K70 电气照明综合 标准查询与下载

KS C IEC 61347-2-8:2008 灯控制装置.第2-8部分:荧光灯镇流器的特殊要求

이 표준은 교류 1 000 V 이하, 입력 주파수 50 또는 60 Hz에서 사용되고, KS

Lamp controlgear－Part 2-8：Particular requirements for ballasts for fluorescent lamps

KS C IEC 61048:2008 管状荧光灯和其他放电灯具电路中用的电容器.通用和安全要求

이 표준은 표고 3 000 m 이하, 50 Hz나 60 Hz에서 동작하는 방전램프 회로에

Auxiliaries for lamps－Capacitors for use in tubular fluorescent and other discharge lamp circuits－General and safety requirements

KS C IEC 60929:2008 管形荧光灯用交流电子镇流器.性能要求

이 표준은 교류 1 000 V 이하에서 사용되고 50 Hz 또는 60 Hz의 교류 입력 주

A.C supplied electronic ballasts for tubular fluorescent lamps－Performance requirements

KS C IEC 60921:2008 管形荧光灯镇流器.性能要求

이 표준은 KS C IEC 60081과 KS C IEC 60901에서 규정한 치수와 특성을

Ballasts for tubular fluorescent lamps－Performance requirements

BS 8206-2:2008 建筑用照明设备.日光照明用实施规则

This part of BS 8206 gives recommendations regarding design for daylight in buildings. It includes recommendations on the design of electric lighting when used in conjunction with daylight. NOTE Data for daylight and sunlight calculations are given in Annex A.

Lighting for buildings - Code of practice for daylighting

KS C 8300-2008 灯具插头

이 표준은 주파수 60 Hz의 교류 250 V 이하의 전로에 대하여 주로 가정, 사무소 등

Appliance couplers for domestic and similar use

KS C IEC 61347-1:2008 灯控制装置.第1部分:总则和安全要求

이 표준은 50 Hz 또는 60 Hz, DC 250 V 이하 또는 AC 1 000 V 이하

Lamp controlgear-Part 1:General and safety requirements

KS C IEC 62471:2008 灯具和灯具系统的光生物学安全性

이 표준은 조명기구, 램프와 램프장치의 광생물학적 안전성의 평가 지침을 규정한다. 구체적으

Photobiological safety of lamps and lamp systems

SAE J2320-2008 放电信号照明系统

This SAE Recommended Practice applies to motor vehicle signaling and marking devices which use light generated by a discharge source. This document provides test methods, requirements, and guidelines applicable to the unique characteristics of discharge lighting systems and their components. These are in addition to those required for signal and marking devices. This document is intended to be a guide to standard practice and is subject to change to reflect additional experience and technical advances.

Discharge Signal Lighting System

CSA C22.2 No.250.0-08-2008 照明设备.第3版

1.1 This Standard applies to luminaires for use in non-hazardous locations and that are intended for installation on branch circuits of 600 V nominal or less between conductors in accordance with the Canadian Electrical Code, Part I (CEC), CSA C22.1, with the U.S. National Electrical Code (NEC), ANSI/NFPA 70, and with the Mexican National Electrical Code, NOM-001-SEDE. 1.2 This Standard does not apply to luminaires covered by other standards. The luminaires not covered by this Standard include: Amateur Movie Lights; Aquarium Lights; Cabinet Lights; Decorative Lighting Strings; Combination Fan/IR Lamps Used for Heating; Electric Signs; Exit Signs in the United States; Junction Boxes for Swimming Pool Fixtures; Lamp Adapters; Low-Level Path Marking and Lighting Systems in the United States; Low-Voltage Landscape Lighting as follows: For products intended for installation in Canada, landscape lighting systems that are 30 V nominal or less; For products intended for installation in Mexico, low-voltage landscape lighting devices that are 24 V nominal or less; and For products intended for installation in the United States, low-voltage landscape lighting devices that are of 15 V nominal or less; Low-Voltage Lighting Fixtures for Use in Recreational Vehicles; Low-Voltage Marine Lighting; Luminaires for Hazardous Locations; Luminaires for Recreational Vehicles; Marine Navigational Lights; Marine-Type Fixtures; Portable Electric Displays; Portable Hand Lamps; Portable Luminaires; Portable Sun/Heat Lamps; Self-Ballasted Lamps and Lamp Adapters; Stage and Studio Luminaires; Submersible Luminaires; Swimming Pools Luminaires; Temporary Lighting Strings; Therapeutic Lamps; Track Lighting Systems; Under-cabinet Lights in Canada and Cord-connected Under-cabinet Lights in the United States; and Unit Equipment for Emergency Lighting.

Luminaires Third Edition

NF C71-247-0:2008 灯控装置.第1部分:一般要求和安全要求

Lamp controlgear - Part 1 : general and safety requirements.

WH/T 31-2008 舞台灯光设计常用术语

Terminology of Lighting

WH/T 32-2008 DMX512-A灯光控制数据传输协议

DMX512-A Digital Data Transmission Standard for Lighting Control

AS/NZS 4934.2:2008 一般照明服务用白炽灯.第2部分:最低能效标准(MEPS)要求

This Interim Standard specifies requirements for Minimum Energy Performance Standards (MEPS) and other requirements for incandescent lamps (the attributes of which are described in Clauses 1.1.2 to 1.1.10), both tungsten filament and tungsten halogen.

Incandescent lamps for general lighting services Part 2: Minimum Energy Performance Standards (MEPS) requirements

EN 61995-1:2008 家用及类似用途的照明设备连接装置.第1部分:一般要求

This standard applies to devices for the connection of luminaires (DCL) intended for household and similar purposes, for the electrical connection of fixed luminaires of class I or class II to final circuits rated at not more than 16 A without providing a mechanical support for the luminaire. DCLs are intended for use according to their IP rating per EN 60529. Outlets have an earthing contact and a rated current of 6 A, plugs are rated at 6 A. The rated voltage is 250 V at 50 Hz. NOTE 1 This standard does not cover integrated DCL-plugs (under consideration). This standard can also be applied to types other than those with standardised interface. NOTE 2 Void. DCL plugs and DCL outlets complying with this standard are suitable for use under the following conditions: – an ambient temperature not normally exceeding 25 °C, but occasionally reaching 35 °C; NOTE 3 The effect of the heat generated by the luminaire may affect the ambient temperature local to the DCL. – a temperature not exceeding 70 °C at the terminals of the DCL outlet including the effect of heat generated by the luminaire and the passage of current. NOTE 4 The requirements and tests of this standard may also be used as a guide when testing DCL's which have different interface configurations or ratings.

Devices for the connection of luminaires for household and similar purposes — Part 1: General requirements

DIN EN 12193:2008 光及照明.运动照明

This standard specifies lighting for those indoor and outdoor sports events most practised in Europe. It provides lighting values for the design and control of sports lighting installations in terms of illuminances, uniformity, glare restriction and colour properties of the light sources. All requirements are meant to be as minimum requirements. It also gives methods by which these values are measured. For the limitation of glare, it also points out restrictions on the location of the luminaires for specific applications. For emergency lighting this standard refers to the requirements of EN 1838.

Light and lighting - Sports lighting; English version of DIN EN 12193:2008-04

NF X90-005:2008 光及照明.运动照明

Light and lighting - Sports lighting.

BS ISO 10526:2007 比色法用CIE标准光源

This International Standard specifies two illuminants for use in colorimetry. The illuminants, which are defined in clauses 4 and 5 of this International Standard, are as follows: a) CIE standard illuminant A This is intended to represent typical, domestic, tungsten-filament lighting. Its relative spectral power distribution is that of a Planckian radiator at a temperature of approximately 2 856 K. CIE standard illuminant A should be used in all applications of colorimetry involving the use of incandescent lighting, unless there are specific reasons for using a different illuminant. b) CIE standard illuminant D65 This is intended to represent average daylight and has a correlated colour temperature of approximately 6 500 K. CIE standard illuminant D65 should be used in all colorimetric calculations requiring representative daylight, unless there are specific reasons for using a different illuminant. Variations in the relative spectral power distribution of daylight are known to occur, particularly in the ultraviolet spectral region, as a function of season, time of day, and geographic location. However, CIE standard illuminant D65 should be used pending the availability of additional information on these variations. Values for the relative spectral power distribution of CIE standard illuminants A and D65 are given in Table 1 of this International Standard. Values are given at 1 nm intervals from 300 nm to 830 nm. The term "illuminant" refers to a defined spectral power distribution, not necessarily realizable or provided by an artificial source. Illuminants are used in colorimetry to compute the tristimulus values of reflected or transmitted object colours under specified conditions of illumination. The CIE has also defined illuminant C and other illuminants D. These illuminants are described in Publication CIE 15:2004 but they do not have the status of primary CIE standards accorded to the CIE standard illuminants A and D65 described in this International Standard. It is recommended that one of the two CIE standard illuminants defined in this International Standard be used wherever possible. This will greatly facilitate the comparison of published results. It is noted that in the fields of graphic arts and photography extensive use is also made of CIE illuminant D50. In most practical applications of colorimetry, it is sufficient to use the values of CIE standard illuminants A and D65 at less frequent wavelength intervals or in a narrower spectral region than defined in this Standard. Data and guidelines that facilitate such practice are provided in Publication CIE 15:2004, together with other recommended procedures for practical colorimetry. The term "source" refers to a physical emitter of light, such as a lamp or the sky. In certain cases, the CIE recommends laboratory sources that approximate the spectral power distributions of CIE illuminants. In all cases, however, the definition of a CIE recommended source is secondary to the definition of the corresponding CIE illuminant, because of the possibility that, from time to time, new developments will lead to improved sources that represent a particular illuminant more accurately or are more suitable for laboratory use. Subclause 6.1 of this International Standard describes CIE source A, which is recommended for laboratory realizations of CIE standard illuminant A. At present, there is no CIE recommended source representing CIE standard illuminant D65

CIE standard illuminants for colorimetry

UL 2108 BULLETIN-2008 低压照明系统UL安全性标准

Requirements in UL 2108 apply to low voltage lighting systems and components intended for permanent installation and for use in locations in accordance with the NEC, ANSI/NFPA, Article 411. The requirements cover low voltage power units, non-enclosed open bus-bar lighting systems, and Class 2 low voltage lighting

UL Standard for Safety Low Voltage Lighting Systems

UL 1838 BULLETIN-2008 低压景观照明系统UL安全性标准

Applies to low-voltage landscape lighting systems and components that may consist of an isolating type power unit, wiring, and luminaire. Only covers equipment where the maximum output of each secondary circuit is 25 A, 15 V ac (21.2 V peak) open circuit voltage, 300 VA. The luminaires intended for garden, walkway, patio areas, or similar outdoor locations and for certain indoor locations such as atriums and shopping malls. The power units may be installed indoors or outdoors. The equipment is intended to be installed in accordance with the National Electrical Code, ANSI/NFPA 70.

UL Standard for Safety Low Voltage Landscape Lighting Systems