共找到 858 条与 蓄电能装置 相关的标准,共 58 页
이 규격은 부분적이거나 매우 특정한 조건에서 완전한 가스 재결합 기능을 갖도록 특별 장치가
Secondary cells and batteries containing alkaline or other non-acid electrolytes-Nickel-cadmium prismatic secondary single cells with partial gas recombination
이 규격은 비산성 및 알칼리 전해액을 포함하는 2차 전지-휴대형 밀폐 2차 단전지 및 이들
Secondary cells and batteries containing alkaline or other non-acid electrolytes-Safety requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications
이 규격은 휴대용 기기에 사용되는 전지가 양호한 예에 의거하여 설계, 제조 및 판매되는 것
Secondary cells and batteries containing alkaline or other non-acid electrolytes-Design and manufacturing recommendations for portable batteries made from sealed secondary cells
Details the definitions, abbreviations, symbols and formulae used throughout the other parts of SANS 1632.
Batteries Part 1: General information - Definitions, abbreviations and symbols
Specifies requirements and tests for the safe operations of portable sealed secondary cells and batteries (other than button) containing alkaline or other non-acid electrolyte.
Secondary cells and batteries containing alkaline or other non-acid electrolytes - Safety requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications
Nickel metal hydride (Ni-MH) cells can exhibit high self-discharge rates. Nitrate impurities in the positive electrode can be reduced to ammonia on the negative electrode. This causes rapid self-discharge. Technical publications have reported a link between the separator ammonia trapping capabilities and the cells charge retention. Grafted polyolefin separators can absorb or trap these impurities—hence, reducing self-discharge rates. The level of ammonia trapping from this method gives an indication of the efficiency of a separator to trap these contaminates, thus helping a battery self discharge ( charge retention). A higher value should provide a cell with greater charge retention.1.1 This test method covers the measurement of the ability of a material to capture ammonia.1.2 This test method is intended primarily for testing grafted polyolefin materials used as a battery separator, although other materials could be tested.1.3 The values stated in SI units are to be regarded as the standard.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determination of Ammonia Trapping in a Grafted Battery Separator
이 규격은 알카라인 또는 기타 비산성 전해질을 포함하는 이차 단전지(Cell) 및 전지
Secondary cells and batteries containing alkaline or other non-acid electrolytes-Guide to the designation of current in alkaline secondary cell and battery standards
Specifies requirements for primary cells and batteries based on any electrochemical system.
Primary cells and batteries
This part of IEC 60896 applies to all stationary lead-acid cells and monoblocs of the valve regulated type for float charge applications, (i.e. permanently connected to be moved from place to place) and incorporated into stationary equipment or installed in battery rooms for use in telecom, uninterruptible power supply (UPS), utility switching, emergency power or similar applications.
Stationary lead-acid batteries - Part 22: Valve regulated types - Requirements (IEC 60896-22:2004); German version EN 60896-22:2004
This part of IEC 60896 apllies to all stationary lead-acid cells and monobloc batteries of the valve regulated type for float charge applications, (i.e. permanently connected to a load and to a d.c. power supply), in a static location (i.e. not generally intended to be moved from place to place) and incorporated into stationary equipment or installed in battery rooms for use in telecom, uninterruptible power suply (UPS), utility, switching, emergency power or similar appplications.
Stationary lead-acid batteries - Part 21: Valve regulated types - Methods of test (IEC 60896-21:2004); German version EN 60896-21:2004
이 규격은 농용 트랙터, 콤바인 등 주행형 농업 기계의 내연 기관의 시동, 점등, 점화 등
Lead-acid starter batteries for agricultural machinery
This standard is Household and similar electrical appliances - Safety - Part 2-29: Particular requirements for battery chargers; Amendment 1;Corrigendum 1.
Household and similar electrical appliances - Safety - Part 2-29: Particular requirements for battery chargers; Corrigendum 1
Specifies the requirements for stationary lead-acid cells and monobloc batteries of the valve regulated type for float charge applications, (i.e. permanently connected to a load and to a d.c. power supply), in a static location and incorporated into stat
Stationary lead-acid batteries Part 22: Valve regulated types - Requirements
Specifies the methods of test for all stationary lead-acid cells and monobloc batteries of the valve regulated type for float charge applications (i.e. permanently connected to a load and to a d.c. power supply), in a static location and incorporated int
Stationary lead-acid batteries Part 21: Valve regulated types - Methods of test
この規格は,電気通信,電気機器,非常用電源などに使用する補水を必要としないシール形ニッケル·カドミウムアルカリ蓄電池(以下,蓄電池という。)の表示,性能及び試験方法について規定する。
Sealed nickel-cadmium rechargeable single cells
Electrotechnical Vocabulary - Part 482 : primary and secondary cells and batteries.
本部分规定了锂离子蓄电池安全检测要求和其他相关要求。 本部分规定了锂离子蓄电池的安全性的最低要求和相应的测试方法。 本部分涉及化学领域内的锂离子蓄电池,放电过程中每一个电化学对具有特定的放电电压范围以及典型的标称电压和放电终止电压。 为避免混淆,锂蓄电池组的检测不在本部分的范围内。 本部分适用于锂离子蓄电池安全检测要求的检测。
Safety inspection of import and export secodary cells and batteries--Part 3: Secondary lithium cells
Secondary cells and batteries containing alkaline or other non-acid electrolytes - Mechanical tests for sealed portable secondary cells and batteries.
Stationary lead-acid batteries - Part 21 : valve regulated types - Methods of test.
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号