K74 灯具附件 标准查询与下载

BS EN 61047:2004 钨丝灯用交直流供电电子降压转换器.性能要求

This International Standard specifies performance requirements for electronic step-down convertors for use on d.c. supplies up to 250 V and a.c. supplies up to 1 000 V at 50 Hz or 60 Hz with operating frequencies deviating from the supply frequency, associated with tungsten halogen lamps as specified in IEC 60357 and other filament lamps. NOTE 1 The tests in this standard are type tests. Requirements for testing individual convertors during production are not included. NOTE 2 Requirements for convertors which incorporate means for varying the lamp power are under consideration. NOTE 3 It may be expected that convertors complying with this standard will ensure satisfactory operation between 92 % and 106 % of rated supply voltage of filament lamps with rated lives greater than 200 h and rated voltage less than 50 V. NOTE 4 There exist regional standards regarding the regulation of mains current harmonics for end-products such as luminaires and independent control gear. In a luminaire, the control gear is dominant in this respect. Control gear, together with other components, should comply with these standards.

D.C. or A.C. supplied electronic step-down convertors for filament lamps - Performance requirements

IEC 60400:2004 管形荧光灯灯座和起动器座

States the technical and dimensional requirements for lampholders for tubular fluorescent lamps and for starter-holders, and the methods of test to be used in determining the safety and the fit of the lamps in the lampholders and the starters in the star

Lampholders for tubular flurorescent lamps and starterholders

IEC 60061-4:1990/AMD9:2004 灯头、灯座及检验其互换性和安全性的量规.第4部分:指南和一般资料.修改件9

Lamp caps and holders together with gauges for the control of interchangeability and safety - Part 4: Guidelines and general information; Amendment 9

JIS C 9730-2-3:2004 家用和类似用途的自动电气控制装置.第2-3部分:管式荧光灯用镇流器热保护器的特殊要求

この規格は，管形蛍光ランプ用安定器のための感熱式保護装置の評価に適用する。

Automatic electrical controls for household and similar use -- Part 2-3: Particular requirements for thermal protectors for ballasts for tubular fluorescent lamps

DB31/T 318-2004 单端荧光灯用内含电子镇流器的节能灯座

Energy-saving lampholders incorporating electronic ballasts for single-capped fluorescent lamps

IEC 60399:2004 带灯罩卡环的灯座的圆筒螺纹

Gives limit dimensions of thread for metal or plastic and ceramic lampholders with shade holder rings made of metal or plastic.

Barrel thread for lampholders with shade holder ring

IEC 60238:2004 螺口灯座

本标准适用于只供灯及半灯具与电源连接时使用的E14、E27和E40型爱迪生螺口匆灯座。 本标准亦适用于只在工作电压不超过250 V(有效值)的交流电路中使用的开关式灯座。 本标准亦适用于工作电压不超过25 V，串联连接室内使用的E5型螺口灯座，工作电压不超过 60 V，串联连接室内、室外使用的Elo型螺口灯座，以及嵌装式单独与电源连接的E10灯座。这些灯座 均不应零售。 就合理采用本标准而言，本标准还适用于与电源串联连接的非爱迪生螺口灯座。 注1：例如，这种类型灯座用在圣诞树照明线路中。 就合理采用本标准而言，本标准还适用于转接器。 本标准还适用于那些与灯具完全或部分结为——体的灯座，以及那些规定安装在设备之内的灯座。 本标准只涉及灯座要求。对于其他要求，如接线端子或灯头的防触电保护要求，则应符合相关设备的标 准，当设备按照自身标准进行试验时，应把这类幻·座安装在适宜的设备中再进行试验。这类灯座以及装 有搭锁外壳的灯座(在仅供灯具制造商使用时)不应零售。 本标准适用于安装在室内、室外、住宅照明装置及工业照明设备上的灯座，也适用于烛形灯座。在 某些使用条件特殊的场合，如在街道照明、轮船甲板、机动车辆中以及那些容易发生爆炸的危险场合，则 可采用特殊结构的灯座。 注2：本标准不适用于三个光源灯座E26d。 注3：本标准的制定基寸：下述相应普通照明用灯的参数： ——E14型灯头用电流不超过2八的灯； —一—E27型灯头用电流不超过4 A的灯； ’ E40型灯头用电流不超过16 A的灯。 注4：如果电源的标称电压不超过130 V，则E40型灯头的最大电流为32 A(参见4．5和5．3)。 注5：对于在灯具中使用的灯座，其最大工作温度在GB 7000．1中给出。

Edison screw lampholders

IEC 60838-2-1:1994/AMD2:2004 杂类灯座.第2-1部分:特殊要求.S14型灯座.修改件2

This is Amendment 2 to IEC 60838-2-1-1994 (Miscellaneous lampholders - Part 2-1: Particular requirements - Lampholders S14)

Miscellaneous lampholders - Part 2-1: Particular requirements - Lampholders S14; Amendment 2

IEC 60838-1:2004 杂类灯座.第1部分:一般要求和试验

This part of IEC 60838 applies to lampholders of miscellaneous types intended for building-in (to be used with general purpose light sources, projection lamps, floodlighting lamps and street-lighting lamps with caps as listed in annex A) and the methods

Miscellaneous lampholders - Part 1: General requirements and tests

JIS C 7603:2004 荧光灯辉光启动器

この規格は，予熱形蛍光ランプ用として互換性をもつグロースタータ(以下,スタータという。)について規定する。

Glow-starters for fluorescent lamps

JIS C 7620-2:2004 自镇流荧光灯.第2部分:性能规范

この規格は，家庭用又はそれに類する一般照明用に使われる，始動と点灯のための同路とを一体化された蛍光ランプ(以下,ランプと呼ぶ。)に要求される性能及び試験方法について規定する。

Self-ballasted fluorescent lamps -- Part 2: Performance specifications

JIS C 8324:2004 管式荧光灯灯座及启动器座

この規格は，蛍光灯ソケット及びスタータソケットに対する技術ト及び寸法トの要求事項，並びに安全性及びかん合性(蛍光灯ソケットと蛍光ランプとのかん合及びスタータソケットとスタ一タとのかん合)について規定する。

Lampholders for tubular fluorescent lamps and starterholders

IEC 60927:2004 灯附件.起动装置(辉光起动器除外).性能要求

Specifies performance requirements for starting devices (starters and ignitors) for tubular fluorescent and other discharge lamps for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz which produce starting pulses not greater than 5 kV. Should be read

Auxiliaries for lamps - Starting devices (other than glow starters) - Performance requirements

IEC 60921:2004 管形荧光灯用镇流器.性能要求

This standard specifies performance requirements for ballasts excluding resistance types for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz, associated with tubular fluorescent lamps with pre-heated cathodes operated with or without a starter or st

Ballasts for tubular fluorescent lamps - Performance requirements

CSA C863-04 CSA-2004 高强度放电(HID)及低压钠(LPS)灯镇流器的能效

Energy efficiency of high-intensity discharge (HID) and low-pressure sodium (LPS) lamp ballasts

Energy efficiency of high-intensity discharge (HID) and low-pressure sodium (LPS) lamp ballasts

IEC 60927/AMD2:2004 灯附件.起动装置(辉光起动器除外).性能要求.修改件2

Auxiliaries for lamps - Starting devices (other than glow starters) - Performance requirements; Amendment 2

IEC 61347-2-3/AMD1:2004 灯的控制装置.第2-3部分:荧光灯用交流电子镇流器的特殊要求.修改件1

This standard is about Lamp controlgear - Part 2-3: Particular requirements for a.c. supplied electronic ballasts for fluorescent lamps; Amendment 1

Lamp controlgear - Part 2-3: Particular requirements for a.c. supplied electronic ballasts for fluorescent lamps; Amendment 1

IEC 61047:2004 钨丝灯用交直流供电电子降压转换器.性能要求

This International Standard specifies performance requirements for electronic step-down convertors for use on d.c. supplies up to 250 V and a.c. supplies up to 1 000 V at 50 Hz or 60 Hz with operating frequencies deviating from the supply frequency, asso

DC or AC supplied electronic step-down convertors for filament lamps - Performance requirements

BS EN 60929:2004 管形荧光灯用交流电子镇流器规范.性能要求

This International Standard specifies performance requirements for electronic ballasts for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz with operating frequencies deviating from the supply frequency, associated with tubular fluorescent lamps as specified in IEC 60081 and IEC 60901 and other tubular fluorescent lamps for high frequency operation. NOTE Tests in this standard are type tests. Requirements for testing individual ballasts during production are not included.

A.C. supplied electronic ballasts for tubular fluorescent lamps - Performance requirements

NF C71-247-9/A1:2004 灯的控制装置.第2-9部分:放电灯(荧光灯除外)用镇流器的特殊要求

Lamp controlgear - Part 2-9 : particular requirements for ballasts for discharge lamps (excluding fluorescent lamps).