAN/CSA-1998 传输应用的合成悬挂式绝缘子.第1版.通用指令第1号

Composite Suspension Insulators for Transmission Applications First Edition; General Instruction No 1

Isolateurs De Suspension Composites Destines Aux Lignes De Transport Premiere Edition; Fiche No 1

NF C66-556:1997 充液变压器除外的设备用电压大于 1 kV 并可达 36 kV 和电流 250 A 至 1.25 kA 的套管

Plug-in type bushings above 1 kV up to 36 kV and from 250 A to 1,25 kA for equipment other than liquid filled transformers.

NF C66-554:1997 充液变压器用电压大于 1 kV 并可达 36 kV 和电流 250 A 至 3.15 kA 的套管

Bushings above 1 kV up to 36 kV and from 250 A to 3,15 kA for liquid filled transformers.

DIN EN 61466-1:1997 额定电压超过1KV的架空线用复合绝缘子串组合件.第1部分:标准强度等级和端接头

Composite string insulator units for overhead lines with a nominal voltage greater than 1 kV - Part 1: Standard strength classes and end fittings (IEC 61466-1:1997); German version EN 61466-1:1997

CSA CEI 300-3-9-97-CAN/CSA-1997 运行安全管理 第3部分：应用指南 第 9 节：技术系统风险分析 第一版

Aluminium-magnesium-silicon alloy wire for overhead line conductors First Edition; Update No 1

Operational Safety Management - Part 3: Application Guide - Section 9: Risk Analysis of Technological Systems First Edition

BS EN 61466-1:1997 标称电压超过1000 V的架空线用复合绝缘子串组合件.标准强度等级和接头配件

This part of IEC 61466 is applicable to composite string insulator units for a.c. overhead lines with a nominal voltage greater than 1 000 V and a frequency not greater than 100 Hz. It also applies to insulators of similar design used in substations or on electric traction lines. This standard applies to string insulator units of composite type with ball, socket, tongue, clevis, Y-clevis or eye couplings, or a combination thereof. The object of this standard is to prescribe specified values for the mechanical characteristics of the composite string insulator units and define the main dimensions of the couplings to be used on the composite string insulator units in order to permit the assembly of insulators or fittings supplied by different manufacturers and to allow, whenever practical, interchangeability with existing installations. It also defines a standard designation system for composite string insulator units. NOTE 1 General definitions and methods of testing are given in IEC 1109. NOTE 2 Only the dimensions necessary for assembly of the couplings are dealt with in this International Standard. Properties of material and working loads are not specified. The co-ordination of dimensions of the end-fittings with the strength classes is specified in Clause 7.

Composite string insulator units for overhead lines with a nominal voltage greater than 1 000 V. Standard strength classes and end fittings

NF C66-041:1997 公称电压大于1kV的架空线路用复合弦线式绝缘子设备.第1部分:标准强度分级和终端配件

Composite string insulator units for overhead lines with a nominal voltage greater than 1 kV - Part 1 : standard strength classes and end fittings.

IEC 60684-2:1997 绝缘软管 第2部分:试验方法

This part of IEC 60684 gives methods of test for flexible insulating sleeving, including heat-shrinkable sleeving, intended primarily for insulating electrical conductors and connections of electrical apparatus, although they may be used for other purposes. The tests specified are designed to control the quality of the sleeving but it is recognized that they do not completely establish the suitability of sleeving for impregnation or encapsulation processes or for other specialized applications. Where necessary, the test methods in this part will need to be supplemented by appropriate impregnation or compatibility tests to suit the individual circumstances.

Flexible insulating sleeving - Part 2: Methods of test

IEC 60168:1994/AMD1:1997 标称电压1000V以上系统用户内、户外陶瓷或玻璃支柱绝缘子的试验 修改1

This is Amendment 1 to IEC 60168-1994 (Tests on indoor and outdoor post insulators of ceramic material or glass for systems with nominal voltages greater than 1000 V)

Tests on indoor and outdoor post insulators of ceramic material or glass for systems with nominal voltages greater than 1000 V; Amendment 1

DIN EN 60383-1:1997 公称电压高于1000V的架空线路绝缘子.第1部分:交流系统用陶瓷或玻璃绝缘子的定义、试验方法和验收准则

Insulators for overhead lines with a nominal voltage above 1 kV - Part 1: Ceramic or glass insulator units for a.c. systems; definitions, test methods and acceptance criteria (IEC 60383-1:1993); German version EN 60383-1:1996

IEC TR2 61467/Cor:1997 标称电压1000V以上的架空线路用绝缘子.绝缘子组交流电弧试验.技术勘误

This standard is Insulators for overhead lines with a nominal voltage above 1000 V - A.C. power arc tests on insulator sets; Corrigendum.

Insulators for overhead lines with a nominal voltage above 1000 V - A.C. power arc tests on insulator sets; Corrigendum

IEC 61466-1:1997 标称电压1000V以上的架空线路用复合绝缘子串单元 第1部分:标准强度等级和端配件

Is applicable to composite string insulator units for a.c. overhead lines with a rated voltage greater than 1 000 V and a frequency not greater than 100 Hz. It also applies to insulators of similar design used in substations or on electric traction lines

Composite string insulator units for overhead lines with a nominal voltage greater than 1000 V - Part 1: Standard strength classes and end fittings

IEC TR2 61467:1997 标称电压1000V以上的架空线路用绝缘子 绝缘子组交流电弧试验

This technical report of type 2 applies to insulator sets comprising string insulator units of ceramic material, glass or composite material for use on a.c. overhead lines and traction lines with a rated voltage above 1 000 V and a frequency between 15 H

Insulators for overhead lines with a nominal voltage above 1000 V - A.C. power arc tests on insulator sets

JB/T 8509-1996 高压线路柱式瓷绝缘子

本标准规定了高压线路柱式瓷绝缘子的型式尺寸，主要机电特性和技术要求，以及规定测试这些技术要求中特性参数的条件、检验规则、试验方法、包装与标志。 本标准适用于标称电压高于1000V，频率不大予100Hz，海拔不超过1000m，普通地区和中、重污秽地区的交流架空电力线路中绝缘和支持导线用的绝缘子，其安装地点的环境温度在-40～+40℃之间。 本标准不适用于严重腐蚀绝缘件和金属附件的条件下使用的绝缘子。 注：海拔超过1000m时，按相应标准规定的修正方法判定其适用性。

Ceramic post insulators for high tension lines